Q3/ A 600-kg car is moving on a level road at 30 m/s. (a) How large a retarding force (assumed constant) is required to stop it in a distance of 70 rn? (D)friction between tires and roadway if this is to be possible? Assume the wheels are not locked, in which case we are dealing with static * .friction * there's no sliding

Q3/ A 600-kg car is moving on a level road at 30 m/s. (a) How large a retarding force (assumed constant) is required to stop it in a distance of 70 rn? (D)friction between tires and roadway if this is to be possible? Assume the wheels are not locked, in which case we are dealing with static * .friction * there's no sliding

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A truck weighing 35 tons is traveling at 32 km/h round a curve track of 43 m radius. If thecenter of gravity of the truck is 2.3 m above the rails, calculate the vertical reaction of eachwheel if the wheel distance is 1.7 m apart Additionally, if the track is banked at 13 degree and thecoefficient of friction is 0.4, and find the truck's maximum speed.
9. The 500KN is in contact with a 450 inline. The coefficient of static friction is 0.25. Compute the value of the horizontal force P necessary to Just start the block up the incline. A. 822KN B. 832KN C. 842KN D. 852KN
Problem 2. Determine the velocity and acceleration of point B below. The wheel below rolls freely to the right. Compute for the required at the given position if w= 3 rad/sec and a= 5 rad/sec2, both clockwise.
The radius of a highway-curve is 120m, and has an angle of9.31 from the horizontal. The center of gravity of the truck islocated 0.80m above the roadway and the distance betweenthe two front wheels is 1.2m. If the truck has a total weight of15KN,a. Determine the normal acceleration (m/s2) and thevelocity (in kph) of the truck before overturning (*Notethat friction is neglected between the tires and theroad)?b. Find the maximum velocity of the truck could move inthe curve so that there will be no pressure between thetires and the roadway.c. If the allowable speed of the highway curve is 80 kphand the coefficient of kinetic friction is 0.60, what is thevelocity of the truck without sliding?
A car running at 80kph saw an oil truck in an accident 250 meters away. At the same time the truck is spilling oil causing a 60% reduction of friction. If initial f-0,30 a) will the car hit the obstruction? b) assuming that the tires would be replaced in such a way that the f-0.70, how much distance will the car have away from the obstruction? c) If the obstruction is 120m away and the oil did not spill, what would have been a safe speed at which the car will not hit the obstruction from 10m away assume f-0.32
If the block reaches point C at a speed of 6m/s, what is the horizontal distance X betweenB and C? (Note: v0=4 m/s, calculate using theWork and Energy Method. The frictioncoefficient is 0.25 on all surfaces)
A 2000-lb bike with a rear wheel drive has awheelbase of 10 ft. The c.g. is 3 ft above thepavement and 4 ft ahead of the rear wheels.The coefficient of friction is 0.60 between thetires and the pavement. Determine the maximum acceleration theauto could have when moving along a levelground.a. 40.21 ft/s2 b. 42.90 ft/s2c. 43.56 ft/s2 d. 45.02 ft/s2
It is observed that the skier leaves the ramp A at an angle ?= 25with the horizontal. If he strikes the ground at B, determine d. Radius of curvature at A e. Radius of curvature at B
To anticipate the dip and hump in the road, the driver of a car applies his brakes to produce a uniform deceleration. His speed is 100 kph at the bottom A of the dip and 50kph at the top C of the hump. The length of the road from A to C is 120m. The radius of curvature of the hump at C is 150m. The total acceleration at A is 3 m/s^2 -determine the acceleration in m/s^2 at the point of inflection B -compute the total acceleration in m/s^2 at C. -compute the radius of curvature at A
Determine the ideal velocity of a car that could pass round a 5° curve if the impact factor is 0.14. Neglect friction. a. 48.51 kphb. 35.62 kphc. 63.87 kphd. 86.51 kph
In a very foggy day, the road visibility is no more than 30m ahead.Given that the coefficients of static and kinetic friction between thetyres and the road surface are 0.9 and 0.8 respectively. (a) If the driver can act immediately when he sees obstacle ahead,i.e. reaction time is zero, find the maximum speed limit.(b) If the driver has reaction time of 0.3 second, what will be thenew maximum speed limit?
The banking of the road way is 10 degrees at a radius of curvature of 80m, what will be the maximum velocity for a 2 ton vehicle and a 5 ton vehicle if the coefficient friction is 0.4 ?