Please written by hand draw the structure kf ghe kissing intermediates and products in the following mechanism. will rate.

Q: (4) From the data given below calculate AGT200 and hence comment on the feasibility of use of…

A:

Q: The equilibrium constant for the reaction N204 (g) + 2 NO2 (g) is 0.100 at 45 °C. Calculate AG° for…

A:

Q: N2(g) + 3H2(g) ⇌ 2NH3(g) If the Keq =7.44 x 10^5, [N2] =0.000723 M, and [H2] =0.0581, what is the…

A: The answer is given below

Q: (4) From the data given below calculate AG200 and hence comment on the feasibility of use of…

A:

Q: 1. Vinegar is a solution of acetic acid (the solute) in water (the solvent) with a solution density…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Decreasing the particle size fraction of a liming material increases the lime rate required to raise…

A:

Q: 2. What would be the best alcohol to use in an acid-catalyzed dehydration to prepare 1,3-…

A: the best alcohol to use would be 2,5-dimethylcyclopentanol.  This way no matter what side the…

Q: Glycerol, C3H03, is a substance used extensively in the manufacture of cosmetics, foodstuffs,…

A: given :-  volume of glycerol = 70.000 mL  density of glycerol = 1.2656 g/mL volume of solution =…

Q: Feagents are strong bases. Because of this, they cannot be prepared from compounds that contain…

A: 1. Ans : 3 ( Acidic hydrogens are present in the staring material. Therefore Grignard generation is…

Q: In the reaction: 2 C2H6(g) + 7 O2(g) -> 4 CO2(g) + 6 H2O(g), increasing the concentration of C2H6(g)…

A:

Q: The preparations of two aqueous solutions are described in the table below. For each solution, write…

A: The first question is a simple acid and base reaction. It results in the formation of conjugate acid…

Q: Consider an element that reaches its first excited state by absorption of 480.4 nm light. Determine…

A:

Q: () TH. エ

A: Note : 2800 cm-1 and 2700 cm-1 aldehyde C-H stretch. 1710 cm-1 is carbonyl stretch. Therefore the…

Q: grams of CaH2 are

A:

Q: Determine the oxidation state of the transition metal in each of these coordination compounds.…

A: Oxidation state of transition metal in coordination compound can be known by substituting oxidation…

Q: another compound called hydrogen peroxide, H202. Hydrogen peroxide was first obtained by treating…

A:

Q: When 2.0 g NaOH were dissolved in 53.0 g water in a calorimeter at 24.0 °C, the temperature of the…

A: a) Now QH2O is the amount of heat absorbed by the water where its temperature increased from 24.0oC…

Q: Grading Your final exam score will be posted after I have graded the essay question. The exam score…

A: The false statement are as follows: c) A mixture is 2 or more different pure substances chemically…

Q: Complete the table below, which lists information about some diatomic molecules or molecular ions.…

A:

Q: OH 1) TsCl, py 2) NaSH, DMSO

A:

Q: A solution is prepared by adding 0.10 mole of Ni(NH, ),Cl, to 0.50 Lof 3.4 M NH, Calculate Ni…

A:

Q: a. When the light source is monochromatic, Beer's Law holds true. b. Beer's Law establishes a…

A: The answer is given below

Q: Which of the following would be the major product of the reaction shown below? CHO но MEOH H он -он…

A: Ans : a ( Put left side groups at up side and right side groups at bottom side on furanose ring.).

Q: Calculate the amount of heat needed to boil 143. g of hexane (C,H14), beginning from a temperature…

A:

Q: A certain compound is composed of 69.58% Ba, 6.09 % C and 24.32% O. What is its empirical formula.…

A:

Q: Draw the major product of this reaction. Ignore inorganic byproducts and CO2. 1. O3 2. CH3SCH3…

A:

Q: B. 500 ml of 0.1N FeSO4.(NH4)2SO4.6H2O Solution: 1. Pulverize about 20 grams of ferrous ammonium…

A: No of moles = Mass / Molar Mass Molarity = No of moles / Volume (L)

Q: What is the expected product of this reaction? H2SO4, H20 H9SO4 А. HO, D. OH ÓH Е. H. OH C. A. B.

