When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire. explain answer: 11.58 mm
Q: I Find the current value for the resistance (4 ohm) using mesh (loop) method or nodal method. All…
A: The mesh equation can be obtained by applying kirchhoff's voltage law to the meshes and then by…
Q: Ex 1: a 50 Hz generator has e.m.f. to neutral 7.5 kV (r.m.s). the reactance of generator and the…
A:
Q: Ex 1: a 50 Hz generator has e.m.f. to neutral 7.5 kV (r.m.s). the reactance of generator and the…
A:
Q: he initial content of a 3-bit ripple down counter is 000. After the first clock trigger, the counter…
A:
Q: Write (True) for the correct answer and (False) for the wrong one: (select tw 1. 1. Coulomb's law…
A: 1. Coulomb's law : According to Coulomb's law when two charges are placed at a distance of d between…
Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the second clock…
A:
Q: A decoder with 4-bit input signal has outputs 4 O 16 O 1 O none of the mentioned O 2 O
A: We need to select correct option for decoder .
Q: 4. The transistor in the circuit in Figure 4 has a dc current gain of 3 = 100. (a) Determine the…
A: For the above given common emitter amplifier circuit we need to derive all the small signal…
Q: 3. By means of full adder block diagram, design a Logic circuit which subtracts two numbers using…
A:
Q: Determine the basis that generates the following vector space by clearing the variable y: M = {(x,…
A:
Q: Discuss in detail about recent technology used in tidal energy systems. List down at least three…
A: Tidal energy is a renewable source of energy that is derived from the natural rise and fall of ocean…
Q: Calculate the current " I " to give air-gap flux of 20 mwb
A:
Q: A high electron mobility transistor (HEMT) controls large currents by applying a small voltage to a…
A: The Given data are Current I=10.0μA Length is L=1.00mm long Wide is W=0.300mm The Thick is T=10.0nm…
Q: In Fig. 11.12, the resistor R, is adjusted until it absorbs the maximum average power. Calculate R,…
A:
Q: Matlab
A:
Q: The minimum number of flip-flops that can be used to construct a Mod- 5 counter is 5 3 O none the…
A:
Q: Calculate the current " I " to give air-gap flux of 20 mwb
A:
Q: 2: Find the efficiency of DC compound motor (long shunt); armature current (101.3 A), rotate at…
A:
Q: In an 8-bit 2's complement adder/subtractor circuit, if A=2, B=6, the operation (A- B) results in…
A:
Q: *75 (II) (a) Calculate the bit-rate that would be required to address all of the 6 million subpixels…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Use rules of block diagram reduction to determine the closed loop transfer function:(see the…
A: By using Rule of block diagram reduction determine the closed loop transfer function: Options are:…
Q: Find 11 and 12
A:
Q: 3- Two sinusoidal currents are given by the equations: il = 10 sin (oot + /3) and i2= 15 sin…
A: Given data, Current1(i1)=10sinωt+π3 Current2(i2)=15sinωt-π4
Q: Consider two amplifiers A, and A₂. The rise time for first stage is 0.3 ms and for the second stage…
A: Given data, To amplifiers A1 and A2 are cascaded. Rise time of first stage is tr1=0.3 ms Rise time…
Q: If the initial content of a 3-bit ripple down counter is 000. After the first clock trigger, the…
A:
Q: The minimum number of flip- flops that can be used to construct a Mod-5 counter is
A:
Q: B. One method of Amplitude Demodulations is shown below: AM Input LPF VOUT m(t) + Distortion Low…
A: Demodulation is an important step in receiving any amplitude modulated signal, whether for broadcast…
Q: Quguse Parallel full adder and other type of gates to design a circuit which for form the following…
A: Given & to find: Use parallel full adder and other types of gates to design a circuit that…
Q: We need a three-stage space-division switch with N = 100. We use 10 crossbars at the first and…
A:
Q: i) Analyse and identify the types of the buses shown in the figure from the specification. 11/33 kV…
A: Given: Consider the following figure: To find: Analyze and identify the types of the buses shown in…
Q: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor has two…
A: There are two sensors in the Given Fluid system: a. Pressure Sensor. b. Flow Sensor. The pressure…
Q: What are the drawbacks of slope detector? 8. How FM wave can be converted into PM wave?
