Q1/ For the hydraulic jack shown in Figure. Assume the specific weight of the liquid in the jack is 9810 N/m3.
Q: 1. If the gauge pressure of the air in the tank is known to be 20kPa. Determine the pressure in the…
A: Gauge pressure of Air, PAir=20 kPa=20*103 Pah1=10 cm=0.10 mh2=70 cm=0.70 mSpecific gravity of…
Q: Problem 4: The U-tube manometer is also widely used to measure the difference in pressure between…
A: Givenpipe A is filled with the diesel fuel has specific gravity γdiesel fuel =8.326KN/m3pipe B is…
Q: reading shown? For the 6 psi. The fluid in both pines A and B is water
A: we will use the equation of inclined tube manometer PA+γ1h1γ2I2 sinθ-γ3h3 =PB
Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 43 psi. The…
A:
Q: b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32…
A: ◆ The mean effective pressure: 562.94 kPa. ◆ The indicated power developed by the engine: 4.10 kW.
Q: A cargo truck with a weight of 289 kN was raised using a hydraulic press. If oil acts on a piston…
A: Correct answer: 1148.62 kPa
Q: Oil with a specific weight of 8.64 KN/m flow from A to B through the system shown in the figure…
A:
Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00221 N/cm2…
A: Given: pi - po = 0.00221 N/cm2 σ = 0.075 N/m
Q: The diameter of the plunger is 18 mm and its weight is 616 grams. If the deadweight atop the piston…
A: Given Datad=18mmW=616gramDw=10kgsHydraulic gauge pressureP=?
Q: A 500kg bucket is lifted by a crane at a certain position shown below. What is the magnitude of the…
A: Given data: Mass of bucket, m = 500 kg. Calculate the weight of the bucket, W=mg=500 kg×9.81…
Q: b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32…
A:
Q: Give an example of Lifting of a large weight by a small force by the application of Pascal’s law. A…
A: According to Pascal law pressure on the enclosed fluid is transmitted throughout the fluid with…
Q: chain wit RS=102.3m
A:
Q: Problem 5: The water on the reservoir side of a dam has a depth of 220 meters (this would be typical…
A:
Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 35 psi. The…
A:
Q: Q15: In Figure below, calculate Fx and Fv per unit width of the cylinder to 1.5 m cylinder Water 35
A: solved
Q: Q2/ Hydraulic cylinder is used to lift cars weighing 75 kN for 550 mm in 6 sec. The ratio of…
A: Given Data The weight of the car is:W=75kN The distanc of lift is:h2=550 mm=0.55m The time is:t=6 s…
Q: 10. A thin – walled spherical tank is filled with water at a pressure 4666 psig. The tank's volume…
A: Pressure, P1= 4666 psig Volume, V1= 805.407 in3 After the water is released form the tank, the…
Q: Q1/ For the hydraulic jack shown in Figure. Assume the specific weight of the liquid in * .the jack…
A: S=Specific Weight of the liquid=9810 N/m3d=Diamter of Smaller Piston=30 mm=0.03 mD=Diamter of Large…
Q: Q5) Using a system similar to that shown in figure, compute the required air pressure above the…
A: Given data h1 = 0.3 mh2 = 5 mWe have to find the air pressure required to cause the jet to rise to…
Q: The figure below represents the working principle of an industrial pressure gauge. The cylinders and…
A:
Q: 6. A portable floor crane in a garage is used to lift a 100 kg engine; see Fig. 6. For the position…
A:
