Q.1 Calculate Efficiency of the system, the net Work transfer & Heat rejected to sink for a Carnot cycle operates between sources and sink temperatures of 285 °C and – 11 °C. If the system receives 100 kJ from the source. A 53.04%; 53.04 kJ; 46.95 kJ 55.52%; 55.52 kJ; 47.68 kJ C 45.88%; 45.88 kJ; 44.44 kJ D 63.05%; 63.05 kJ; 50.35 kJ

Q.1 Calculate Efficiency of the system, the net Work transfer & Heat rejected to sink for a Carnot cycle operates between sources and sink temperatures of 285 °C and – 11 °C. If the system receives 100 kJ from the source. A 53.04%; 53.04 kJ; 46.95 kJ 55.52%; 55.52 kJ; 47.68 kJ C 45.88%; 45.88 kJ; 44.44 kJ D 63.05%; 63.05 kJ; 50.35 kJ

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Thermodynamics (Carnot Cycle) An OTEC power plant has an efficiency of 2.5%. The difference in temperature of teh warm surface water (hot source) and cold deep-water (sink) is 7.5℃. Assuming powerplant is operating in a Carnot Cycle, find the temperature of the sink in ℃. Options: a. 11.5 b. 12.5 c. 13.5 d. 14.5 e. 15.5 f. 16.5 g. 17.5 h. 18.5 i. 19.5 j. None of the above
In a gas turbine plant working on air standard Brayton cycle, the air at inlet is at 27°C temperature ,0.1 MPa pressure respectively.The pressure is 6.25 and maximum temperature is 800° C the turbine and compressor efficiencies are each 80%. Find per kg of air; i) The compressor work ii)The turbine work iii) The cycle efficiency iv) The turbine exhaust temperature
Pls answer thank you! The following data were obtained during performance test with a simple open cycle gas turbine engine: compressor inlet temperature, 520*R: compressor isentropic discharge temperature, 672"R: actual compressor discharge temperature, 691"R: turbine inlet temperature, 1500 R: turbine isentropic discharge temperature. 1184"R: and turbine actual discharge temperature, 1216°R. For these conditions calculate the thermal efficiency in percent.
A Carnot cycle operates between source and sink temperatures of 260°C and – 17.8°C. If the systemreceives 100 kJ from the source, find (i) efficiency of the system, (ii) the net work transfer, (iii) heatrejected to the sink.
write legibly pls A simple gas-turbine operates with air as the working fluid, a pressure ratio of 18:1 and a maximum temperature of 700°C. The air enters the compressor at 100kPa and 20°C. Determine: a. Thermal Efficiency of the cycleb. The heat addedc. The state of the air exhausted by the turbine
p103#4. two and one-half pounds of air actuate a cycle compes of the following processess: polytropic compression 1-2, with n=15; constant pressure 2-1; constant volume 3-1. the known data are p1=20psia, t1=100degree F, QR= -1682 Btu. determine (a) T2 and T3, (b) the work of the cycle using the pV plane,in Btu; (c) QA, (d) the thermal efficiency and (e) pm
Thermodynamics (Carnot Cycle) An OTEC power plant has an efficiency of 2.5%. The difference in temperature of teh warm surface water (hot source) and cold deep-water (sink) is 7.5℃. Assuming powerplant is operating in a Carnot Cycle, find the temperature of the hot source in ℃. Options: a. 21 b. 22 c. 23 d. 24 e. 25 f. 26 g. 27 h. 28 i. 29 j. None of the above
Complete the Carnot cycle performed by air if the parameters in points 1 and 3 are the following: Point 1: P_1=2MPa, T_1=600kPoint 3: P_2=120 KPa, T_2= 300K R=287 J/(Kg K)-air only. Please type answer no write by hend.
In an air standard Brayton cycle the air enters the compressor at 0.1 MPa, 25 ∘C. The pressure leaving the compressor is 1 MPa. and the maximum temperature in the cycle is 1200 ∘C. Assume a compressor efficiency of 80%, a turbine efficiency of 85%, and a pressure drop between the compressor and turbine of 30 kPa. Use the PG model. a) Determine compressor work (w_C), b) Determine the turbine work (w_T), c) Determine the cycle efficiency (n_th,Brayton).
A rankine turbo-generator unit receives 27,000kg/hr. of steam at 1.20 MPa and superheated by 122 degrees. condensate leaves at 22 degree celsius, for brake steam rate WB= 4.74 kg/kwhr, mechanical efficiency of 90% and generator efficiency = 94%. Determine the A) ideal work B) Work net C) Ec, cycle thermal efficiency D) W indicated E) indicatedsteam rate F) Indicated engine efficiency G)turbo generator output in KW(Wk)
Refrigeration is desired at a Temperature of -5.6°C (minus 5.6 degrees C). Heat is rejected at atemperature of 36.7°C (36.7 degrees C). Using the Carnot Cycle, determine the coefficient ofperformance (COP), for both as a refrigeration and as a heat pump.MUST show all steps. MUST show units in each step.
A 136 kg/s steam with an inlet condition of 52 bar, 400 C enters a rankine turbine and expands to 36 kPa. determine the work, the thermal efficiency, and the steam rate (a) for the cycle, (b) for the turbine. (c) With the same specifications, consider the steam expanded on an actual turbine and the brake steam rate is 4800 g/kwh and the driven electric generator has an efficiency of 0.93. Find Brake Thermal Eff, Brake Engine Eff, Combined Work, and quality or temperature of actual exhaust steam