Problem 3 (activity) A regenerative steam turbine has a throttle pressure of 3.8 MPa at 380°C and a condenser at 0.01 MPa. Steam are extracted at the following points: 2.0 MPa, 1.0 MPa, and at 0.2 MPa. For the ideal cycle, find (a) The amount of steam extracted (b) W, Q, and e. (c) For an ideal engine and the same states, compute (d) W, Q, and e and

Problem 3 (activity) A regenerative steam turbine has a throttle pressure of 3.8 MPa at 380°C and a condenser at 0.01 MPa. Steam are extracted at the following points: 2.0 MPa, 1.0 MPa, and at 0.2 MPa. For the ideal cycle, find (a) The amount of steam extracted (b) W, Q, and e. (c) For an ideal engine and the same states, compute (d) W, Q, and e and

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Consider a steam power plant operating on the ideal Rankine cycle. The steam enters the turbine at 5.2 MPa, 350 o C and is condensed in the condenser at a pressure of 15 kPa. Determine (a) the thermal efficiency of the cycle. (b) What would the thermal efficiency be if steam were superheated to 750 o C instead of 350 o C ?
The mass flow rate of steam is 5 kg/s for a Rankine Cycle. For the actual cycle, the turbine efficiency is 86%, turbine brake efficiency is 80%, and generator efficiency=90%. The inlet conditions of the turbine are 3MPa and 400⁰C while the condensing pressure is 50kPa. a. Sketch the P-v, T-s and h-s diagram of the Cycle b. Calculate for the ideal and actual steam rates and heat rates of the Rankine Cycle and Rankine Engine, respectively. c. Determine the energy chargeable and combine thermal efficiencies for the Rankine Cycle and Rankine engine, respectively
Solve the Rankine Cycle problems. Draw a detailed Schematic and Ts Diagram. Show a clear and detailed solutions. 1, Consider a steam power plant that operates on an ideal reheat Rankine Cycle.The Plant maintains the boiler at 8MPa, the reheat section at 700kPa.and the condenser at 10kPa. The mixture quality at the exit of both turbines is 93%. Determine the temperature at the inlet of each turbine .
A steam power plant operates on the simple ideal Rankine cycle. Steam enters the turbine at 4 MPa, 500 degrees celcius and is condensed in the condenser at a temperature of 40 degrees celcius. draw and label the schematic diagram and the pV and TS planes. (a) Show the cycle on a T-s diagram. If the mass flow rate is 10 kg/s, determine (b) the thermal efficiency of the cycle (c) the net power output in MW.
Compare the thermal efficiency and turbine-exit quality (temperature if superheated) at the condenser pressure for a simple Rankine cycle and the reheat cycle when the boiler pressure is 5 MPa, the boiler exit temperature is 500°C, and the condenser pressure is 20 kPa. The reheat takes place at 0.5 MPa and the steam leaves the reheater at 500°C. (Enthalpies are in KJ/kg.) Without the reheater, the enthalpy at the turbine exhaust is: Without the reheater, the quality at the turbine exhaust is: The pump work is: The enthalpy leaving the reheater is: The thermal efficiency is:
Compare the thermal efficiency and turbine-exit quality (temperature if superheated) at the condenser pressure for a simple Rankine cycle and the reheat cycle when the boiler pressure is 5 MPa, the boiler exit temperature is 500°C, and the condenser pressure is 20 kPa. The reheat takes place at 0.5 MPa and the steam leaves the reheater at 500°C. (Enthalpies are in KJ/kg.) Without the reheater, the thermal efficiency is: The temperature at the exhaust of the low-pressure turbine is: The throttle enthalpy is: The heat added in the boiler is: The enthalpy at the suction of the pump is:
A turboprop aircraft propulsion engine operates where the air is at 8 psia and −10°F, on an aircraft flying at a speed of 600 ft/s. The Brayton cycle pressure ratio is 10, and the air temperature at the turbine inlet is 940°F. The propeller diameter is 10 ft and the mass flow rate through the propeller is 20 times that through the compressor. Determine the thrust force generated by this propulsion system. Assume ideal operation for all components and constant specific heats at room temperature.
Show complete solutions. In an ideal reheat-regenerative cycle, steam enters the turbine at 8.1547 Mpa and 400.547°C. After expansion to 280.547°C the steam is withdrawn and reheated to 340°C. Extractions for feedwater heating occurs at 1.6547 Mpa and 0.70547 Mpa and condenser pressure is 0.005547 Mpa a) For ideal cycle, find e,? b) Draw the schematic diagram and T-s diagram with label.
A steam power plant operates on the simple ideal Rankine cycle. The steam enters the turbine at 4 MPa and 500°C and is condensed in the condenser at a temperature of 40°C. draw and label the schematic diagram and the pV and TS planes. (a) Show the cycle on a T-s diagram. If the mass flow rate is 10 kg/s, determine (b) the thermal efficiency of the cycle (c) the net power output in kW.
A steam power plant operates on the ideal Rankine cycle principle (see installation schematic and T-s diagram below). Water vapor enters the turbine at 15 MPa and 500°C and is condensed at a condenser pressure of 10 kPa. Calculate the thermal efficiency of the cycle.
In a Rankine cycle, steam enters the turbine at 2.5 MPa and condenser at 50 kPa, what is the thermal efficiency of the cycle?
Steam at 10 MPa, 600C enters the first-stage turbine of an ideal Rankine cycle with reheat. The steam leaving the reheat section of the steam generator is at 500C, and the condenser pressure is 6 kPa. If the quality at the exit of the second stage turbine is 90%, determine the cycle thermal efficiency.