Please submit an example of architecture with three storeys.

Q: 4. A 45° strainmounted on thebracket. The following readings are obtained for each gauge:€4 =…

A:

Q: TUATION IV (9-10) The beam AB shown in the figure supports a uniform loa ting all over half the…

A: To find value of W for the equilibrium

Q: Q3) Determine the force in each member of the truss. State if the members are in tension or…

A:

Q: 3.131 A concrete foundation mat of 5-m radius supports four equally spaced columns, each of which is…

A:

Q: Question The state of 2D-stress at a point is given by the following matrix of stress: [100 30. 30…

A: Given- State of 2D-stress given- σx=100 MPa,σy=20 MPa,σxy=τxy=30 MPa,   It is needed to find the…

Q: Determine the slope and the displacement at the end C of the beam. E = 200 GPa, I = 70(106) mmª. Use…

A: Find out displacement and slope at C.?

Q: Vertical reaction developed at B in the frame below due to applied load of 200 kN (with 200,000…

A:

Q: A 2 kN/m 6m 6 kN 4m 2m

A:

Q: If 200 ft3of oil weighs 10,520 lb, calculate its specific gravity

A:

Q: The truss is supported by rollers at A and by a pin-joint at Find the force in members CD, LD, and…

A: Given : F1 = 3000N F2 = 5880 N F3 = 7090 N F4 = 5780 N Find force in member CD, LD and KL ?

Q: A square footing 2.5 m X 2.5 m is built on a homogeneous bed of sand of density 19 kN/m3 having an…

A: Safe bearing capacity is given by:-Ultimate bearing capacityArea ×Factor of safety It is usually the…

Q: A gallon of water weighs 8.34 pounds. The Stean family has a round, 12-foot diameter, above -ground…

A: Given data: A gallon of water weighs 8.34 pounds.

Q: A gallon of water weighs 8.34 pounds. The Stean family has a round, 12-foot diameter, above -ground…

A:

Q: oblem 6.99 The 390-kg drum has a center of mass at point G. The grip at B on member DAB resists both…

A: Given Data : Weight of drum = 300 kg

Q: of the first point A was 180.750 m. Rule out a page of a level field book and enter the above…

A:

Q: What is the support reaction VG from the following figure?

A: In the given truss structure, G support is roller having only one reaction i.e., VG and support A is…

Q: Q- A 2 km long pipe of 0.2 m diameter connects two reservoirs. The difference between water levels…

A: Given- Length of pipe L=2 km, Diameter D=0.2 m, Head difference h=8 m, friction factor f=0.04,   It…

Q: For the given data of a close traverse, determine the missing bearings of courses DE and EF then…

A: Given:-distance bearingTo find:-area

Q: 80KN GOKN 4m 4m 4m 4m 4m 4m w= 20 kN/01 Gm 6m Lia

A: Given- A propped cantilever Beam having an internal hinge at B. Required- To calculate shear force…

Q: 60 kN AQ А 6 m 40 kN 16 m B

A:

Q: The following figure shows a simple bracket made of structural steel with Young's modulus E = 200…

A: We will use the Finite Element method (FEM)to solve the given problem:- FEM is the numerical method…

Q: A new office park is considering to start an express bus service for workers. A survey of office…

A: mode utility equation-  Um=a0-0.47×OPCm-0.22×TTT To find-  a) Expected percentage of bus riders b)…

Q: Problem 4 The moist weight of 28.8 x 10^4 m^3 of soil is 54.27 N. If the moisture content is 12%…

A: Moist weight of soil, W = 54.27 N The total volume of soil, VT = =28.8 × 10-4 m3  Moisture content,…

Q: A sampling tube has an inner diameter of 80 mm and outer diameter of 88 mm. The area ratio is A 0.21…

A: Given- Inner diameter D1=80 mm, Outer diameter D2=88 mm, It is needed to find the Area Ratio for the…

Q: Construct a contour with a contour interval of 0.20 m. The proportional spacing of contour lines…

A: Contour interval = 0.20m Elevation for which conyours to be obtained = 92m, 93m, 94m, 95m & 96m

Q: Under repeated loading a material has the stress-strain curve shown in figure, which of the…

A: The given figure is shown below:

Q: 7. A vertical rectangular sluice gate at the bottom of the dam is 0.60m wide and 1.8m high and…

A:

Q: Determine the components of reaction at the supports. Joint C is a rigid connection.

