QUESTION 2 a) Determine the drag force on either side of a thin smooth plate 2 m long and 1 m wide, with the length parallel to a 30 ms¹ fluid flow. The fluid has a density of 800 kgm ³ and a dynamic viscosity of 0.008 kg/m/s. b) A stream of fluid is flowing at 0.5 ms ¹. A cylinder with a diameter of 80 mm and a length of 200 mm is placed in it perpendicular to the flow direction. The fluid has a density of 800 kgm ³. The drag force is 30 N, according to the measurements. Calculate the drag coefficient of the cylinder.

QUESTION 2 a) Determine the drag force on either side of a thin smooth plate 2 m long and 1 m wide, with the length parallel to a 30 ms¹ fluid flow. The fluid has a density of 800 kgm ³ and a dynamic viscosity of 0.008 kg/m/s. b) A stream of fluid is flowing at 0.5 ms ¹. A cylinder with a diameter of 80 mm and a length of 200 mm is placed in it perpendicular to the flow direction. The fluid has a density of 800 kgm ³. The drag force is 30 N, according to the measurements. Calculate the drag coefficient of the cylinder.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As shown in Fig. 1.12, a horizontal interface 0-0 exists between two immiscible liquids. The dynamic viscosity of these two liquids are 0.14 Pa sand 0.24 Pa s respectively. The thickness is d1 0.8 mm and d2 1.2 mm respectively. Assuming that the velocity gradient is linear. Find theforce F required to push a bottom area A 1000 cm2 wood board to movewith velocity v0 0.4 m/s along the surface?
A plate moving 10 cm/s to the right is 0.5 cm above a stagnant wall. The fluid between the plate and the wall has a viscosity of 1.8 cP. Determine the shear rate.
A nuclear reactor is cooled by liquid sodium. The liquid sodium has the following properties: dynamic viscosity = 0.41 mPa·s, specific heat capacity = 1.2 kJ/kgK, thermal conductivity 82 W/mK. Which of the following statements is correct for this scenario? please explain A The thermal boundary layer is thicker than the hydraulic boundary layer. B Heat is transferred through the fluid more easily than momentum. C The velocity varies significantly from the surface to the thickness of the thermal boundary layer. D The hydraulic boundary layer is thicker than the thermal boundary layer.
A 20 kg slab slides down a 14° inclined plane on a 2.8 mm thick film of oil with viscosity equal to 0.082 Pa-sec. If the contact area is 0.12 m2, solve for the terminal velocity of the slab in m/s. Neglect air resistance. Round your answer to 3 decimal places.
Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the wind tunnel spped is measured with Pitot tube probe. For a certain run, the stagantion pressure is measured to be 472.6 Pa gage and the statric pressure is 15.43 Pa gage. Calculate the wind tunnel speed. Choose the right answer below: a.16.3 m/s b.18. 3 m/s c.17. 3 m/s d.19. 3 m/s
The Reynold's number of a sphere falling in air is 1E6. If the sphere's radius is 1ft, what is its velocity? Density of air is 0.00234 slug/ft³ and viscosity of air is 3.8E-7 lbf-sec/ft²A. 2.5 ft/sB. 5.1 ft/sC. 40.6 ft/sD. 81.2 ft/s
A plate moving 10 cm/s to the right is 0.5 cm above a stagnant wall. The fluid between the plate and the wall has a viscosity of 1.8 cp. Determine the shear stress in the fluid.
A square block weighing 1.1 KN and 250 mm on an edge slides down an 20 degrees inclined on a film of oil 6.0 micrometer thick. Assuming a linear velocity profile in the oil, what is the terminal speed of the block in m/s. The viscosity of the oil is 7 mPa-s. a.5.16 b.5.62 c.5.75 d.5.48
The shear stress at a point in a liquid is found to be 0.03 N/m2. The velocity gradient at the point is 0.15 s-1. What will be it’s viscosity (in Poise)? a) 20 b) 2 c) 0.2 d) 0.5
3. A cubic object (SG=0.893) with a side length of 10 cm is suspended between two liquids (fluid 1 and fluid 2). If the specific gravity of fluid 1 is 1.03 and the density of fluid 2 is 840 kg/m^3 which of the two fluids can be found at the top of the mixture and what percentage of the object is submerged in fluid 2?
What is the behavior of flow if water at 20 deg C is flowing through a pipe with a radius of 2.067 in at 20 gal/min. Viscosity of water at 20 deg C =1.005 cP Density of water at 20 deg C = 998.23 kg/m3
Liquid A(sp gr = 0.95) at a temperature of 29°C is flowing at a rate of 120gal/min in a pipe with an inside diameter of 2.343 in. If the reynold number is 5.6 x 10^5. what is the viscosity of liquid A in centipoise. Final answer in four decimal.