Q1): The concentration of salt is given as a function of time by: de -=37.5-3.5x dr at the initial time (t =0)., the salt concentration in the tank is (50 g/L). Using Euler's method find the salt concentration for the condition : (choose only one ): a-after (3) minutes and step size( h=1) minutes.

Q1): The concentration of salt is given as a function of time by: de -=37.5-3.5x dr at the initial time (t =0)., the salt concentration in the tank is (50 g/L). Using Euler's method find the salt concentration for the condition : (choose only one ): a-after (3) minutes and step size( h=1) minutes.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

There's 1 drink (and you are asked to determine the glucose concentration in the drink in the units of g/100mL. (Why these units? Well, once you have the concentrations in g/100mL you will be able to compare your values with the nutritional values given on the drink bottles’ labels). The sample of the drink was diluted 1/100 (i.e. by a factor of 100). This was an essential step in the method because, without it, the machine used to analyse the glucose concentration (spectrophotometer) would have given an error as the concentration would have been too high for accurate detection. What this means for you is that the dilution factor will need to be taken into consideration in your calculations (remember the aim is to calculate the concentration in the original drink and not in the diluted drink). You measured the concentration of their diluted drink using the spectrophotometer and their results were provided to them in the units mM (millimolar). Glucose Concentration in mM of drink =…
In aqueous solution, chlorine dioxide oxidizes iodide ion to iodine and chlorine dioxide is reduced to chlorite ion. 2ClO2 (aq) + 2 I- (aq) ----> 2ClO2- (aq) + I2 (aq) The concentration in molarity, of ClO2 was measured at various time points. The data was plotted and the plot of [1/[ClO2] versus time in seconds was most linear. The linear regression equation for the plot is y= 7.60x10-2 (t) + 2.353. What is the concentration of ClO2 at 2.00 minutes if the initial concentration of ClO4 ia 0.425 M? a.) 0.0872 M b.) 2.50 M c.) 11.5 M d.) 0.399 M
General Chemistry for Engineers Lesson: Chemical Kinetics Directions: Answer the following problems by showing the complete solution. In return, I will give you a good and high rating. Thank you so much! Note: Please input the units and measurements in the calculations. Thank you so much! Number 19 and 20
Using the data for Trials 1-3, enter the average time for the Clock reaction at room temperature: ................ s
The student then determined ΔH neutralization for the reaction of sodium hydroxide and acetic acid, using the procedure described in this module. The student added 100.0 mL of 0.8500M NaOH to 100.0 mL of 0.8404M acetic acid. Prior to and following the mixing of the acid and base solutions, the following temperature-time data were collected. g) Identify the limiting reagent and briefly explain why it is limiting. h) Find ΔH neutralization for the reaction.
Please answer fast it’s very important and urgent I say very urgent so please answer super super fast please For the image attached For 1. a Mass of metal: Trial 1 is 35.0228 g Trial 2 is 35.0915 g Trial 3 is 34.0821 g Mass of water: Trial 1 is 20.0177 g Trial 2 is 20.0250 g Trial 3 is 20.0168 g For delta t of water: Trial 1 is 15.5 C Trial 2 is 15.7 C Trial 3 is 15.1 C For delta t of metal Trial 1 is 80.1 C Trial 2 is 80.2 C Trial 3 is 79.5 C For B my calculated Specific heat is: Trial 1 is 0.462 Trial 2 is 0.467 Trial 3 is 0.466
The answer is D, please show steps, thanks.
I need help with calculations i need help by step by step show the work please Below is a simple set of weights obtained while immersing potato slices in various sugar solutions over 30 minutes. a. For each solution, calculate the rate of weight change over this 30-minute period. . Once you calculate these rates - . Write your answer in standard notation and use 3 digits past the decimal point - e.g. 0.005, 0.030. (Note that the last zero in an answer is considered to be a digit). 0.0 M sucrose = ____________________ g/min 0.4 M sucrose = _____________________ g/min 0.6 M sucrose = _____________________ g/min 0.8 M sucrose = _____________________ g/min 1.0 M sucrose = _____________________ g/min
NH4+ {aq) + NO2(aq) -> N2(g) +2H2O{l} Data Initial [NH4+] Initial [NO2-] rate 1 0.0100 0.200 5.4 x10-7 2 0.0200 0.200 10.8x10-7 3 0.0400 0.200 21.5x10-7 4 0.200 0.0202 10.8x10-7 5 0.200 0.0404 21.6x10-7 6 0.200 0.0808 43.3x10-7 Find x,y,k
COMPLETE SOLUTION with given and required ASAP You will be defining a new temperature scale in oX, in which the freezing and boiling points of water areone-hundred degrees X and one-thousand fifty-five oX, respectively. Correlate this to Celsius orFahrenheit scales. The oX reading on this scale is a certain number of degrees on a correspondingabsolute temperature scale. What is the corresponding absolute temperature at 0oX?
A new method for the determination of cholesterol in serum is being developed in whichthe rate of depletion of oxygen is measured with an oxygen electrode upon reaction of thecholesterol with oxygen, when catalyzed by the enzyme cholesterol oxidase.a. Use Q-test and Grubb’s Test in determining if the extreme values (higher andlower) are outliers.b. Compute for the value of mean, standard deviation, and RSD for the data set (after rejectingany outliers from the Grubb’s test)
Benzene is dissolved at a constant initial concentration of 350 mg/l and is contained within a landfill in leachate water above bottom liner of the landfill system. It starts to diffuse through the liner at time t = 0. Using Equation Ci (x,t) = Co erfc x/ 2(D*t)0.5 related narrative, and (error function table), calculate the concentration of benzene at its breakthrough location as it diffuses through a 1.5 meter thick liner (x=1.5 meters represents breakthrough location where liner fails of contaminant is released), after 50 years. Assume D = 10-5 m2/sec (diffusion coefficient in free standing water) and w = 0.7 (coefficient of tortuousity). Clearly present your assumptions and your value of erf, Select the answer range which best fits the answer you calculate. Group of answer choices 315 to 350 mg/l My answer is not in the range of any of the choices my answer. 215 to 314 mg/l 175 to 200 mg/l 370 to 400 mg/l