PROBLEM 4: Oil (SG=0.82) entering a pump through an 8- inch diameter pipe at 4 psi has a flow rate of 3.5 cfs. It leaves the pump through a 4-inch diameter pipe at 15 psi. Assuming that the suction and discharge sides of the pump are at the same elevation, find the horsepower delivered to the water by the pump (550 Ib.ft/s = 1 HP). Illustrate the problem and show your complete solution. *

PROBLEM 4: Oil (SG=0.82) entering a pump through an 8- inch diameter pipe at 4 psi has a flow rate of 3.5 cfs. It leaves the pump through a 4-inch diameter pipe at 15 psi. Assuming that the suction and discharge sides of the pump are at the same elevation, find the horsepower delivered to the water by the pump (550 Ib.ft/s = 1 HP). Illustrate the problem and show your complete solution. *

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Questions #1 The water system in a suburban area consists of old 9-inch pipeline 2,280 ft. long which conveys water from a pump to a reservolr whose water surface as 326 ft. higher than the pump. Water is pumped at the rate of 3.09 cfs. Determine the horsepower saved by replacing the old pipe with a new 12-inch pipe. Assume the values of f as equal to 0.050 and 0.012. respectively, for the old and new pipes. Neglect Losses of head except friction head. A. 38.17 B. 42.89 C. 50.27 D. 54.56 Questions #2 A new cast iron pipe must carry 3.945 mm/s at a head loss of 9.8 m per 4 km length of pipe. Compute the diameter of the pipe in m using Darcy Weishback Formula with f = 0.038. A. 1.98 B. 2.062 C. 1.744 D. 1.819
An industrial plant needs 1, 383,739 gallon ofwater per day which must be pumped from a laketo a height of 273 ft. through 1, 779 ft. of 11in. pipe with friction factor f=0.048.Consadering losses in the pump due to valvesand appurtenances equal to 5 times thevelocity head and the entrance loss equal to0.7 the velocity head, find the horsepowerrequired to deliver water needed. Choices:a.63.1 b.70.24 c .153.4 d. 183.45 subject- civil engineering- hydraulics
An industrial plant needs 1, 383,739 gallon ofwater per day which must be pumped from a laketo a height of 273 ft. through 1, 779 ft. of 11in. pipe with friction factor f=0.048.Consadering losses in the pump due to valvesand appurtenances equal to 5 times thevelocity head and the entrance loss equal to0.7 the velocity head, find the horsepowerrequired to deliver water needed. Choices: a.63.1 b.70.24 c .153.4 d. 183.45 subject- civil engineering- hydraulics Hint answers: letter B . 70.24, please show your solution
Show all problem solution's steps. Direct formula substitution solutions will have NO CREDIT POINTS. 1. A 75 mm diameter fire hose discharges water through a nozzle having a jet diameter of 25 mm. The lost head in the nozzle is 25% of the velocity head in the jet. If the pressure at the base of the nozzle is 625 KPa: compute the discharge in m3/min; the maximum horizontal range to which the stream can be thrown; the maximum vertical reach, and the diameter of the jet at a point two-third of the maximum vertical reach from the tip of the nozzle. Neglect air resistance.
5. An industrial plant needs 1336313 gallon of water per day which must be pumped from a lake to a height of 258 ft. through 1279 ft. of 12 in. pipe with friction factor f =0.027. Considering losses in the pump due to valves and appurtenances equal to 5 times the velocity head and the entrance loss equal to 0.6 the velocity head, find the horsepower required to deliver water needed. Round your answer to 2 decimal places.
A 12-inch by 6-inch Venturi meter is installed in a vertical pipeline carrying water as shown inthe Figure C. The flow is upward through the meter. A differential manometer containing fluid,with sp.gr 1.67, is attached to inlet and throat, the difference z in gage levels being 5.76 ft.Neglecting loss of head, write energy equation from inlet to throat of meter. Also write stepby step equation of the differential gage between inlet and throat and combine the twoequations to compute the discharge
Theflowrateofwaterthroughacastironpipeis5000GPM.The diameter of the pipe is 330mm, and the coefficient of friction is f=0.0173. What is the pressure drop over a 30m length of pipe
SHOW COMPLETE SOLUTION AND FINAL ANSWER INTO 3 DECIMAL PLACES 3. A large pipe called penstock in hydraulic work is 1.5 m in diameter. Here it is composedof wooden staves bound together by steel hoops each 300 mm2in cross sectional area, and is used to conduct water from a reservoir to a powerhouse. If the maximumtensilestress permitted in the hoops is 130 MPa, what is the maximum spacing between hoops under a head of water of 30m? Use density of water equal to 1000 kg/m3
Questions #1 A 60-inch (f = 0.02) man carrying 90 cfs branches at a point × into two pipes, one 1,000 ft. long, and 4 ft. in diameter (f = 0.022) and one 4,000 ft long and 2 ft. in diameter (f = 0.024) . Both pipes come together at a point y and continue as a single 60-inch pipe (f = 0.02) . Compute the rate of flow of the 4 ft diameter pipe. A. 112.98 cfs B. 82.98 cfs C. 102.98 cfs D. 92.98 cfs Questions #2 The discharge of the pipe system shown is 0.85 M/sec. The length of pipes 1, 2, 3, 4 and 5 are 1000 m, 500 m ,600 m, 800 m and 700 m, respectively. Pipes 2, 3 and 4 are laid parallel and drawn from pipe 1 and discharge into pipe 5. The diameters of pipes 1, 2, 3 and 5 are 90 cm, 50 cm, 40 cm and 75 cm respectively. The total head loss in the pipe is 10 m. Assuming f=0.02. A. 0.104 B. 0.014 C. 0.410 D. 0.129
oil (SG = 0.88) dischargesfrom a pipe (D = 13 in.) through a sharp-crested, round orifice (diameter = 5 in.), as shown. the coefficients of contraction and velocity are 0.619 and 0.967, respectively. find the actual velocity (in ft/s) in the jet. Point (1) is a point collinear with the orifice at point (2). Point (3) is the free surface of the manometer containing mercury. use h = 2.84 ft., and y = 7.42 in.
1. THERE IS A LEAK IN A HORIZONTAL 300 MMDIAMETER PIPELINE. UPSTREAM FROM THE LEAK TWOGAGES 600 METER APART SHOWED A DIFFERENCE OF140 ???. DOWNSTREAM FROM THE LEAK TWO GAGES600 METER APART SHOWED A DIFFERENCE OF 126??? . ASSUMING ? = 0.025. HOW MUCH WATER ISBEING LOST FROM THE PIPE. show answer in litre per sec
Oil (SG = 0.87) discharges from a pipe (D1 = 13 in.) through a sharp-crested, round orifice (D2 = 4 in.) as shown. The coefficients of contraction and velocity are 0.632 and 0.904, respectively. Find the actual discharge in the orifice in ft3/s. Use x = 7.8 in., y = 2.3 ft. Round off to four decimal places.