Prepare a Temperature vs Time cooling curve for each of the two trials involving the lauric acid/stearic acid mixtures. Perform a linear regression analysis on the cooling and freezing regions as before. Calculate the point of intersection and identify this point on each graph by inserting a text box and arrow. Report the freezing point for each of the two trials [T(1) and T (2)]. Freezing point (1st trial of lauric acid) T(1) = Freezing point (2nd trial of lauric acid) T/(2) =

Prepare a Temperature vs Time cooling curve for each of the two trials involving the lauric acid/stearic acid mixtures. Perform a linear regression analysis on the cooling and freezing regions as before. Calculate the point of intersection and identify this point on each graph by inserting a text box and arrow. Report the freezing point for each of the two trials [T(1) and T (2)]. Freezing point (1st trial of lauric acid) T(1) = Freezing point (2nd trial of lauric acid) T/(2) =

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter88: Column Chromatography

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

Extraction of the aqueous salicylic acid solutions with 10% ethyl acetate/hexane (density ~ 0.7 g/ml) will give two layers in the separatory funnel. Will the aqueous layer be the upper layer or the lower layer? If dichloromethane (density ~ 1.3 g/ml) were substituted for the 10% ethyl acetate/hexane solution, which layer would be the aqueous layer?
As a newly appointed research officer, Marissa has been assigned a task to separate a mixture containing acetone, acetamide and 1,2-dichloroethane using a high-performance liquid chromatography (HPLC) technique. The instrument was equipped with a 40-cm column packed with cyano propyl bonded to the siloxane backbone material. i) List THREE (3) examples of mobile phase solvent/solvent systems that can be used with the column above. ii) Determine the sequence in which the three analytes eluted from the column and explain the underlying principle applied. iii) Sketch the chromatogram that would be produced if the column was replaced with a column filled with C18 hydrocarbon bound to the siloxane backbone material and acetonitrile was employed as the mobile phase. Label the peaks observed.
What could have gone wrong in the separation and purification process to result in the disparity from the observed and expected yields? Select all that apply A) Both the benzoic acid and sand may have been wet before the student recorded the masses, hence the increase in expected masses. B) The student may have filtered the benzoic acid while cold. Hence the sand could have been contaminated with benzoic acid and resulted in a higher mass for sand. C) The sand may have dissolved in the hot water along with the benzoic acid, hence, the recorded mass for benzoic acid was more. D)The benzoic acid may have been cooled down too quickly on ice thereby allowing other soluble impurities to crystallize with benzoic acid causing the increase in the expected mass
10g coffee 4g sodium carbonate 40m dichloromethane 160ml distilled water coffee filter What are the principles behind caffeine being extracted from coffee using the above items? 1st sodium carbonate mixed with coffee then brought to a boil for 20min then solution/grinds are filtered. Then solution is added to a separatory funnel with 15ml of dichloromethane and two layers are observed so the bottom layer with DCM contains the caffeine, then this layer is collected in a beaker and dried out using molecular seeds. Then the solvent is brought to a boil with crude caffeine remaining and recystallized using 95% ethanol and brought to a boil again. Then the contents are vaccum filtered and allowed to dry resulting in 30mg caffeine.
Below is a chromatogram observed from chemical separation of chlorinated pesticides using gas chromatography. Water samples were pre-treated using solvent extraction technique prior to injection into GC. Complete the statements below so that the sentences will be accurate and logical. Gas chromatography coupled with __________ __________ detector is suitablefor chlorinated pesticide analysis. ii. Peaks that emerge first will represent compounds that are the most __________.Those compounds will also likely have low boiling points and show the leastinteractions with the stationary phase. iii. Major peaks start to emerge after 24 minutes. Heating the GC oven containing the column will likely __________ the time of chromatographic separation. iv. The peak height or area of an analyte is used to determine its __________ in quantitative analysis.
A student was careful to make and stir all of her standard solutions immediately before measuring their turbidity for her calibration curve. However, she let her tap water solutions sit for 10 minutes prior to measuring their turbidity. If she measured the top portion of the solution, would her experimental sulfate ion concentration be higher or lower than it should be?
Earth, a CHEM 40.1 student, extracted a mixture of pigments from the roots of Rubiatinctorum, commonly known as rose madder. Earth spotted the root extract on twohydrophobic silica gel plates. He then placed each plate in separate developing chambers,one containing solvent system WHITE and the other housing solvent system MIX. Earthallowed the chromatograms to develop for around five minutes. Afterwards, he removedthe plates from the containers and placed them inside an iodine chamber. Thechromatograms resulting from the TLC experiment after visualization are illustrated asfollows. The distances travelled by each spot and by the solvents were measured andrecorded in the displayed table.
separate a mixture containing acetone, acetamide and 1,2-dichloroethane using a high- performance liquid chromatography (HPLC) technique. The instrument was equipped with a 40-cm column packed with cyano propyl bonded to the siloxane backbone material. i) List THREE (3) examples of mobile phase solvent/solvent systems that can be used with the column above. ii) Determine the sequence in which the three analytes eluted from the column and explain the underlying principle applied. iii) Sketch the chromatogram that would be produced if the column was replaced with a column filled with C18 hydrocarbon bound to the siloxane backbone material and acetonitrile was employed as the mobile phase. Label the peaks observed.
Of Aspirin, ethanol, acetaminophen, ethyl acetate, hexane, and water which could go undetected during HPLC analysis, but could result in a lower than expected melting point, why are they not detected by HPLC analysis?
Identify the effect of the condition on the parameters. Write increase, decrease, or no effect. And Explain. A. The test tube used in the determination of the ΔHrxn for nitric acid was still wet with water. [ magnitude of ΔHrxn] B. The thermometer and stopper were inserted to the test tube 5 minutes after adding the base in the calibration part. [Ccal]
Arrange in INCREASING Rf if the mixture underwent paper chromatography with the same solvent system. Explain how you get the answer I. 2-chloropentaneII. pentanoic acidIII. cyclopentaneIV. pentanal a. II = IV < III < I b.II < IV < I < III c.I < II < III < IV d.III < I < IV < II
please quickly ,within 1hour thanks ! If it takes longer than an hour, i don't need the answer (2) List the representative stationary phase for gas chromatography.