Q3.2. Air enters the lungs through a circular channel with a diameter of 3 cm and a velocity of 150 cm/s and a density of 1.25 kg/m . Air leaves the lungs through the same opening at a velocity of 120 cm/s and a density equal to that of the air within the lungs, which has decreased its net density, due to the lower density air entering the lungs. At the initial conditions the air within the lungs has a density of 1.4 kg/m3, with a total volume of 6 L. Find the aggregate rate of change of the density of air in the lung assuming that your time step includes one inhale and one exhale (takes 15 s) and that there is no change in the lung volume over this time.

Q3.2. Air enters the lungs through a circular channel with a diameter of 3 cm and a velocity of 150 cm/s and a density of 1.25 kg/m . Air leaves the lungs through the same opening at a velocity of 120 cm/s and a density equal to that of the air within the lungs, which has decreased its net density, due to the lower density air entering the lungs. At the initial conditions the air within the lungs has a density of 1.4 kg/m3, with a total volume of 6 L. Find the aggregate rate of change of the density of air in the lung assuming that your time step includes one inhale and one exhale (takes 15 s) and that there is no change in the lung volume over this time.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A water truck drives slowly around a construction site, spraying water to keep dust down. A pump maintains a constant pressure of 100 kPa, gage, and the water is dispersed through 20 spray nozzles, each of diameter 0.01 m. If the truck is initially filled with 4000 L of water, and the flow rate is constant, determine how long the truck can drive before a refill is necessary in seconds.
A fluid moves in a steady flow manner between two sections in a flow line. At the entrance section: A1, =1 m2, v1= 0.5 m/s, ρ1 = 4 kgm/m3. At the exit section: A2 =0. 2 m2, ? 2 = 0.20 m3/kgm. Calculate (a) the mass flow rate in kg/s and (b) the speed at section 2 in m/s.
A 5-cm-diameter horizontal jet of water, with velocity 30 m/s, strikes the tip of a horizontal cone, which deflects the water by 45° from its original direction. How much force is required to hold the cone against the water stream?
A jet of water with velocity 35 m/s strikes a series of radial curved vane mounted on a wheel which is rotating at 200 rpm. The jet makes an angle 30° with the tangent to the wheel at inlet, and leaves the wheel with a velocity 5 m/s at angle of 140° to the tangent to the wheel at the outlet. The outer and inner radii of the wheel are 70 cm and 35 cm, respectively. A. Determine the Inlet Vane Angle, in degrees.
Water flows through a pipe of 0.0025 m^2size with a uniform velocity of 7m/s and flows out from an ariface at bottom at a rate 0.003 m^3/s. what is rate of change of mass of water in the tank?
A jet of water with velocity 35 m/s strikes a series of radial curved vane mounted on a wheel which is rotating at 200 rpm. The jet makes an angle 30° with the tangent to the wheel at inlet, and leaves the wheel with a velocity 5 m/s at angle of 140° to the tangent to the wheel at the outlet. The outer and inner radii of the wheel are 70 cm and 35 cm, respectively. Determine the work done per unit weight of water, in Newton-Meter per Newton.
A fluid moves in a steady flow manner between two sections in a flow line. At the entrance section: A1, -1 m2, V = 0.5 m/s, P1 = 4 kg/m2. At the exit section: Az =0.2 m2, v 2 = 0.20 m®/kgm. Calculate (a) the mass flow rate in kg/s and (b) the speed at section 2 in m/s.
A reducing elbow is used to deflect water flow at 25 L/s in a horizontal pipe upward by an angle of=45° from the flow direction while accelerating it. The elbow discharges water into the atmosphere. The diameter of the elbow is 15 cm at the inlet and 5 cm at the exit. The elevation difference between the center of the exit and inlet is 40 cm. The mass of the elbow and the water in it is 40 kg. Determine the anchoring force needed to hold the elbow in place, assuming a momentum-flux correction factor of 1.03.
A fluid moves in a steady flow manner between two sections in a flow line. At the entrance section A1 = 1m², V1= 0.5 m/s, P1= 4kgm/m³. At the exit section: A2 = 0.2m², V2= 0.20m³/kgm. Calculate the mass flow rate in kg/s and the speed at section 2 in m/s.
A projectile-like object with maximum diameter of 20 cm is placed at the exit of a 25-cm-diameterpipe. Water flows through the pipe. At the upstream location 1, the velocity is uniform and equalto 2 m/s. The water exits to the atmosphere where the pressure is 100 kPa. Find the force requiredto hold the object in place. Be sure to state your assumptions.
A jet of water of diameter 60 mm strikes a stationary flat plate normally at a velocity of 26 m/s. What is the force exerted by the jet of water? Select one: a. 1,911.3 N b. 1,756.4 N c. 1,561.6 N d. 1,722.1 N
Consider the incompressible flow of water through a divergent duct, where the inlet has a velocity & section area of 5 ft/s & 10 ft2. If the exit area is 5x the inlet area and the density of water is 62.4 lbm/ft3, solve for the pressure difference. (Please type answer no write by hend)