Problem 2. The block in the figure below weighs 500 lb and the coefficient of friction between the block and the floor is 0.2. Determine if the system would be in equilibrium for P = 400 lb. Calculate the maximum P to prevent motion. Determine the maximum P for which the system is in equilibrium. 20 30

Problem 2. The block in the figure below weighs 500 lb and the coefficient of friction between the block and the floor is 0.2. Determine if the system would be in equilibrium for P = 400 lb. Calculate the maximum P to prevent motion. Determine the maximum P for which the system is in equilibrium. 20 30

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

6. Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by a double U-tube manometer, as shown in figure. Determine the pressure difference Pfresh water- Psea water= ?(kPa) between the two pipelines. Take the density of seawater at that location to be P = 1035 kg/m³. (2 decimal)
A horizontal pipe carries cooling water from a reservoir as shown in the following figure. If the pipe diameter is 20 cm, the flow rate is 0.06 m3/s, what is the pressure at L= 2000 m? Calculate head loss as hL = 0.015(L/D)(V 2/2g)
A 3 layered density tower includes 30 cm glycerin (D = 1260 kg/m3), 25 cm oil (D = 950 kg/m3), and 20 cm gasoline (D = 740 kg/m3). What is the absolute pressure against the bottom of a container?
1.) convert a pressure head of 15 m of water to meters of oil (sp. gr. =0.75).2.) Convert a pressure head of 600 mm of mercury to meters of oil (sp. gr.= 0.75)
A 40 mm plastic sphere (?? = 1.3) is dropped in a certain oil (?? = 0.85, μ =3.6 × 10−2 Pa∙s).(a) Determine its terminal velocity(b) If this sphere starts to rotate at 25 revolutions per second in the clockwise direction. Determine the magnitude and direction of the Magnus force
Figure P8.19 shows a pipeline through which water flows at a rate of 0.06 m3/s. The pipe is 3000 m long, it has a diameter of 120 mm, and it is straight. If the friction factor for the pipe is 0.03 and the loss coefficient for the pipe entrance is 1.0, calculate H, the depth of the reservoir, given that the pipe exits to atmosphere.
Problem 4. If the drum in the figure is open to the atmosphere at the top, calculate the force on the bottom.a. 283.8 kNb. 273.8 kNc. 263.8 kNd. 253.8 kNe. 243.8 kNf. 233.8 kN
Problem 7. Figure shows a dam 30.5m long that retains 8m of fresh water and is inclined at an angle 0 of 60’’. Calculate the magnitude of the resultant force on the dam.a. 18.06 MNb. 16.06 MNc. 14.06 MNd. 12.06 MNe. 11.06 MNf. 8.06 MN
The rectangular bin with an inclined gate AB is filled with oil to the depth shown. Determine the resultant force (kN) acting on the inclined side AB. Take density of oil - 900 kg/m^3 x=3.27 a=5.2 m b=30 degrees asap
A hollow cylinder 2.46-m in diameter and 7-m long weighs 3,159 N. How many cubic meters (m3) of metal weighing 112 kN/m3 must be placed inside the cylinder such that 2.9 m. of the cylinder is protruding above the liquid surface? The hollow cylinder is submerged in a liquid that has a specific gravity of 2.3. Round off to four decimal places.
Consider a rectangular plate of width B = 1m (measured in the direction normal to the plane of this sheet) and negligible thickness, which separates two fluids of densities ρ and ρw. A mass of density ρs is supported by an inextensible rope that passes through a pulley connected to one end of the plate. Consider that ρ = 1.59ρw and ρs = 2.40ρw, where ρw = 1000 kg/m3. Determine the volume that this mass must have for the system to remain in equilibrium, as shown in the figure.
For the figure ,point A is (30 cm) below the surface of liquid , What is the pressure. * a_17.658 kpa b_17.658 kpa (vacume) c_176.58 kpa d_Option 4