Q2// The four-cylinder engine of a light truck owned by a utility company has been converted to run on isobutene (C,H10) fuel. A dry analysis of the engine exhaust gives the following volumetric percentages: CO,= 7.9%, CO= 8.1%, 02=1.23% Calculate the equivalence ratio at which the engine is operating.

Q2// The four-cylinder engine of a light truck owned by a utility company has been converted to run on isobutene (C,H10) fuel. A dry analysis of the engine exhaust gives the following volumetric percentages: CO,= 7.9%, CO= 8.1%, 02=1.23% Calculate the equivalence ratio at which the engine is operating.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Cereal is being dried in a vertical drier by air flowing countercurrent to the cereal. To prevent breakage of the cereal flakes, some of the exit air from the drier is recycled back to mix with the the moist fresh air. For each 1000 kg/hr of wet cereal fed to the drier, calculate the input of moist fresh air in kg/hr and recycle rate in kg/hr. The available data on stream compositions is (fractions): For water: Fresh air: 0.0132 Wet cereal: 0.200 Exit air: 0.263 Dried Cereal: 0.050 Air entering Dryer: 0.066
What is the Molecular weight of a certain volatile liquid which is placed in 225 g flask which has total capacity volume of 252.17 mL. After the liquid was heated to 96.7 oC the gass volatilized and the weight of the flask measure 227.33g. What is the could be the MW of the volatile sample?
Nitrogen is to be liquefied in a simple Linde process. The feed and recycle are mixed. compressed to 64 bar, and precooled to 135K. The vapor then passes through a heat exchanger for additional cooling before beinng throttled to 1 bar. The unliquefied fraction leaves the seperator at the saturation temperature and passes through the heat exchanger, then exits at 120 K. a. What fraction of the gas is liquefied in the process? b. What is the temperature of the high pressure gas entering the throttle valve?
1) A tank is filled with oil whose density is 0.85 g/cm?. If the volume of the tank is 2 m?, determine the amount of mass (in kg) in the tank. 2) Determine the kinetic energy required to accelerate a 900 kg car shown in the Figure from rest to a velocity of 80 km/h in 20 s on a level road. 80 km/h m= 900 kg 3) A rigid tank (stationary) contains a hot fluid that is cooled while being stirred by a paddle wheel. Initially, the internal energy of the fluid is 800 kJ. During the cooling process, the fluid loses 500 kJ of heat, and the paddle wheel does 100 kJ of work on the fluid. Determine the final internal energy of the fluid. Neglect the energy stored in the paddle wheel. 4) Determine the absolute pressure (in bar) in a tank when a pressure gage connected to a tank reads 3750 Torr. Pabs 3570 Tor Patm = 94 kPa
An open vessel containing liquid water stands in a sealed room measuring 5.0m wide x 4.0m long x 3m high. The temperature of the room is 320K and, over time, some of the liquid water evaporates. Eventually, the liquid water level in the vessel stops changing. a) How many grams of water will be in the humid air within the sealed room? b)A contact lens cleaning system on the market uses an aqueous hydrogen peroxide solution to disinfect the contact lenses. In a few hours, the hydrogen peroxide decomposes to liquid water and oxygen gas in a catalyzed reaction. The vessel in which the reaction occurs has a hole in the top. Use chemical potential to explain how the equilibrium concentration of hydrogen peroxide would be affected if the hole was not present.
L-lysine is produced by Corynebacterium glutamicum in a bioreactor using glucose as the carbon source and ammonia as the nitrogen source. All streams of this process are aqueous. In the inflow, 8 grams of glucose per 100 grams of flow fluid flowing at a rate of 500 kg / hour is included. The glucose flow rate in the exit steam is 1 kg / hour. The reaction takes place at 25 °c.What is the mole percentage of glucose that was consumed during cell growth inside the bioreactor? -Does the growth of Corynebacterium glutamicum cells inside this bioreactor release or absorbheat? Should heat be supplied to the bioreactor, or removed from, to maintain the operation temperature? I want the solution of both options.
Downvoted for wrong solution. A river is carrying water containing 2000 mg/l Magnesium Chloride into a small lake. The lake has a naturally occurring Magnesium Chloride of 50 mg/l. If the river flow is 2500 Lmin and the lake flow rate is 1.5 m³.sec¹, what is the concentration of MgCl2 in the lake after the discharge point? Assume that the flows in the river and lake are completely mixed, that the salt is a conservative substance, and the system is at steady state.
Liquid benzene is contained at 298K in a 2 cm diameter glass tube and maintained at a level 5 cm below the top of the tube, which is open to atmosphere. The following properties of benzene are given: 1) Boiling temperature is 353K at 1 atm. 2) MW of benzene is 78.108 kg/kmol. 3) hfg is 393 kJ/kg at 353K. 4) Density is 879 kg/m^3 5) Diffusivity rate (D) is 0.88x10^-5 m^2/s at 298K. Determine the following: A) The mass evaporation rate of benzene knowing that Psat is 0.145 atm and Yf at infinity is zero B) How long does it take to evaporate 0.5 cm^3 of benzene
23 ft^3 of air was drawn from a ventilation duct and measured by means of a dry gas meter. the meter's temperature averaged 60 F and the meter gage pressure was -1.9" H2O. Barometric pressure during the sampling was 752 mm Hg. Calculate the volume in standard cubic feet and in standard cubic meter (25C, atm) this is an ideal gas problem
The interfacial energy γoil-water of an oil – water interface at 25 oC is 53 mJ/m2. The surface tension of the oil is 25 mN/m and that of water is 72.5 mN/m at 25 oC. (a) Calculate the spreading coefficient. Does the oil spread on water at 25 oC? (b) When carboxylic acid is dissolved in the oil, γoil-water is reduced. We may assume that acid addition only affects γoil-water, which decreases linearly with acid concentration (dilute solution). It is observed that spreading of the oil occurs when the acid concentration in greater than 0.005 mol/L. Calculate the adsorption isotherm Γ versus C for adsorption of acid at the interface, and the area occupied by each acid molecule at the interface at the onset of spreading.
Mrs S has severe urticaria. The prescriber has requested 500g of 2% w/w calamine in aqueous cream. You have 5% w/w calamine in aqueous cream in stock. You decide to prepare this product by extemporaneous dilution using aqueous cream as the diluent. How many grams of 5% w/w calamine in aqueous cream is needed to make 500g of 2% w/w calamine in aqueous cream? units – g
Table 1 below shows the data for the filtration of fruit juice to produce clarified fruit juice at 298.2 K. Table 1: Total volume of filtrate collected at certain time V * 103 (m3) t (s) 0.5 17.3 1.0 41.3 1.5 72.0 2.0 108.3 2.5 152.0 3.0 201.7 The filtration process was conducted at a constant pressure of 46.2 kN/m2. The area of the plate-and-frame the press was 0.0439 m2, and the pulp concentration was 23.47 kg solid/m3 filtrate. a) Convert the data in Table 1 into a graph. You can either use Excel or graph paper. Your graph should be self-explanatory. b) Using the graph in (a), estimate the specific cake resistance and the resistance of the filter medium to filtrate flow.