Q2 : The three bars shown in fig are pined at point B which carry a loadP and fixed at points A, C and D. The length of the three bars AB, BDand CB is (L) . The cross section area for each bar is Aj except the barwhich has different cross section area of A2 . All three bars have thesame young modulus E. Determine the axial force in each of the bars.СВ

Answered: Image /qna-images/answer/caa433a6-cd5c-440f-a7d4-2250ebe75ae5.jpg

Q2 : The three bars shown in fig are pined at point B which carry a load P and fixed at points A, C and D . The length of the three bars AB, BD and CB is (L) . The cross section area for each bar is A, except the bar CB which has different cross section area of A2. All three bars have the same young modulus E. Determine the axial force in each of the bars. B PV

Q2 : The three bars shown in fig are pined at point B which carry a load P and fixed at points A, C and D . The length of the three bars AB, BD and CB is (L) . The cross section area for each bar is A, except the bar CB which has different cross section area of A2. All three bars have the same young modulus E. Determine the axial force in each of the bars. B PV

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.63P: The cable of the suspension bridge spans L=140m with a sag H=20m. The cable supports a uniformly...

See similar textbooks

Similar questions

The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016, determine the force F required to advance the bar at a constant speed.
The structure is supported by a pin at C and a cable attached to A. The cable runs over the small pulley D. Find the internal force systems acting on sections 1 and 2.
The cable of the suspension bridge spans L=140m with a sag H=20m. The cable supports a uniformly distributed load of w0 N/m along the horizontal. If the maximum allowable force in the cable is 4 MN, determine the largest permissible value of w0.
Two separate cables AC and BC support a sign structure of weight W = 1575 lb attached to a building. The sign is also supported by a pin support at O and a lateral restraint in the '-direction at D. (a) Find the tension in each cable. Neglect the mass of the cables. (b) Find the average stress in each cable if the area of each cable is Ae= 0.471 in2.
A horizontal board weighing Wb = 600 N is hinged to a vertical wall. A personweighing Wp = 400 N stands at the end of the board 5 m from the wall. A rope is attached to theboard at a point 3 m from the wall and makes an angle of θ = 40° with theboard. Determine the tension (T) in the rope
A uniform bar 3.00 m long is held by ropes at the ends making angle 60.0 and 30.0,respectively, with the horizontal. A weight of 200 N is hung 0.500 m from the leftend where the 60.0 rope is attached. Find the tension in the ropes (T1 & T2) andthe weight (W) of the bar
The triangular block shown in the figure is subjected to the loads P = 1600 lb. and F = 600 lb. If AB = 8 in and BC = 6 in., resolve each load into components normal and tangential to AC.
Member AB (helical spring) and Member AC (axial rod) are carrying a weight at point A. Member AB has the following properties: R = 90 mm, n =4 turns, G = 70 GPa, d = 30 mm, and allow = 105 MPa while Member AC has the following properties: L = 2 , A = 500 mm2, E = 200 GPa, and allow = 30 MPa. Determine the maximum safe value of W (in N). Use simplified formula for the helical spring.
A 25kg wooden plate is held in place by two strings attached to the ceiling and the wall. The string attached to the ceiling makes an angle 40o with the horizontal and the string attached to the wall makes 90o with the wall. Determine the force in each string (DONT ANSWER THIS PROBLEM). ANSWER ONLY THE PROBLEM IN THE ATTCHED IMAGE, COMPLETE SOLUTION PLEASE.
Two men carry a load of 2 kN by means of two ropes fixed to the weight. One rope is inclined at 45º and the other at 30º to the vertical. Find the tension in each rope.
A chandelier weighing 20kg hangs from a point B by two strings AB and BC. AB is inclined at 50° to the horizontal and BC at 35° to the vertical as shown. Question 7A, determine the force in the string AB. Question 7B, determine the force in string BC. See figure from the preceding problem.
In the simple cage system in the figure, which of the following is the absolute value of the force carried by the CE element in kN?