Q: Figure 2 shows a hydraulic diagram used in loading and unloading materials from ships in Sohar…
A: Analysis of Hydraulic circuit and the functions of each part
Q: The pressure at the suction of the pump reads 8 psi vacuum, while at the discharge is 41 psi. The…
A: Write the given data. P1=-8 psi+14.7 psi=6.7 psia=46.2 kPaP2=41 psi+14.7 psi=55.7 psia=384…
Q: A 10 ft by 15 ft rectangular cistern (storage tank for rainwater) has its top 30 ft below ground…
A: Calculus is frequently used to determine the amount of labour required to empty a tank of the…
Q: 3. A gas is under pressure of 40 bar abs at 40°c. a. Compute the pressure in kPa b. Compute the gage…
A:
Q: Diagram of the problem, necessary formulas, clearance and numerical solution It is planned to lift…
A:
Q: 8. As shown in the figure below, oil is inside the hydraulic press with SG=0.82. What force F is…
A:
Q: A hydraulic press is used to raise an 80 - kN cargo truck. If oil of sp. gr. 0.82 acts on the piston…
A: Given data, F= 80 KN Sp. gr =s= 0.82 So ρ= 0.82*1000= 820 kg/m2 Pressure P= 10 MPa= 10 N/mm2…
Q: An open vessel contains water up to a depth of 5.34 m and above it an oil of SG = 0.8 for a depth of…
A:
Q: A gate is used to hold water as shown in the figure, Ignore the weight of the gate and the friction…
A:
Q: A 15° inclined manometer containing mercury is connected to two taps A and B containing water. Tap B…
A:
Q: 4. Compute the pressure different between 'M' and 'N’ for the system shown in figure. -S = 0.92 M.…
A:
Q: gure, fluid A has a specific gravity of 0.90 and fluid B has a specific gravity of 3.00. Determine…
A: Given:sA=0.90sB=3
Q: Q1/ For the hydraulic jack shown in Figure. Assume the specific weight of the liquid in the jack is…
A:
Q: 4. The air-oil-water system shown in the figure is at 90°F. If gage A reads 16.1 psi abs and gage B…
A:
Q: 4. A fan is used to provide ventilation in a tunnel requires a 3-kW electric motor to deliver 360…
A:
Q: press has a diameter ratio between the two pistons of 8:1. The diameter of the larger piston is 600…
A: Given:D:d=8:1D=0.6 md=0.68 =0.075 mm=3500 Kgs=0.8
Q: hat can be lifted if the output piston has a diameter of 1 foot? Assume 80% efficiency of the…
A: P1 = P0 + ρ gd+ F1A1P2 = P0 + ρ g d + F2A2 P1 = P2F2A2 = ρ g d + F1A1
Q: Q1(b) A multi fluid manometer is shown in Figure Q1(b). Determine the following: (i) Determine…
A:
Q: 5. Flow occurs over a spillway (Figure). Determine the horizontal force on the spillway per foot of…
A:
Q: A hydraulic pump delivers 13.5 litres per minute towards pressure of 310 bar.Find the following…
A: Discharge through the pump, Q=13.5 Lit/min=13.5*10-360=2.25*10-4m3/s Pressure across pump, ∆P=310…
Q: 6. A portable floor crane in a garage is used to lift a 100 kg engine; see Fig. 6. For the position…
A:
Q: The 500-kg load on the hydraulic lift shown in the figure on the right is to be raised by pouring…
A: Given :- Load on hydraulic lift (L) = 500 kg × 9.81 m/s2 Load on hydraulic lift (L) = 4905 N To…
Q: Q11: Find the SPECIFIC GRAVITY of the OIL GOn in the Tank shown in Figure 10, if the pressure at…
A: Given Data: The pressure at point D is PD= 21 kN/m2. The value of a=1 m, b =0.4 m, c =0.4 m and d…
Q: Q1) Using a system similar to that shown in figure, compute the required air pressure above the…
A: Find the pressure in the tank.
