#4 Vibration questionComplete solution and correct units pls. Thanks Prob. # 4] The mass m is suspended from an idealspring of stiffness k and is set into motion with the initialconditions x, = 9 mm and vo = 1.2 m/s. Assume that x ismeasured from the equilibrium position of the mass. Ifthe amplitude of the vibration is 12 mm, determine a)the frequency; and b) the x as function of time.

For solution refer below images.

Prob. # 4] The mass m is suspended from an ideal spring of stiffness k and is set into motion with the initial conditions x = 9 mm and v.- 1.2 m/s. Assume that x is measured from the equilibrium position of the mass. If the amplitude of the vibration is 12 mm, determine al the frequency; and b) the x as function of time.

Prob. # 4] The mass m is suspended from an ideal spring of stiffness k and is set into motion with the initial conditions x = 9 mm and v.- 1.2 m/s. Assume that x is measured from the equilibrium position of the mass. If the amplitude of the vibration is 12 mm, determine al the frequency; and b) the x as function of time.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A uniform disk with radius r and mass m can roll without slipping on a cylindrical surface and is attached to bar ABC with a length L and negligible mass. The bar is attached at point A to a spring with a constant k and can rotate freely about point B in the vertical plane. Knowing that end A is given a small displacement and released, determine the frequency of the resulting vibration in terms of m, L,K and g.
A large industrial cooling system of mass 160 kg is supported by six springsarranged in parallel. Two of the springs have equal stiffness of 30 kN/m, twohave stiffness of 15 kN/m, and the remaining two have stiffness of 10 kN/m.Determine:i) the total stiffness of the spring system;ii) the natural frequency of vibration of the motor;iii) the periodic time for the vibration.
A three-blade wind turbine used for research is supported on a shaft so that it is free to rotate about O. One technique to determine the centroidal mass moment of inertia of an object is to place a known weight at a known distance from the axis of rotation and to measure the frequency of oscillations after releasing it from rest with a small initial angle. In this case, a weight of Wadd = 50 lb is attached to one of the blades at a distance R = 20 ft from the axis of rotation. Knowing that when the blade with the added weight is displaced slightly from the vertical axis, and the system is found to have a period of 7.6 s, determine the centroidal mass moment of inertia of the three-blade rotor.
A small collar of mass 1 kg is rigidly attached to a 3-kg uniform rod of length L = 750 mm. Determine (a) the distance d to maximize the frequency of oscillation when the rod is given a small initial displacement, (b) the corresponding period of oscillation.
A 6-lb slender rod is suspended from a steel wire that is known to have a torsional spring constant K=1.5 ft.lb/rad. If the rod is rotated through 180° about the vertical and released, determine (a ) the period of oscillation, (b ) the maximum velocity of end A of the rod.
The system shown left composed by two rigid bars with a distributed mass of m and 2m, respectively. Determine the natural vibration period of the system. (k = 100 N/m,c = m = 10kg/m, L = 4m)
A turbine rotor of a ship is of 2000 kg mass and has a radius of gyration of 0.8 m. Its speed is 200 rpm. The ship pitches 5o above and below the mean position. A complete oscillation takes place in 20 s and the motion is simple harmonic. Determine i. the maximum couple tending to shear the holding down bolts of turbine, ii. the maximum acceleration of the ship during pitching, and iii. the effect of gyroscope, if the rotation of the rotor is clockwise, when looking from aft.
A 30-lb uniform cylinder can roll without sliding on a 15° incline. A belt is attached to the rim of the cylinder, and a spring holds the cylinder at rest in the position shown. If the center of the cylinder is moved 2 in. down the incline and released, determine (a) the period of vibration, (b) the maximum acceleration of the center of the cylinder.
A slender 10-kg bar AB with a length of l = 0.6 m is connected to two collars of negligible weight. Collar A is attached to a spring with a constant of k = 1.5 kN/m and can slide on a horizontal rod, while collar B can slide freely on a vertical rod. Knowing that the system is in equilibrium when bar AB is vertical and that collar A is given a small displacement and released, determine the period of the resulting vibrations.
The period of vibration of the system shown is observed to be 0.6 s. After cylinder B has been removed, the period is observed to be 0.5 s. Determine (a) the weight of cylinder A(b) the constant of the spring.
An inverted pendulum consisting of a rigid bar ABC of length l and mass m is supported by a pin and bracket at C. A spring of constant k is attached to the bar at B and is undeformed when the bar is in the vertical position shown. Determine (a ) the frequency of small oscillations, (b ) the smallest value of a for which these oscillations will occur.
An elastic string of natural length 4a is fixed at one end to a point O.its hangs vertically and carries at its other end a particle of mass 2m , In the position of equilibrium ,the length of the string is 5a Find, i)The modulus of elasticity of the string ii)The period of small vertical oscillations of the particle when it is pulled downward from its equilibrium position and then released