Two large parallel glass plates separated by a distance d water. The contact angle between the water meniscus and the glass plate is approximately zero. How height will the water rise due to capillary action if the surface tension between water and air is 0.07 N/m? 1 mm are placed vertically in

Two large parallel glass plates separated by a distance d water. The contact angle between the water meniscus and the glass plate is approximately zero. How height will the water rise due to capillary action if the surface tension between water and air is 0.07 N/m? 1 mm are placed vertically in

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: The density of stainless steel is about 8000 kg/m3 (eight times denser than water), but a razor…

A: (a) The free body diagram of the total mass is given as, In this case, the total maximum weight of…

Q: An 8-in.-diameter piston is located within a cylinder that is connected to a 0.5-in.-diameter…

A: The rise in the fluid in the vertical direction can be determined as,

Q: It is said that Archimedes discovered the buoyancy lawswhen asked by King Hiero of Syracuse to…

A: Understand that the weight of the crown in air is higher than the weight of the crown in water…

Q: A vertical rectangular plate is submerged half in oil (s = 0.80) and half in water such that its top…

Q: A bottle consist of a cylinder 35 cm in diameter and 30 cm high and a neck 5 cm in diameter and 30…

Q: A vertical rectangular gate 3m wide and 1.75m high has water on one side with surface of liquid 3m…

Q: A rectangular plate 0.6 m wide and 1.2 m deep lies within a water body such that its plane is…

A: Consider th FBD of the given case drawn belowso given thatwide=0.6mdeep=1.2minclination=45°rope…

Q: A glass tube of intemal diameter 3 mm is immersed in mercury. The angle of contact of mercury with…

A: Given that, d=3 mm=3×10-3 mσ=0.48 N/m

Q: To what height will 68˚F ethyl alcohol rise in a 0.005 in internal diameter glass capillary tube?…

Q: Find surface tension in a soap bubble of 50 mm diameter when the inside pressure is 2.578 N/m2 above…

A: Given diameter of soap bubble is 50 mm = 0.05m.

Q: Find surface tension in a soap bubble of 45 mm diameter when the inside pressure is 2.862 N/m2 above…

Q: The capillary effect in a glass tube of 3.7 mm diameter, when immersed in (1) water and (2) mercury…

Q: er is 1000 kg/m³, then total pressure force on the plate (in kg) is approximately

Q: Question 1a) A 4m wide flat plate is submerged such that its top horizontal edge is at the surface…

A: Problem 1 (a) The data given is, Density of water, ? = 1000 kg/m3 Height of bottom surface from…

Q: 3. A rectangular gate 1.4 m in base and 1.8 m high is placed on the face of the water reservoir, as…

A: Given: Length of the gate (L)=1.8mBreadth of the gate (b)=1.4Mass of the buoy (mb)=20kgMass of the…

Q: A glass tube of internal diamoter 3mm is immersed in mercury. The angle of contact of mercury with…

A: Given that, Diameter, d=3 mm Surface tension of liquid, σ=0.48 N/m We have to find: What will be the…

Q: The surface tesnion of waterr in contact with air at 20deg C is given at 0.0716 N/m. The pressure…

Q: Determine the capillary rise (in cm) in a glass tube of radius 0.25 mm that is immersed vertically…

A: Given Data S= 0.0725 N/m R=0.25 mm

Q: A closed cylinder of diameter 30 cm and height of 20 cm is completely filled with water. Calculate…

Q: A bottle consist of a cylinder 35 cm in diameter and 30 cm high and a neck 5 cm in diameter and 30…

A: Given Diameter = 35 cm High = 30 cm Neck diameter = 5 cm Long = 30 cm To find Depth of the open end…

Q: A glass tube of internal diameter 3mm is immersed in mercury. The angle of contact of mercury with…

Q: A U-shaped tube is partially filled with water. Oil is then poured into the left arm until the…

Q: water has surface tension of 72 dyne/cm. what contact angel would water make with this surface?

A: Explaining the contact angle of water made with the surface having a surface tension of 72 dyne/cm.

Q: . The U-tube in the figure below has a 1-cm ID and contains mercury as shown. If 20 cm? of water is…

Q: Consider two identical glasses of water, one stationary and the other moving on a horizontal plane…

A: The water will have same level of water at front, midpoint and back in glass which is stationary…

Q: For your science exhibit, you want to make a block of wood float at the interface between a layer of…

A: given data;lets take volume of block =Vdensity of wood(ρwood)=800kg/m3density of…

Q: Make an explanation for every solution. and please be clear with your numerical solution. Problem: A…

Q: A flat rectangular plate 1 m wide and 2 m long is immersed in water. The shorter side parallel to…

A: Calculate the distance of the plate centroid from the free surface using the given figure. x¯=0.5…

Q: How can you calculate the hydrostatic force FR (magnitude) and its point of application (center of…

A: Case (1) : Vertical Rectangular Plate dF = PdA ....Where P,i.e. P =ρgx is the pressure acting on…

