Please show the complete solution. (Example: Conversion of Units) An empty, open can is 30 cm high with a 15 cm diameter. The can, with the open end down, is pushed under water with a density of 1000 kg/m3 level Find the water in the can when the top of the can is 50 cm below the surface.

Please show the complete solution. (Example: Conversion of Units) An empty, open can is 30 cm high with a 15 cm diameter. The can, with the open end down, is pushed under water with a density of 1000 kg/m3 level Find the water in the can when the top of the can is 50 cm below the surface.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: Consider an object that sinks to the bottom of a beaker of liquid. The object is a block with a…

Q: Water at 4°C its unit weight in Ib/ft' is equal to

A: As we knowunit weight or density of water at 4oC is maximumie =1000 kg/m3

Q: 1- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its…

Q: The lock gate of a canal (Fig. 2.5) is rectangular, 20 m wide and 10 m high. One side is exposed to…

Q: 2. A vertical cylindrical tank is filled to the top with water at a temperature of 20°C. The…

Q: 1) Calculate the buoyant force on 10 tons of solid steel completely submerged in water and compare…

A: Given:mass of steel, m=10 tons or 10000 kgdensity of steel, ρ=7800 kg/m3displaced water volume,…

Q: Q1:-The gate shown in fig.1 is in cquilbrium.Compute W, negelecting the mass of the gate?

Q: Find the hydrostatic pressure at the bottom of the container 70 cm deep, if it is filled up with a)…

Q: Before immersion, the liquid was 75 mm deep. At what level will the solid cylinder float?

Q: A 25 m high vertical column of a fluid of density 1800 kg/m³ exists in a place where g = 9.6 m/s2…

Q: Q2) what is the length of sides required to maintain a cube shown in figure suspended on water…

A: The weight of the cube can be determined as,

Q: An open tank contains 5.6m of water covered with 3.4m of kerosene (S.G=0.80). Find the pressure at…

Q: A conical vessel is 12 ft across the top and 15 ft tall. If it contains a liquid weighing W lb/ft3…

A: The schematic diagram of the conical vessel with a ring element is as follows:

Q: solution according to the question. Note : Figure not given. The top portion of an equilateral…

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00181 N/cm2…

A: Excess pressure in water droplet, P=4σ/D...

Q: rectangular plane 1.2 m by 1.8 m is submerged in water and makes an angle of 30 with the horizontal.…

A: Given:θ=30°d=1.2 mb=1.8 m

Q: 5. At a particular temperature, the surface tension of water is 0.73 N/m. Under ideal conditions,…

A: Given: Surface tension of the water is 0.73 N/s. The contact angle is 0 deg. Diameter of the tube is…

Q: The zoo is building a new polar bear exhibit, and wants to put a semi-circular window in the…

Q: Fill a glass approximately 80 percent with water, and add alarge ice cube. Mark the water level. The…

A: It is stated that the glass is filled 80% with water, and a large ice cube added in the glass due to…

Q: Question 35 A dam has a semi-circular gate at the bottom that is 4 m in diameter. The dam is 12 m…

A: Given: The diameter of the semicircular gate is 4m. The height of the dam is 12 m. The height from…

Q: What is the height (in ft) of a cylindrical tank (with 300 mm diameter) that was filled with a fluid…

A: Given: The diameter of the cylindrical tank d=300 mm. The mass of the filled fluid is m=10 kg. The…

Q: A circular tank of diameter 5 m, and height 300 cm is completely filled with a liquid, the weight of…

Q: 3.16 A partitioned tank as shown contains water and mercury. What is the gage pressure in the air…

A: Consider the schematic diagram of the partitioned tank initially, From "Properties of a liquids"…

Q: 5. Two vertical cylindrical storage tanks are full of liquid water, density atmoshere. One is 10 m…

Q: 2. At a particular temperature, the surface tension of water is 0.073 N/m. Under ideal conditions,…

A: Answer: The theoretical height of the capillary rise is 0.297655 m.

Q: Take density of fluid = 1000kg/m^3.. Kindly give correct solution and it should be handwritten in…

A: Given Diameter, d = 0.175 m Height, h = 25 mm of Hg = 3333.06 Pa Density = 1000kg/m3…

Q: A glass in a form of a right circular cylinder is filled with water to the brim. It has a base…

A: Given: rA = 10 cm hA = 25 cm rB = 15 cm

Q: glass window has the shape of a trapezoid with height 3m, width at the top of 4m, and width at the…

Q: A tank with vertical sides is 1.30 m square (horizontal section), 3 m high and is filled with water…

Q: 1. A body is float and submerged in sea water (s.g. = 1.03) and has a weight of 641,750 kN. If the…

Q: A block of wood 4 m long, 2 m wide and 1 m deep is floating horizontally in water. If the density of…

Q: rity is 10 m/s²?