A: Explanation :

Q: For efficient disinfection to occur, treated drinking water should contain about 0.5 mg/L of Cl₂…

A:

Q: (a) Place the following gases in order of increasing average molecular speed at 25°C: Co, SF5, H2S,…

A: Average speed of gas molecules is given by the formula  c = 8RTπM M = molar mass of the gas    Root…

Q: Calculate AG for the reaction given below if the partial pressure of NO2 is 0.273 atm and the…

A:

Q: what is the enthalpy change per mole of CO2 for the following reaction? CO(g) + 1 /2 O2(g)  CO2(g)

A:

Q: (4) From the data given below calculate AG200 and hence comment on the feasibility of use of…

A:

Q: What is the predicted product for the reaction shown? H2SO4 HO OH II III IV

A:

Q: why does trans-tetraammine(dichloro)cobalt(III) chloride turn from an emerald green color to a light…

A: In this Trans isomer get converted  into cis isomers and Octahedral splitting  increases

Q: You are given the following reaction to complete in lab. However, you recognize an issue with the…

A:

Q: Tungsten trioxide (WO,) has a rich yellow color and is often used as a pigment in ceramics and…

A:

Q: Please help ASAP Provide the reagents or sequence needed to convert p-methylbenzaldehyde to each of…

A: We have find out the reagents for conversion.

Q: Draw the major product of this reaction. Ignore inorganic byproducts and CO2. 1. O3 2. CH3SCH3…

A: First O3 acts as an oxidizing agent and do insertion of O3 in double bond and then finally converted…

Q: Which structures do NOT have conjugated pi-bonds? O: I. II. I. IV. O A. I & II O B. I & II O C.I& IV

A: Please find your solution below : A conjugated system is a system that has alternate single and…

Q: Mechanism 2 ketal formation using ethylene glycol and catalytic TSOH

A:

Q: Calculate the pH of an aqueous solution that contains 0.369 M potassium sulfite and 0.482 M…

A: Given- Concentration of potassium sulphite= 0.369M  Concentration of potassium hydrogen sulphite=…

Q: What is the mass (in grams) of 11.50 L of propane vapor (C_H) at STP?

A:

Q: OFrom the data given below calculate AGT200 and hence comment on the feasibi use of hydrogen as a…

A:

Q: a. Determine the order with respect to each reactant b. Determine the overall order of reaction C.…

A:

Q: Br Fill in the missing reagents or structures associated with the multi-step synthetic sequence…

A: Reaction 1 : Grignard reaction. Reaction 2 : RMgX reaction with carbondioxide and water. Reaction 3…

Q: The equilibrium constant for the reaction N204 (g) =* 2 NO2 (g) is 0.200 at 65 °C. Calculate AG° for…

A: Given :-  N2O4(g) <-----> 2NO2(g)  K = 0.200  T = 65°C  To calculate :- ∆G° for this reaction

Q: (c) Octane has a density of 0.692 g/mL at 20°C. How many grams of 02 are required to burn 5.45 gal.…

A: c) Given, Density of octane (C8H18) = 0.692 g/mL Note: 1 gal = 3.79 L 1 L = 1000 mL Volume of octane…

Q: A) When 12.0 mL of a 5.67x10^-4 M sodium sulfate solution is combined with 15.0 mL of a 3.57x10^-4 M…

A: In order to check whether the precipitate is formed or not, we needed to compare the value of K…

Q: Suppose a current of 0.800 A flows through a copper wire for 22.0 minutes. Calculate how many moles…

A:

Designing a Synthesis

Organic synthesis is a branch of chemical synthesis that involves the planned construction of organic compounds/molecules from smaller units that possess functional groups. Friedrich Wöhler was the first scientist who designed the synthesis of an organic compound, urea from inorganic starting materials silver cyanate with ammonium chloride via a simple, one-step synthesis.