Q: Gate ABC in Fig. is 1 m square and is hinged at B .It will open automatically when the water level…

A: The gate will open when the hydrostatic force F on the gate above B. That is when…

Q: 2. A triangular gate having a horizontal base 4 ft. long and an altitude of 6ft is inclined 45° from…

A: Given: The base of the triangular plate is, b=4 ft. The height of the triangular plate is, d=6 ft.…

Q: 3. As shown, a round viewing window of diameter D=0.8m is situated in a large tank of seawater…

Q: Consider a 6 m diameter spherical gate holding a body of water whose height equal to the diameter of…

A: Diameter = D = 6m Radius = R = D/2 = 6/2 = 3 m Horizontal Projection Area of Sphere A = 3.14 R2 =…

Q: O A rigid ring A and a rigid thin disk B both made of same material when gently placed on water just…

Q: Calculate the volume of a water cylinder with total height of 10 meters and whose diameter is 400…

A: Given Data D=400 cm=4 m H=10 m

Q: 10. The U-tube in the figure below has a 1-cm ID and contains mercury as shown. If 20 cm' of water…

Q: An 8-in.-diameter piston is located within a cylinder that is connected to a 0.5-in.-diameter…

Q: A 15cm diameter, 40cm high vertical cylindrical container is partially filled with 25cm high water,…

Q: Find the position of the center of pressure of a circular plate of diameter 1.5m placed vertically…

Q: Calculate the capillary rise in cm in a glass tube of 3.0 mm diameter when immersed vertically in…

A: Given data d = 3 mm = 3 x 10^-3 m ( d = diameter ) σ = 0.0725 N/m ( σ = surface tension) s =…

Q: "Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

Q: Calculate the capillary effect in millimetres in a glass mm diameter, when immersed in mercury. The…

Q: Determine the capillary rise of water in glass tube if the surface tension of water=0.00287 N/m and…

A: Given data : The value of surface tension of water=0.00287 N/m The value of diameter of tube=80 mm…

Q: A 4m wide flat plate is submerged such that its top horizontal edge is at the surface of the water…

A: As per the company policy, I will solve the question (1 a). For rest of the question please re-post…

Q: In a zero gravity region, a drop of a liquid of surface tension o assumes a cylindrical shape of…

A: The force acting on the plate due to surface tension is showing below, The force is inward to the…

Q: A wire ring of radius 6 cm is rested flat on the surface of a liquid and then slowly raised. The…

A: We know that a wire ring with a radius of 6 cm is laid flat on a liquid's surface and then…

Q: a close cylinder of diameter 30 cm and height 20cm is completely filled with water. calculate the…

A: Given, Diameter of cylinder,D=30cmHeight of cylinder,H=20cmN=300rpmTo calculate-Total pressure force…

Question

1. Two large parallel glass plates separated by a distance d
water. The contact angle between the water meniscus and the glass plate is approximately
zero. How height will the water rise due to capillary action if the surface tension between
water and air is 0.07 N/m?
= 1 mm are placed vertically in

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Step 1

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.
The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.
Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
A glass tube 5 ft long and 1 inch in diameter with one end closed is inserted vertically with the open end down, into a tank of water until the open end is submerged to a depth of 4 ft. If the barometric pressure is 14.30 lb per sq.in, and neglecting vapor pressure, how high will water rise in the tube?
water has surface tension of 72 dyne/cm. what contact angel would water make with this surface?
A factory's pressure tank rests on the upper base of a vertical pipe whose inside diameter is 1 ft. and whose length is 40 ft. The tank is a vertical cylinder surmounted by a cone, and it has a hemispherical base. If the alti-tudes of the cylinder and the cone are respectively 6 ft. and 3 ft. and if all three parts of the tank have an inside diameter of 6 ft., find the volume of water in the tank and pipe when full.
Calculate the volume of a water cylinder with total height of 10 meters and whose diameter is 400 centimeters, whose top section is a semi-spehere.
A square lamina (each side equal to 2m) is submerged vertically in water such that the upper edge of the lamina is at a depth of 0.5 m from the free liquid surface. What will be the hydrostatic pressure in kPa on the lamina? Determine the center of gravity on the lamina from the free liquid surface.
A closed cylindrical tank 2m in diameter and 8m deep with axis vertical contains 6m deep of oil (SG =0.8). The air above the liquid surface has a pressure of 0.8 kg/cm2. Determine the total force and location of it from the bottom of the tank?
Find the total pressure on a circular plate of diameter 1.5 m which is placed vertically in water in such a way that the centre of the plate is 3 m below the free surface of water.
A Vertical circular gate or radius “r” is submerged in a liquid with its top edged flushed on the liquid surface. Determine the location of the total force acting on one side of the gate and its magnitude
A circular plate of diameter 3 m is immersed in water in such a way that its least and greatest depth from the free surface of water are 1 m and 3 m respectively. For the front side of the plate, find (i) total force exerted by water and (ii) the position of centre of pressure.