QUESTION 1 (a) Powder Metallurgy (PM) has become competitive with processes such as casting, forging and machining, particularly for complex parts made of high strength and hard alloys. Compare the design considerations for products made of powder metallurgy, casting and forging process. Evaluate your observation. (b) Products made of sheet metals can be easily found around us. Identify some of the products in your automobile which are made from sheet metal, and discuss the process or combination of processes required to produce such products.

QUESTION 1 (a) Powder Metallurgy (PM) has become competitive with processes such as casting, forging and machining, particularly for complex parts made of high strength and hard alloys. Compare the design considerations for products made of powder metallurgy, casting and forging process. Evaluate your observation. (b) Products made of sheet metals can be easily found around us. Identify some of the products in your automobile which are made from sheet metal, and discuss the process or combination of processes required to produce such products.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In powder processing, a cylinder with a diameter of 2 inches and a height of 10 inches is to be made from fine copper powders. A single-action press is used for compaction. If the average density of the green product is 7 g/cm3 at the bottom half of the cylinder, estimate the compaction pressure at the punch surface. Assume no friction between the powders. The coefficient of friction between particles and containers is 0.2.
In solid state sintering of compacted metal powder material, discuss how the progress of microstructure changes in sintering can be observed by microscopy. Support your discussion with suitable schematic diagram.
GKN Sinter Metals Company pressed iron powders using a compaction pressure of 600 MPa to produced a cylindrical bearing which is 70 cm long and has internal and external diameters of 8 cm and 16 cm, respectively. Determine (a) the most appropriate pressing direction, (b) the required press tonnage to perform this operation, and (c) the final weight of the part if the porosity is 12%, given that the density of iron, ρ = 7.87 g/cm3. Assume shrinkage during sintering can be neglected
1- List all steps involved in powder metallurgy (P/M) process. 2- Briefly explain each step taken plagiarism into consideration, please.
What were the main needs to develop colloidal technique for powder processing, explain your arguments clearly?
What happens in the powder mixture if granulation is over wetted and under wetted? How can this be prevented?
1- List all steps involved in powder metallurgy (P/M) process. 2- Briefly explain each step
Explain the process of powder metallurgy in detail.
Discuss the effect of monomodal and bimodal particle size distribution of powderson the microstructure and properties of advanced ceramics. Which starting powders would youprefer and WHY?
If your aim is to obtain enhanced densification rates and accelerated grain growth during sintering, which sintering method would you prefer and why?What are the stages of this sintering method?
1) Give some examples of design of powder metallurgical parts
For a powder binding process that mixes a 3:1 volume ratio mixture of semi-crystalline polyethylene powder with a density of 0.900 g/cm3 and crystalline polyethylene powder, what is the percent crystallinity of the manufactured parts? (The density of polyethylene in its amorphous and crystalline states is 0.870 g/cm3 and 0.998 g/cm3 respectively) a. % Crystallinity = 35.50% b. % Crystallinity = 55.25% c. % Crystallinity = 53.35% d. % Crystallinity = 61.20% e. % Crystallinity = 45.96%