A:

Q: A #2 Determine the slope and the displacement at the end C of the beam. E = 200 GPa, I = 70(106)…

A: Given data  P = 29 KN a = 3m E = 200 GPa = 2 × 105 N/mm2 I = 70 × 106 mm4 Find slope and deflection…

Q: *3-32. Determine the forces in all the members of the complex truss. State if the members are in…

A: Given: In this question, the given details are The given figure is Here, we want to determine the…

Q: Given the following data: Typical Classroom. Dimensions: 24 x 30 x 12ft. Required footcandles = 70.…

A: Room dimensions 24 *30*12 ft Working plane = 30 in = 2.5ft   To determine room cavity ratio.

Q: The safe stress, for a hollow column carries an axial load of 2.1 × 103kN is 125MPa. If the external…

A:

Q: Problem- Find the equilibrium discharge (in cumecs) of the S-curve derived from a 4-h unit…

A: Given data- 4-hour unit hydrograph, Area A=360 km2, To Find- The equilibrium discharge Q.

Q: 2. A compound used in automobile antifreeze, is 38.7 % C, 9.7% H, and 51.6 % O by mass. Its molar…

A: If we assume we have 100 g of the unknown, then %'s become grams and we then find moles of each…

Q: Q- What is end depth in free overall?

A: solution of above problem is below:

Q: The weights of two children sitting at ends A and B of a seesaw are 84 lb and 64 lb, respectively.…

A:

Q: Use A992 steel and compute the nominal compressive strength of a WT10.5 × 66 with an effective…

A: Given         For WT 10.5*66  From AISC table,                   Ay = 19.4 in2                  rx=…

Q: A. Determine the magnitude of normal reaction at A B. Determine the x component of the reaction at B…

A: An inclined beam simply supported A and B, acted upon by uniformly varying load, 1k/ft at A and…

Q: What role does traffic analysis and monitoring play specifically?

A: Traffic analysis is the process of engineering investigation to evaluate a transportation system.…

Q: A reservoir of glycerin has a mass of 1200 kg and a volume of 0.952 m3. Find the glycerin’s…

A: Given :Mass of glycerin, m=1200 kgVolume of glycerin, V=0.952 m3

Q: Determine the deflections at point B of the beam shown if only the 270 kN load is applied and the…

A:

Q: An oven-dried soil having a mass of 200 g is placed in a pycnometer which is then completely filled…

A:

Q: The rainfall on five successive days in a catchment were measured as 3, 8, 12, 6 and 2 cm. If the…

A:

Q: The drainage area of a watershed is 50 km². The - index is 0.5 cm/ hour and the base flow at the…

A:

Q: A. Determine the y component of reaction at A. B. Determine the x and y components of reaction B. C.…

A:

Q: A water tank has sloping inclined at 45degrees with the horizontal. The total depth of water in the…

A: Slope 45 degrees with horizontal Total depth = 10 m The orifice is located, h =  8m from the top…

Q: A Determine the slope and the displacement at the end C of the beam. E = 200 GPa, I = 70(106) mmª. a…

A: Given data  P = 54 KN  a = 2m  E = 200 GPA = 2 × 105 N/mm2 I = 70 × 106 mm4 Find slope and…

Q: Using the method of joints, determine the forces in all members of the truss

A: ###Determination of all member forces by method of joint####

Q: The interior angle x (ABC) and its explement angle y (CBA) were turned to close the horizon. Each…

A:

Q: Note: Assume any suitable values for missing data. WCB of Line AB = X*5 (X is one ) Q. The following…

A: To Determine :- Complete the gales traverse table as follows: Apply all necessary corrections for…

Floor Plan Details

Floor plans are the scale drawings that show the interplay of rooms, spaces, and physical objects. They are an integral part of the house plan. They let you see how people will move around the room. Floor plans determine the suitability of space for its intended use, work through any potential issues, and redesign before moving on to more comprehensive planning or constructing phases. It shows the different alternatives and perspectives related to the location and dimension of rooms, windows, doors, kitchen and all other things as per the requirement by the user. Many consultants give their own floor plans as reference to the clients for a better idea and to develop good floor plans.