Problem 3 Air (ideal gas) enters an adiabatis compressor operating at steady state al a with a mass flow rate of 0.02 ke/ls and is compressed to 4 bar, 177C.The kinetic ana potential energy changes are neglected. Using variable specific heats, determine, a) The work consumed W in kW b) The change in specific entropy (s,-s,) in kJ/(kg.K) c) The rate of entropy generation S in kW/K

Problem 3 Air (ideal gas) enters an adiabatis compressor operating at steady state al a with a mass flow rate of 0.02 ke/ls and is compressed to 4 bar, 177C.The kinetic ana potential energy changes are neglected. Using variable specific heats, determine, a) The work consumed W in kW b) The change in specific entropy (s,-s,) in kJ/(kg.K) c) The rate of entropy generation S in kW/K

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water at p1 = 20 bar, T1 = 400oC enters a turbine operating at steady state and exits at p2 = 1.5 bar, T2 = 200oC. The water mass flow rate is 4000 kg/hour. Stray heat transfer and kinetic and potential energy effects are negligible.Determine the power produced by the turbine, in kW, and the rate of entropy production in the turbine, in kW/K.
Water at p1 = 20 bar, T1 = 400oC enters a turbine operating at steady state and exits at p2 = 1.5 bar, T2 = 180oC. The water mass flow rate is 4000 kg/hour. Stray heat transfer and kinetic and potential energy effects are negligible. Determine the power produced by the turbine, in kW, and the rate of entropy production in the turbine, in kW/K.
Water vapor at 5 bar, 320 °C enters a turbine operating at steady state with a volumetric flow rate of 0.65 m3/s and expands adiabatically to an exit state of 1 bar, 160 °C. Kinetic and potential energy effects are negligible. Determine for the turbine (a) the power developed, in kW, (b) the rate of entropy production, in kW/K
Water vapor at 10 MPa, 600°C enters a turbine operating at a steady state with a volumetric flow rate of 0.36 m3/sand exits at 0.1 bar and a quality of 92%. Stray heat transfer and kinetic and potential energy effects are negligible. Determine for the turbine (a) the mass flow rate, in kg/s, (b) the power developed by the turbine, in MW, (c) the rate at which entropy is produced, in kW/K, and (d) the isentropic turbine efficiency. Show this expansion process on a T-s diagram.
Water vapor at 6 MPa, 500°C enters a turbine operating at steady state and expands to 20 kPa. The mass flow rate is 3 kg/s, and the power developed is 2626 kW. Stray heat transfer and kinetic and potential energy effects are negligible. Determine: (a) the isentropic turbine efficiency and (b) the rate of entropy production within the turbine, in kW/K.
Air enters a diffuser operating at steady state at 540°R, 15 lbf/in.2, with a velocity of 600 ft/s, and exits with a velocity of 60 ft/s. The ratio of the exit area to the inlet area is 6.Assuming the ideal gas model for the air and ignoring heat transfer, determine the temperature, in °R, and pressure, in lbf/in.2, at the exit.
8Air enters the diffuser of a ramjet engine (schematic shown below) at 6 lbf/in.2, 420°R, with a velocity of 1800 ft/s, and decelerates essentially to zero velocity. After combustion, the gases reach a temperature of 2000°R before being discharged through the nozzle at 6 lbf/in.2 On the basis of an air-standard analysis, determine:(a) the pressure at the diffuser exit, in lbf/in.2(b) the velocity at the nozzle exit, in ft/s.Neglect kinetic energy except at the diffuser inlet and the nozzle exit. Assume combustion occurs at constant pressure and flow through the diffuser and nozzle is isentropic.
Water vapor enters a turbine operating at steady state at 500°C, 40 bar, with a velocity of 200 m/s, and expands adiabatically to the exit, where it is saturated vapor at 0.8 bar, with a velocity of 150 m/s and a volumetric flow rate of 25 m3/s.
Steam enters a nozzle operating at steady state at 20 bar, 263°C, with a velocity of 52 m/s. The exit pressure and temperature are 8 bar and 162°C, respectively. The mass flow rate is 2.9 kg/s. Neglecting heat transfer and potential energy, determine the inlet area in cm2.
At steady state, air at 200 kPa, 51.85°C and a mass flow rate of 4.02 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. At the duct exit, the pressure of the air is 100 kPa, the temperature is 82°C, the velocity is 255 m/s, and the cross-sectional area is 2 x 10-3 m2. Assuming the ideal gas model, determine the rate of entropy production within the duct, in W/K.
Liquid water flows isothermally at 20°C through a one-inlet, one-exit duct operating at steady state. The duct’s inlet and exit diameters are 0.02 m and 0.07 m, respectively. At the inlet, the velocity is 10 m/s and pressure is 1 bar.At the exit, determine the mass flow rate, in kg/s, and velocity, in m/s. m2 = ? v2 = ?
Air enters a horizontal, constant-diameter heating duct operating at steady state at 280 K, 1 bar, with a volumetric flow rate of 0.25 m3/s, and exits at 325 K, 0.95 bar. The flow area is 0.05 m2.Assuming the ideal gas model with k = 1.4 for the air, determine:(a) the mass flow rate, in kg/s,(b) the velocity at the inlet and exit, each in m/s, and(c) the rate of heat transfer to the air, in kW.