Q/ Describe a control system (as previous studied examples in lecture #1). Draw figure and block diagram for this system, then explain the following: • Output (Controlled variable) • Input (Reference value) • Controller • Actuator • Process (plant) • Sensor (measurement) • Is this system open loop or closed loop

Q/ Describe a control system (as previous studied examples in lecture #1). Draw figure and block diagram for this system, then explain the following: • Output (Controlled variable) • Input (Reference value) • Controller • Actuator • Process (plant) • Sensor (measurement) • Is this system open loop or closed loop

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter15: Solenoid Valves

Section: Chapter Questions

Problem 1SQ: Why is it important to understand the purpose and action of the total operational system when...

See similar textbooks

Similar questions

Hello Sir.Good Evening. I have a question in my home work related Control System Lesson. The following below is my question.Please advise, Thank you so much. "Give a control mechanical system and show how to get a transfer function of the system"
With reference to the schematic representation of a control system shown below, determine/define the following:1.) Control (controlled) variable
Control System Y=[ ]X+[ ]V??? Complete solving this question
Hello, I got question. In the closed loop control system given below, z is the zero of the controller. According to this; a. Maximum overshoot will be less than 5% and settling time less than 2 secondsDesign the controller accordingly.b. What type of controller is the controller you are designing (P, PI, PD, PID) andWrite down the parameters of this controller according to your calculations.c. Can the controller you design meet the required values in item a?Please explain.Thanks for answer.
Write a report on system control strategies and techniques used in engineering.
control systems question, step by step please.
control and system question can you solve step by step ?
Q about Control Systems. Looking for only SECOND question's answer
Why is it important to understand the purpose and action of the total operational system when working with controls?
Pneumatics problem 3. Aside from the examples given in the notes, give 3 more examples ofautomatic control systems using the close loop idea. 4. Aside from the examples given in the notes, give 3 more examples ofautomatic control systems using the open-loop idea.
Write any two (different) examples of controllers used in closed loop systems. Your examples of (a) closed loop systems, (b) the controllers used in it and (c) your reasons, how it works as ‘controller’ ? are to be explained.
In diagram provided 3a shows an air conditioning system as an open-loop system. Figure 3b shows the system with closed-loop proportional control. Finally, Figure 3c shows the closed-loop system with PD control. Described image Figure 3 (a) Open-loop system; (b) Closed-loop system with proportional control; (c) Closed-loop system with PD control You are given the task as a control engineer to design a closed-loop controller for this air conditioning unit so that it has the following properties: Maximum overshoot: 10% Maximum time to reach 99% of steady state: 10 seconds Maximum steady-state error: 10% Please find the values of the gain, natural frequency and damping coefficient of the open-loop system to two places after the decimal point. Does the open-loop system conform to the design constraints?