Plot the graph between P vs Va in Dc shunt excitation motor

Q: Define regulation of the full wave rectifier?

A: Since multiple questions are present, as per the guidelines, in the following section, the solution…

Q: 05- An earth station is receiving a signal from a space research satellite on a frequency of 11GHZ.…

A: We need to find out average power density and received power and effective area of antenna

Q: A sinusoidal voltage source is represented by the vector pointing to 6 + j4 on the complex plane. It…

A:

Q: (B)- Indicate whether the following statements are true or false and correct the false statements 1-…

A: In this question we need to verify the given statement is true or false

Q: Given Figure Q2(b) is a second order circuit. Analyse the circuit and obtain the following: (i)…

A: As per the guidelines we are supposed to answer only first three subparts.Please repost the…

Q: Compose the mesh equations. 10 Q j10 O j10 O l i5 v sine 10 V [11] [12] :-10 O sine @mesh 1: Z111 +…

A:

Q: One line voltage of a balanced Y-connected source is VAB 180/ – 20° V. If the source is connected to…

A: The solution is given below

Q: For the given circuit below, compute for the power dissipation of the diode. Si RL 8 k2 Vs 18 V

A:

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered  at a time,…

Q: For medium transmission line under light load or no load condition the receiving end voltage is…

A:

Q: find the RAB in fig. A. Ikn 9kn 9kn 3k 3kn B.

A:

Q: You have x[n]= sin @̟n *→X(e®), with 0<@ <n. Determine the value of we to ensure X(e") = 5 %D

A: x[n]=sin ωcnπn2↔ℱX(ejω) with 0&lt;ωc&lt;π.  We need to determine the value of ωc to ensure that…

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A:

Q: A 3-phase 50 Hz I.M. has a rated torque = 16.7 N.M and maximum torque = 40.5 N.M. If its rated speed…

A:

Q: (B)- Indicate whether the following statements are true or false and correct the fals statementS. こに…

A: In this question we will write about dc motor related questions and about interpole winding....…

Q: (a) For an AM DSBFC wave with an unmodulated carrier voltage of 18V and a load resistance of 50Ω. If…

A: In this question,   We need to determine the total sideband power And total transmitted power?

Q: Vhat would be the barrier potential of a silicon diode when the junction emperature is at 10°C?…

A:

Q: For the following network, find the value of load resistance RỊ for maximum power to RL. R1 R3 6Ω…

A:

Q: IN KL1 L2 1 OUT V1 L1 L2 R2 1µ 9µ 1 SINE(0 1 1Meg) Rser=.1 .tran 3u

A: Given the circuit, as shown below: We need to explain what will happen with the voltage on the left…

Q: Based on Figure Q1(a), find the equivalent capacitance seen at the terminal of the ircuit. (4 marks…

A:

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: As per the guidelines of bartleyby I need to Answer first three subparts only so kindly repost other…

Q: In power factor correction where a motor load is normally operating with 1000 inductive vars, a…

A: It is mentioned, that in power factor correction when motor loads operate with 1000 inductive VARS…

Q: (b) An AM signal with 100 percent modulation has an upper sideband power of 32 W. Determine: (i)…

A:

Q: six pole three-phase 440-volts 50Hz, induction motor develops an 8-Hp at 955 rpm, the power factor…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Find the Laplace Transform of the following. Answers must be in a simplified form and solutions must…

A:

Q: The frequency of the rotor circuit increase as the rotor speed decreases True O False O

A:

Q: 1.2.3 3. Use nodal analysis. please do complete kvl kcl solution solving thankyou

A:

Q: The maximum and minimum stresses in the dielectric of a single core cable are 40 KV/cm (rms) and 10…

A:

Q: Fourier transform can be widely used in real applications in daily life. 1. Please list at least 2…

A: According to the question, we need to enlist the 2 applications of the Fourier transform.

Q: Q3) The conduction angle of SCR in AC chopper fed R-load is equal to а. а Ob. B Oc. B+n Od.n-a

A: In this question,  we need to choose the correct options What is conduction angle of SCR?

Q: Draw the y(t) signal if the signal x(t) shown below: 1. y(t) - x(t - 1) 2. y(t) - x(t + 4) %3D x(t)…

A:

Q: Find the value of RL for maximum power transfer in the network and the maximum power that can be…

A:

Q: (a) Calculate: (1) The slip and line current. (ii) The torque and mechanical power. (iii) The…

A:

Q: Plot the graph between P vs Va in Dc compound excitation motor

A: In this solution we discusses about the concepts related the DC compound motor &amp; its P Vs Va…

Q: A DID S B CI — СО

A:

Q: Calculate the radiation efficiency, in %, for a half wavelength dipole antenna whose radiation…

A:

Q: What is the magnitude of the line-to-line voltage across the two loads? (The two loads have the same…

A: Let Z is the each impedence In delta connection, then after converting into star connection the new…

Q: Refer to Figure 8. Find Thevenin equivalent circuit with two different methods.

A:

Q: Q/ Name a Schottky diode that operates at small frequencies

A: The Schottky diode is a type of metal– semiconductor junction diode. Schottky diodes are also known…

Q: In radio transmission, the Maximum Usable Frequency (MUF) is the: Highest frequency possible for…

A: The radio transmission is a type of communication which involves use of electromagnetic waves for…

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A:

Q: 1. A regular tetrahedron has vertices at P1 (2, 0, 0), P2 (-1, √3, 0), P3 (-1, -√3, 0), and P4 (0,…

A:

Q: Q1) Determine and sketch the double side spectrum, up to the third harmonic, of the continuous-time…

A:

Q: 3 Shown on the left from 0st<20 ms is an analog signal xa(t) sampled at a rate Fs to get x[n]. What…

A: Sampling Rate:  For functions that fluctuate in space, time, or any other dimension, sampling can be…

Q: A continuous-time signal is composed of in-phase sinusoids with periods of 1 ms, 2 ms, and 4 ms.…

A:

Q: Calculate the gate to source voltage VGs for a NMOS transistor with B 2200 HA/V, V=1 V and operating…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 2 kn What is the required value of R for a EDIFIC o Vout 2.2 kn voltage gain of 10 b) Determine Vout…

A: Here negative feedback is present so we can apply virtual gorund concept here  According to virtual…

Q: 3. Three non-inductive resistances, each of 100 Q, are connected in star to a three- phase, 440-V…

A: We convert the given delta connected inductive coil into star and analysis the 3 phase system on per…

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A: In this question we need to find a voltage VC(t) , Vo(t) and io(t)

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.