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…
A: Squirrel cage induction motor is good speed regulation and the harness of electromagnetism to…
Q: A transformer has 1200 primary turns and 200 secondary turns. The primary and secondary resistances…
A: It is given that: N1=1200N2=200R1=0.2ohmR2=0.02ohmX1=1.20hmX2=0.05ohm
Q: Solve the question in the simplest way Determine the y parameters for the two-port shown in Fig.…
A: We need to find out the Y parameters of given circuit
Q: 2. Current is defined as the rate of charge. .flow. If a charge of 0.0065 colombs passes a given…
A: This question belongs to circuit theory . It is based on the concept of formula of current . Problem…
Q: The characteristic equation
A:
Q: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…
A: To prevent mal-operation of differentially connected relay while energising a transformer, the relay…
Q: Solve the given initial-value problem. Give the largest interval I over which the solution is…
A:
Q: Region I Mr₁=4 is the side of the plane ytz: containing the origin Region II 1 Mr₂ = 6 for given…
A: The interface is in y-z plane. So normal to the plane is along x At the interface, normal component…
Q: In this parallel-plate capacitor, the distance d between the plates is 3cm, the radius of the plates…
A: Given, Distance between the plates, d=3 cm Radius of plates, r=2 cm Relative permittivity, εr=1…
Q: 30 KVA, 2400/120V, 50Hz transformer has a high voltage winding resistance of 22Ω. The low voltage…
A:
Q: Derive the equation for maximum power transfer, Pmax= E V / X.
A:
Q: Ex. 1: Determine the PSM (plug setting multiplier) of a 5A, 2.2 sec over current relay having a plug…
A: In this question we need to find a PSM .
Q: A rectifier circuit is used to charge a 12 Vdc battery using a 40 Vpp AC source, according to the…
A: The Given is to design rectifier circuit. In the Given rectifier circuit charge a V0=12 Vdc battery…
Q: 44 7. The generator power is always less than the maximum power transferred to the load?.
A: Q.7) True If generator operated at a power which is greater than maximum power (Pmax) it leads to…
Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…
A:
Q: What is the equivalent transformer specification if needed to produce an output of 15 volts…
A: Given data, Average dc output voltage V0=15 V
Q: Q2: A) Sketch the block diagram of thermal power station, then state the main parts of the plant and…
A:
Q: 2m, 2.5 m and 4.5 m and the diameter of each conductor is 1.24 cm. Calculate: (1) The inductance per…
A:
When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire.
explain
answer: 11.58 mm
Step by step
Solved in 2 steps with 1 images
- When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire.explain the steps. answer: 11.58 mm use the parallel wires formulaWhen two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire. explain the steps of the problemWhen two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire. Explain
- When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire. Explain the problemWhen two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m. Calculate the diameter of each wire.A relay coil is connected to a 210V, 50Hz supply. If it has a resistance of 30Ω and an inductance of 0.5H, calculate thea pparent power and the power factor.
- I have already answer but can please help to understand calculations..i will give vote A 240 kV, 3-phase, 50 Hz, 400 km transmission line has a capacitance to earth of 0.04 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.Calculate the reactance of a coil of inductance 0.2H when it is connected to a 50Hz supply. A. 62.83ohms B. 63.82ohms C. 62.38ohms D. 63.28ohmsAn RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms. What is the inductance of the cable per foot.
- 3-phase single circuit 132 kV overhead line has conductors of diameter 1.8 cm each. Thespacing between conductors is 4 m, 6 m and 9 m. Find the inductance per phase per km.[1.35 mh]The voltage v = 207 sin(100t+50°) V is connected acroos a 5-H inductor. Determine the inductive reactance. Write the magnitude only in four decimal places.Calculate the inductive reactance of a 210mH inductor that has a 100mA RMS 1kHz current passing through it. 10.4kΩ 5.32kΩ 1.32kΩ 2.87kΩ