Q: 4) The diameters of the pistons shown in Fig. below are D1= 3 in and D2= 1.5 in. Determine the…
A:
Q: For the configuration shown in Figure 5, calculate the weight of the piston if the gauge pressure…
A: Specific gravity of oil, SG=0.86 Diameter of piston, D=1 m Position of gauge above the piston, h=1 m…
Q: The pump in figure below draws water from a reservoir at point A. In the suction pipe an open…
A:
Q: 3. A rigid container is partly filled with a liquid at 1520 kPa. The volume of the liquid is 1.232…
A: Given Pressure, P1 = 1520 kPa P2 = 3039 kPa Volume, V1 = 1.232…
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 3 images
- The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.A gas under a pressure of 1 MPa absolute has a specific weight of 99 N/m^3. What is the value of R for the gas if T = 60°C?A cargo truck with a weight of 325 kn was raised using a hydraulic press. If oil acts on a piston with 412 mm diameter. Determine the pressure in kpa under the piston.
- 2. A 3,000 gallon tanker is carrying industrial alcohol (donaity-48 23 D. /h) finteBurton to the Selene Building. Find the weight (N) of the industrial alcohol if the tanker is67% full. (Round to nearest whole number)A hydraulic lift is to be used to lift a 5000-lb weight by putting a weight of 50 lb on a piston with a diameter of 0.50 ft. Determine the diameter of the piston on which the weight is to be placed.Make it short and simple. [1] A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of 6 kg and cross-sectional area of 30 cm2. A compressed spring above the piston exerts a force of 50 N on the piston. If the atmospheric pressure is 99 kPa, determine the pressure inside the cylinder.
- Fluid mechanic: Q1) Two square gates close two openings in a conduit connected to an open tank of water as shown. When the water depth, h, reaches 5 m it is desired that both gates open at the same time. Determine the weight of the homogeneous horizontal gate and the horizontal force R acting on the vertical gate that is required to keep the gates closed until this depth is reached. The weight of the vertical gate is negligible, and both gates arehinged at one end as shown. Friction in the hinges is negligible.The device shown is the buoyancy measurement device used to measure the liquid height change. A pressure sensor is installed at the bottom of the tank, and a force sensor is installed to measure the upward force on the horizontal lever. The distances to the pivot point from the force sensor and cylinder are X1 and X2, respectively. The reference pressure at the reference liquid height, h0, to the bottom of the cylinder is pref. (4) If the force measured by the force sensor is Fsensor = 7.53 N, X1 = 1.58 m, X2 = 0.17 m, the diameter of the cylinder is D = 0.05 m, and the specific weight of the liquid is γf = 8.70 kN/m3, calculate the liquid height difference, Δh, relative to the reference height h0. __________ m.draw or make the FBD A test tube standing vertically in a test tube rack contains 2.5 cm of oil (ρ =0.81 g/cm3) and 6.5 cm of water. What is the gauge and absolute pressure on the bottom of the test tube? A 10kg block of Aluminum (ρ = 2700kg/m3) is attached to a rope. a. What is the tension force in the rope if the block is in a vacuum?b. What is the tension force if the block is in air (ρ = 1.29kg/m3)c. What is the tension force if the block is in water (ρ=1,000 kg/m3) A downward force of 100 N is applied to the small piston with a diameter of 50 cm in the hydraulic lift system shown below.a. What is the upward force exerted by the large piston with a diameter of 2m?b. What is the mechanical advantage of this hydraulic lift?c. If the input force of 100N pushes the small piston down by 2m, how high will the large piston rise? Water flows through a circular pipe with a constant radius of 10cm. The speed and pressure at point A is 4m/s and 250,000Pa respectively.a. What is the speed…
- What is the altitude an airplane is flying if the measured air pressure is 640.12471304150 psf? Assume standard condition.The pressure of water in a pipeline was measured by means of a simple manometer containing mercury. The mercury level in the open tube is 160 mm higher than that of the left tube. The height of water in the left tube is 43mm. Determine the static pressure in the pipe in a).kN/m2. b) Head of water in meters, 1: The static pressure in the pipe in kN/m2 ? 2: Head of water in meters ?What height of mercury column is equivalent to 1000 kPa? The density of mercury is 14000 kg/m3.