A: Given Mass m = 3 kg Acceleration due to gravity, g= 10 m/s^2

Q: Q2:- A steel cylinder of (s.g submergence , h? 0.64) floats on water , find the depth of

A: Given data S.G of cylinder = 0.64 Diameter = 8 cm Density of water = 1000 kg/m3 Density of cylinder…

Q: Please show the complete solution (Formula, Given and Conversion of Units) A 1 m x 1.5 m…

A: Given: The diameter of cylinder, d = 1 m The length of cylinder, L = 1.5 m The specific gravity of…

Q: A hollow iron pipe is 21 cm long and its external diameter is 8 cm. If the thickness of the pipe is…

A: Given External diameter = 8 cm Thickness of the pipe = 1 cm

Q: A tank of height 30 cm is filled with water up to a height of 10 cm. Oil with SG= 0.9 is poured to…

Q: A U-tube manometer filled with water, density 62.4 lbm/ft3, shows a height difference of 10 in. The…

A: Given data: h=10 inρ=62.4 lbm/ft3θ=30° Need to determine the length of the column of water in the…

Q: The homogeneous 12-cm cube in Fig. 2.116 is balanced by a 2-kg mass on the beam scale when the cube…

A: The density of ethanol at 20 degrees Celsius is The volume of the cube is

Q: A wooden column (SG = 0.65) is 5 cm by 5 cm by 2.2 m long. What weight of lead (SG = 11.4) is needed…

Q: a) Consider a large cubic ice block floating in seawater. The specific gravity of ice is 0.91. If 10…

A: We are suppose to solve only one question. Please post other question as a separate question.

Q: 3. A vertical tube 3.0m long its upper end closed and the lower end open, has its lower end…

Q: If the bottom pressure is 1.27 [Kg/cm2.abs], find the height of the liquid with a density of 0.642…

A: Given data, P= 1.27 kg/cm2 = 124544.5 Pa. P is absolute pressure. D= 0.642 g/cm3 =642 kg/m3 Let…

Q: A rectangular plane, 1.2 m by 1.8 m is submerged in water and makes an angle of 30 degrees with the…

Q: A rectangular tank of length 6 m, width 2.5 m and height 300 cm is completely filled with a liquid.…

Q: Find the required diameter of a droplet of water in order to have a pressure of 1 kPa within it,…

Q: A rectangular gate is hinged at the water line, as shown. The gate is 4 ft high and 10 ft wide. The…

Question

Please show the complete solution. (Example: Conversion of Units)

An empty, open can is 30 cm high with a 15 cm diameter. The can, with the open end down, is pushed under water with a density of 1000 kg/m3 level Find the water in the can when the top of the can is 50 cm below the surface.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A house has 3500ft2 of floor space and a 9-ft ceiling. What is the cubic volume of the house?
Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
A cylindrical can 76 mm in diameter and 152 mm high, weighing 1.11 N, contains water to depth of 76 mm. When this can is placed in water, how deep will it sink?
A tank with vertical sides is 1.30 m square (horizontal section), 3 m high and is filled with water to a depth of 2.70 m. By how much, if at all, will be the pressure on one side of the tank be changed if a cube of wood (s=0.50) measuring 60 cm on an edge be placed in water?
A metal block 2 ft square and 10 in. deep is floated on a body of liquid which consists of an 8-in layer of water above a layer of mercury. The block weighs 120 lb/ft3. What is the position of the bottom of the block? If a downward vertical force of 500 lb is applied to the center of this block, what is the new position of the bottom of the block ?
Question-2: in a container with a depth of 2 m, two separate liquids in two separate compartments are separated from each other through two separate doors A and B. The cap is held in balance with a rope and Mass at the end. find the weight of the mass attached to the rope. (Just find B side)
. A 2 m tall barrel is closed on top except for a thin pipe extending 8 m up from the top. When the barrel is filled with water up to the base of the pipe (2 m deep), the water pressure on the bottom of the barrel is 20 KPa. What is the pressure on the bottom when water is added to fill the pipe to its top?
A force sensor is immersed in a iquid with a density of 61 lb/ to a depth of 42 in and then placed in a second liquid with a density of 732 N/. What is the change in force on the sender if the diameter of the sensor is 8 cm and the change in depth is 5.9 cm?
A cube of steel 0.3 m on each side floats in mercury. Using specific gravities of steel and mercury of 7.8 and 13.6, respectively, find the submerged depth in the cube
1. Given an air with a known temperature and pressure of 4 degree Celsius and 105 KPa, respectively, find the density of the air. 2. A rigid container is closed at one end and measures 7 inches diameter by 14 inches long. The container is held vertically and is slowly moved downward until the pressure in the container is 16.5 psia. What will be the depth of the water surface measure from the free water surface?
A 10cm x 10 cm x 10cm block of steel (ρsteel = 7900 kg/m3) is suspended from a spring scale. The scale is in Newtons. a. What is the scale reading if the block is in air? b. What is the scale reading after the block has been lowered into a beaker of water and is completely submerged?
Question: A rectangular plane, 1.2 m by 1.8 m is submerged in water and makes an angle of 30 degrees with the horizontal, the 1.2 m sides being horizontal. 1. If the top of the edge of the plane is at the free surface, what would be the shape of the pressure distribution acting on the plane. 2. What is the minimum AND maximum pressure acting on the plane in kPa? 3. Find the magnitude of the hydrostatic force acting on either side of the plane in KN. Draw a figure with labeled pressure prism diagrams. Thank you!