Q4/ A cylindrical coil of length L = 20 cm, its area is A1 = 40 cm^2 and the number of its turns is 20000 = N1. Inside it and in the middle is a short coil so that the two coils have a common axis. If you know that the length of the short coil is 20cm = L2, its area is A2=40cm^2 and the number of its turns is 200=N2, find: 1- The mutual inductance coefficient %3D

Q4/ A cylindrical coil of length L = 20 cm, its area is A1 = 40 cm^2 and the number of its turns is 20000 = N1. Inside it and in the middle is a short coil so that the two coils have a common axis. If you know that the length of the short coil is 20cm = L2, its area is A2=40cm^2 and the number of its turns is 200=N2, find: 1- The mutual inductance coefficient %3D

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter20: Induced Voltages And Inductance

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
A rectangular coil with resistance R has N turns, each of length and width as shown in Figure P31.36. The coil moves into a uniform magnetic field B with constant velocity v. What are the magnitude and direction of the total magnetic force on the coil (a) as it enters the magnetic field, (b) as it moves within the field, and (c) as it leaves the field?
You observe that a circular conducting ring (one-turn) of radius 0.27 m is performing 35 rotations per minute in a region where there is a 0.047 Tesla uniform B-field. a. What is the angular speed (or angular frequency) of rotation (in rad/sec)? b. Take t=0 as the time when the B-field is perpendicular to the plane of the coil (or parallel to the area vector). What is magnitude of the voltage generated at t=0.2 seconds? c. What is the magnitude of the peak voltage generated?
1. For the discussed problem: loop of current with radius R at xz plane. (a) Sweep point P location from y=0 to y » R and obtain magnetic field. (b) Construct two columns in Excel and plot the B versus on-axis distance y in the range of your sweep. Show that plot. Z dī dB R O di 0 0 0 dB'
A 1000 turn coil is moved from a location where there the magnetic field is 25.00 T to a location wherethere is no magnetic field. It takes 0.5 s to move the coil and the induced voltage. The induced voltage is 50.00volts. What is the cross-sectional area of the coil in ?2? What is the diameter of the coil in units of cm?
A uniform magnetic field of 3.2 x10-3 T passes through a single loop rectangular coil of dimensions of 2.9 m by 3.1 m which makes 57° angle with the area vector of the coil. Calculate magnetic flux of the coil in Wb/m2?
Q.1 What produces the magnetic field we measure in the coil? The computer software The current The temperature gradient between the ends of the coil. Q.2 The magnetic field strength of a long solenoid is 1 * 10 -4 T. If the current in it is 1 A, how many loops will it have? Q.3 The field strength for the East radial field has how many peaks?
XThe spiral shown in figure 1 is square, 4 cm on its side a with 3 turns. A magnetic field given by: B = 0.2xy(t+1) k With t in seconds, x and y in meters and B in Teslas, passes through it. Determine for t=5 s: a) Determine the magnetic flux. b) Induced emf.. 1 4 cm •B X X X X XX 3 cm 1 cm
I want to know what the flux is since the cylinder is still subject to induction heating. I want to know if with the given information it is possible to calculate the magnetic flux. a) how far is the flux andb) is the flux in the range of the cylinder wall? outside diameter of the cylinder .900inside diameter 0.500
(Hand by written ans.)A circular loop (10 turns) with a radius of 29 cm is in a magnetic field that oscillates uniformly between 0.95 T and 0.45 T with a period of 1.00 s. a. How much time is required for the field to change from 0.95 T to 0.45 T? b. What is the cross-sectional area of one turn of the loop? c. Assuming that the loop is perpendicular to the magnetic field, what is the induced emf in the loop? I have a test and i am revising and I got 2 answers for this question. could you please explain each step thoroughly for me to understand.
a) A coil of wire has an area of 2.0 x 10-*m?, consists of 100 turns or loops and contains acurrent of 0.045A. The coil is placed in a uniform magnetic field of magnitude 0.15T.Determine the magnetic moment of the coil and the maximum possible torque that themagnetic field can exert.b) List four factors affecting the size of the torque on the wire.c) State faraday's law of Electromagnetic induction.A coil of wire has an area of 0.02m? and consists of 50 turns. At t = 0 the coil is orientatedso the normal to its surface has direction (8 = 0°) to a constant magnetic field of magnitude0.18T. The coil is then rotated through an angle of (8 = 30°) in a time of 0.10s. By using theexpression given below determine the average induced EMF.E• N(4 - Po)/(t-to)4= BAcos(A)