Q2: Water flows through a Venturi meter, as shown in Fig. 2. The pressure of the water in the pipe supports columns of water that differ in height by 30 cm. Determine the difference in pressure between points a and b, in MPa. Does the pressure increase or decrease in the direction of flow? The atmospheric pressure is 1 bar, the specific volume of water is 0.001 m /kg, and the acceleration of gravity is g 9.81 m/s.

Q2: Water flows through a Venturi meter, as shown in Fig. 2. The pressure of the water in the pipe supports columns of water that differ in height by 30 cm. Determine the difference in pressure between points a and b, in MPa. Does the pressure increase or decrease in the direction of flow? The atmospheric pressure is 1 bar, the specific volume of water is 0.001 m /kg, and the acceleration of gravity is g 9.81 m/s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Given the lifting table shown below , The diameter of the plunger DP 8 cm.The ram diameter DR 48 cm , The efficiency is 100 %, The stroke of the plunger is 18 cm. The ram has to raise a load F2 = 2 kN. Find : a) the force F1 exerted on the plunger b) the number of strokes needed to raise the load given above by a distance of 10 cm c) the volume of oil pumped if the load moves by 20 cm ( using plunger force in a ) d) What will be the new diameter of the ram piston if the new load force is 16 times the force exerted in the plunger the diameter of the plunger is kept to 8cm .
Find the atmospheric pressure in kilopascals if the mercury barometer reads 742 mm. Specific gravity of mercury is S=13.57, g=9.81m/s2. a) 103.8 kPa b) 93.8 kPa c) 88.8 kPa d) 83.8 kPa e) 98.8 kPa
A town has a 1.4-million-gallon storage capacity water tower. If the density of water is 62.4 lb/ft3 and local acceleration of gravity is 32.1 ft/s2, what is the force, in lbf, the structural base must provide to support the water in the tower?
An air bubble rises from the bottom of a well where the temperature is 25oC, to the surfacewhere the temperature is 27oC. If the depth of the well is 5m and the atmospheric pressure is101.325kPa, determine the following:a. Initial pressure inside the air bubble (P1). b. Volume of air bubble at state 1. c. Volume of air bubble at state 2. d. Percent increase in volume of the bubble.
If glycerin has a specific gravity of 1.261 at 20°C, what is its density in g/cm^3; in lbm/ft^3; in kg/m^3?
At a certain elevation, the pilot of a balloon has a mass of 125 lb and a weight of 119 lbf. What is the local acceleration of gravity, in ft/s2, at that elevation? If the balloon drifts to another elevation where g = 32.05 ft/s2, what is her weight, in lbf, and mass, in lb?
The force generated by a spring is given by F = kx, where k is the spring constant and x is the deflection of the spring. The spring of Fig. P1–99 has a spring constant of 8 kN/cm. The pressures are P1 = 5000 kPa, P2 = 10,000 kPa, and P3 = 1000 kPa. If the piston diameters are D1 = 8 cm and D2 = 3 cm, how far will the spring be deflected?
Suppose a liquid level from 5.5 to 8.6 m is linearly converted to pneumatic pressure from 3 to 15 psi. What pressure will result from a level of 7.2 m? What level does a pressure of 4.7 psi represent?
A vertical piston-cylinder assembly contains 0.5 kg of water. Initially, the piston is resting against the stops when the water pressure and temperature are 1.00 bar and 100°C, respectively. The piston has a mass of 50 kg and face area of 0.01 m2; local atmospheric pressure is 1.01 bar; local gravitational acceleration is 9.81 m/s2 (5) What water pressure would be required to lift the piston from the stops? (3) Thinking about water as the system, is the system best described as open, closed, or isolated? Why? (3) Are changes in kinetic and potential energy negligible for the system in this case? Why? (5) How much heat transfer must occur to the water in order to begin to lift the piston from the stops? (2) Once the piston is lifted from the stops, will the water pressure change? Why? (5) Assuming that the water's pressure remains constant, find the work for the volume to double in kJ. Carefully indicate the direction (i.e., what is the work that you reported being done on or…
If 10 m^3 of atmospheric air at 1 degree centigrade temperature are compressed to a volume of 1m^3 at 100°C, what will be the pressure of air?
Which of the following is intensive property heat: work, internal energy, specific heat, heat capacity, pressure
[Hydraulics] How can you evaluate the vertical force acting on a horizontal surface immersed in a liquid?