Q. 1 Two pitot tubes are installed in the pipe of 300 mm diameter carrying water, one on the centreline and the other 75 mm from the centreline (as shown in Fig. 1). If the velocities at the two points are 3 m/s and 2 m/s respectively calculate the reading on the differential mercury manometer connected to the two tubes. 3 m/s 2 m/s Fig. 1

Q. 1 Two pitot tubes are installed in the pipe of 300 mm diameter carrying water, one on the centreline and the other 75 mm from the centreline (as shown in Fig. 1). If the velocities at the two points are 3 m/s and 2 m/s respectively calculate the reading on the differential mercury manometer connected to the two tubes. 3 m/s 2 m/s Fig. 1

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Answer is: V = 14.17 ft/s
Water is flowing at a rate of 12 ft^3/s, and it is assumed that the head loss from the reservoir to the gage is equal to twice the velocity head in the 12-in pipe. What power must the pump supply in HP to allow this flow?
The figure shows a siphon that is used to draw waterfrom a large open tank. If the absolute vapor-pressureof the water is pv = 1.23 kPa. (a) determine the shortest drop length L of the50-mm-diameter tube that will cause cavitation in thetube. Show all your calculations. (b) Also draw the energy and hydraulic grade lines forthe length of the tube. Be sure to indicate the pressureheads, elevation heads, and dynamic heads. And toshow all your calculations.
Water at 10°C is flowing from point A to point B through the fabricated section shown below at the rate of 0.37 m3/s. If the pressure at A is 66.2 kPa, calculate the pressure at B. answer should be 34.9 kPa
Water flows out of a faucet at A at 6 m/s. Determine thevelocity of the water just before it strikes the ground at B
Q1: In a venturemeter used for measuring the flow ofoil (-0.85) through a horizontal pipeline, the pipe diameter is 2.4 times the diameter at the throat. Connections are made from the entrance to the meter and the throat to a vertical L tube containing mercury If the difference level between the fluids in the U - tube arms is (x +) in em, where S.N. is student serial number. Neglect friction in the pipe. Find an expression in terms of x for the velocity of the oil in the pipe.
Determine the manometer reading as shown in thefigure, when the velocity of fluid flowing through a75mm diameter pipe is 0.6 m/sec.
A hemispherical tank of diameter 4 m contains water up to a height of 2.0 m. An orifice of diameter 50 mm is provided at the bottom. Find the time required by water (i) to fall from 2.0 m to 1.0 m (ii) for completely emptying the tank. Take Cd= 0.6
An unknown gas is flowing through a venturi meter whose diametersas shown. Gage pressures are measured 12.2 psia at the entranceand 11.8 psia at the throat. Take the density to be 0.105 lb/ft3.Determine the following: A) Neglecting friction, the volume flow rate of airB) If the pressure gauge is replaced with a manometer withmercury as its medium (SG=13.6), what will be the height ofthe mercury in inches? Draw the most possible orientationof the manometer and its fluid height.
An unknown gas is flowing through a venturi meter whose diametersas shown. Gage pressures are measured 12.2 psia at the entranceand 11.8 psia at the throat. Take the density to be 0.105 lb/ft3.Determine the following: a) Neglecting friction, the volume flow rate of air b) If the pressure gauge is replaced with a manometer withmercury as its medium (SG=13.6), what will be the height ofthe mercury in inches? Draw the most possible orientationof the manometer and its fluid height.
A pump test for air flow is set up as shown below in which the pump draws air from the atmosphere into the 1-ft diameter pipe. The liquid in the differential manometer is water (? = 62.4 ?b/??^3) and the density of air is 0.00238 ?lug/??^3. Assume that the air flow is incompressible and frictionless. (a) Using the piezometer tube, compute the pressure in the pipe. (b) Using the Pitot tube and an energy equation, compute the velocity in the pipe. (c) Assuming that the air far away from the entrance to the pump is at rest (zero velocity), calculate the power delivered by the pump.
The three reservoirs system contains water. If L1 = 2000 m, f 1= 0.013, D1 = 1m; L2 = 2300 m, f2 = 0.02, D2 = 0.60m; and L3 = 2500 m, f = 0.023, D3 = 1.20m. Compute Q3 in m3/s.