ppose Ma igdeburg hollow sphere with a hollow cube, with a volume of 1 cubic foot. The cube is bisected into two equal halves and the seams are sealed with grease. When the cube is evacuated, what is the maximum force (in lbs) needed to pull the cube anart (at sea levell? Does it matter how the cube is bisected?

ppose Ma igdeburg hollow sphere with a hollow cube, with a volume of 1 cubic foot. The cube is bisected into two equal halves and the seams are sealed with grease. When the cube is evacuated, what is the maximum force (in lbs) needed to pull the cube anart (at sea levell? Does it matter how the cube is bisected?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

What is the compression force on S1 if lumbosacral angle is 50 degrees? What is the pressure if the contact area is 15 cm^2?
A commpon way of salvaging cannons from old wreacks is to attach an inflatable balloon filed with air. Assume that the cannon is a solid cylinder of iron which is 1.30m long with a radius 17.3cm. The density of iron is 7.87g/cm^3. a. If an air bag were filled twice the volume necessary, what will be the tension in the rope between the air bag and the cannon when the air bag reaches the surface and comes to rest? What volume of air bag wil be floating above the water surface?
A barge has the trapezoidal shape shown in Fig. andis 22 m long into the paper. If the total weight of barge andcargo is 350 tons, what is the draft H of the barge whenfl oating in seawater?
A circular plate of radius 2ft is lowered to a liquid (w=1000 lb/ft^3) so that its center is 4 ft below the surface. Find the force on the lower half of the plate.
The iceberg idealization may becomeunstable if its sides melt and its height exceeds its width. InFig. suppose that the height is L and the depth intothe paper is L , but the width in the plane of the paper isH , L. Assuming S =0.88 for the iceberg, fi nd the ratio H / Lfor which it becomes neutrally stable (about to overturn).
A metal block 2 ft square and 10 in. deep is floated on a body of liquid which consists of an 8-in layer of water above a layer of mercury. The block weighs 120 lb/ft3. What is the position of the bottom of the block? If a downward vertical force of 500 lb is applied to the center of this block, what is the new position of the bottom of the block ?
A cylinder weighs 150 lbf. Its cross-sectional area is 40 in^2. When the cylinder stand vertically on one end, approximately what pressure does the cylinder exert on the floor?
A barge of 20 ft wide and 40 ft long is loaded with rocks. Assume that the center of gravity of the rocks and the barge is located along the centerline of the top surface of the barge.If the rocks and the barge weigh 400,000 lbf, will the barge float upright or tip over?
A barge is 15 ft wide and 40 ft long and fl oats with a draftof 4 ft. It is piled so high with gravel that its center of gravityis 3 ft above the waterline. Is it stable?
A 10cm x 10 cm x 10cm block of steel (ρsteel = 7900 kg/m3) is suspended from a spring scale. The scale is in Newtons. a. What is the scale reading if the block is in air? b. What is the scale reading after the block has been lowered into a beaker of water and is completely submerged?
A semicircular plate of radius 5ft rests vertically on its diameter at the bottom of a pool filled with water to a depth of6ft. Assume that the water’s weight density is62.4lb/ft3.•Find the force exerted by the water against on side of the plate.
What percent of the volume of a piece of iceberg (sg=0.915) will float above the water?