Q4/ Draw the mohr's stress circle or the element of the beam as shown in Fig. 4, and determine the principal stresses, the principal planes (p), and the maximum shear stress. Also, find o, o, and try on element obtained by rotating the given element counterclockwise through 30°. Fig. 4 a=60 MPa T=48 MPa 0,-100 MPa

Q4/ Draw the mohr's stress circle or the element of the beam as shown in Fig. 4, and determine the principal stresses, the principal planes (p), and the maximum shear stress. Also, find o, o, and try on element obtained by rotating the given element counterclockwise through 30°. Fig. 4 a=60 MPa T=48 MPa 0,-100 MPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A cylindrical storage tank contains liquefied propane under a pressure of 1.5 MPa (gage pressure P=1.5 MPa) and is subjected to an axial force F=60 kN. Knowing that the tank has an inner diameter of 320 mm and a wall thickness of 3 mm, find the principal stresses and determine the maximum shear stress.
Determine the average normal stress developed at points A, B, and C. The diameter ofeach segment is indicated in the Figure below.
Find the maximum principal stress
The stresses shown act at a point in a stressed body. Assume stress magnitudes of Sx = 13,300 psi, Sy = 7,750 psi, and β=25∘. Determine the normal and shear stresses at this point on the inclined plane shown.
When sheer force acting on beam at F=60kN,find the sheer stress that occurs on the n-n section and indicate the distribution of the sheer stress
Determine the principal stresses andmaximum in-plane shear stress of given stresselement.
The inner diameter of the AB compressed air tank is 160, the wall thickness is 1.Since the manometer pressure in the tank is 1,6 ,at point a at the top of the tank maximum normal stress and determine the maximum plane shear stress.(c=16 , d=38, e =32, g=160, h=1, k =1.6 , F=160)
A thin-walled pressure vessel is made of steel with a thickness of 2 mm and an internal diameterof 300 mm. It is subjected to an internal pressure of 10 MPa. Determine the hoop stress andlongitudinal stress developed in the vessel.
Q2. A mild steel shaft transmits 21 kW at 250 r.p.m. It carries a central load of 900 N and is simply supported between the bearings 2.5 metres apart. Determine the size of the shaft, if the allowable shear stress is 42 MPa and the maximum tensile or compressive stress is not to exceed 56 MPa.
From the stress states given, draw the 3D Mohr's circle (lable the principle normal stresses, maximum and absolute shear stresses), and sketch the principle and shear planes. σxx = 70 ksi, σzz = -50 ksi, ?xy = 50 ksi (counterclockwise)
A rubber bolt is inflated to apressure of 65kPa. At that pressure, te diameter ofthe ball is 240mm and the wall thickness is 1.25mm. The rubber has a modulus ofElasticity = 3.7 MPa and Poisson’s ratio v=0.48. Determine the maximum stress in theball if its stress is half that of the cylinder.
Using transformation equations of plane stress, determine the normal and shear stress components for X’-axis located 0.5 radians clockwise from x-axis. The non-zero stress components are given as follows, σx= 200 MPa, σy= 100 MPa, τxy= -50 MPa.