Question 1 Find the convolution by the graphical method for if 2/9 1/3

Q: In RL and RC parallel circuit, if the value of R= √L/C, then prove that the impedance of the entire…

A:

Q: A parallel-plate capacitor has plate area 200 cm2 and plate separation 3 mm. The charge density 1…

A:

Q: 1. Debug program is an assembler to assemble the Mach. Lang. to Assemb. Lang. 2. LEA SI, [BX+DI]…

A: 1. Debug program is used for the conversion of the assembly language input to the machine language…

Q: And dī= dpā p+ pd ØaØ+dzāz 4 dp ..vab=₁(P)dp Pl_)dp=-2² √10 p 10 2TEOP BAIX ρι PL Inplio In :: vab…

A: In  Vab equation ln(10/4) is getting as given below

Q: The most commonly used practical binary decoders are 2-10-4 O 4-10-16 O All the of them 3-10-8 *One…

A: 1. Answer: all the of them   a. It is one of the most preferred binary decoders along with the other…

Q: Find T 100 pF 10 ΚΩ 20 ΚΩ 40 ΚΩ 30 ΚΩ

A: We need to find out the time constant for the given circuit

Q: The oscillation frequency for the oscillator below is 3.12 MHZ for c=150 PF, L1=L2= 2.2 mH and M=0.5…

A:

Q: The direction of the field pattern in going and outgoing produced by a current flowing through a…

A: Single conductor Transmission line is a method of transmitting electrical power or signals using…

Q: Impedances z₂ and z3 in parallel are in series with an impedance z₁ across a 100V,50Hz AC supply. Z₁…

A: For the above given question we need to calculate the value of current, power and XC at resonance.

Q: If, in a 3-4 alternator, a field current of 50 A produces a full-load armature current of 200 A on…

A: Given, A 3-φ alternator has, Field current of 50 A Open circuit line voltage, Vocline=1730 V Open…

Q: Q1) Choose the correct answer 1. A periodic signal x(t) has a trigonometric Fourier series…

A:

Q: Classify IC logic circuits based on the package density, i.e. the number of devices in an IC chip.

A: We will refer the classification of IC chip.

Q: Solve this means find transfer function only handwritten I want or else dislike

A: For the above given question we need to calculate transfer function of the given block diagram.

Q: the four diodes used in a bridge rectifier circuit haveforward resistance which can be considered…

A: Diode is an electronic device. It have a two terminal positive and negative. It is made by…

Q: Design a simple charging circuit using a 100 V source, a 1M resistor and a capacitor. The circuit…

A: The capacitor will not reach its final immediately after giving the input it will take five times…

Q: In the following circuit, determine: (a) iR(0), iz(0), and ic(0), (b) dir(0)/dt, dir(0)/dt, and…

A: The required parameters can be obtained by analysing the circuit based on the state of the circuit…

Q: What will be the equivalent resistance between the terminal a & b for the below given electrical…

A: In this question we need to find a equivalent resistance between terminal a and b

Q: What are the relationships of resistance, voltage and current, and the distribution of voltages and…

A:

Q: Assume that V is a function of y and at y =2, V=5 volt and at y = 4, V = 10 volt. a) Fi cis. 30 με…

A: In this equation shows that the potential distribution in a region is depend the local charge of…

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

A: For the above given question we need to calculate the value of average power dissipated in the load…

Q: Suppose vi = 1.25 V for the CMOS inverter in Fig. below, What is the value of Vo for which MN is…

A: For the above given CMOS inverter need to calculate the value of output voltage whenever both NMOS…

Q: Q² For several system that relate the input x(n) to the output y(n). For each, determine whether the…

A:

Q: A- in scott connection: 1- Draw the connection diagram. 2- Prove that when the load is balance then…

A:

Q: Assume that the contents of 8086 microprocessor registers are: DS= 3300H, CS=1033H, SS= 1614H, SP=…

A: The stack memory at 1E76A H is not covered by the segment. This is because the maximum value of the…

Q: The magnetic field intensity is given in square region 0.5<x< 1 y = 0,1C2CIS by H = 2 ax + x²³ ay +…

A:

Q: RF carrier 10 KV at 1 MHz is amplitude modulated and index is 0.6. Peak voltage of the signal is?…

A: Given: Amplitude modulated carrier voltage, Vc=10 kV Modulation index, μ=0.6 Peak voltage of the…

Q: What are the three protective methods for surges, explain anyone method.

A: Given: Three protective methods for surges. Explain anyone's method.

Q: 32. The star connected rotor of a a 3-phase induction motor has a resistance and standstill…

A:

Q: Q2:- In the network in fig. (2), find the total capacitance Cr if: a. The switch is open. b. The…

A:

Q: A six pole wave wound armature has 40 slots. Each slot has 24 conductors and runs at 500 rpm. Find…

A:

Q: An inductive circuit of resistance 2ohms and inductance 0.01H is connected to a 250V, 50Hz supply.…

A:

Q: 20K0 www For the circuit below find V ref of . (741) comparator +16 V Vo 741 470 92

A:

Q: Example 7.12 An AM transmitter has a carrier power of 1 kW at a carrier frequency of 10 MHz. It…

A: Given  Few parameters of an am modulated wave.we need to find bandwidth ,total signal power and we…

Q: For the systems below, determine "Time invariant/variant," "Linear/Non-linear" and…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q1. A link is operating at f=60GHz & 500 MHz bandwidth. The Tx & Rx antennas are square-shaped with…

A: An antenna refers to an interfacing channel between the radio waves which are travelling through…

Q: At 50Hz operation a single phase transformer has eddy current loss of 100 W, Its eddy current loss…

A:

Q: Three point charges are located at the corners of an equilateral triangle as shown in the figure. b.…

A: In this question,  We need to determine the force on the charge -4uC and 2uC. Force due to 2 charge…

Q: The magnetic field intensity is given in square region 0.5<x< 1 y=0,1<2<15 by H = 2ax + x³ ay + y²…

A:

Q: Particles of charge +75 μC, +48 µC, and -85 µC are placed in a line as shown in figure (1). The…

A:

Q: How is a current of 10A shared by three circuits in parallel, the impedance of which are 2-j5),…

A:

Q: Q.1. a) Define 'Overvoltage' and briefly describe types of overvoltages in electrical system

A: Overvoltages protection devices Lighting arrangement  Overhead earth wire  Earthing screen....etc

Q: A 14/2 type NM copper used for a general lighting branch circuit Ampacity : Maximum fuse or circuit…

A: Circuit breaker:- Circuit breakers are used for safety purpose in electrical equipment. It is used…

Q: Consider the circuit on the left with two resistors, a capacitor and an ideal OP-AMP. You may make…

A: The Given Ideal OP-AMP is

Q: Find Zeg in the circuit of Fig. 3 eq

A: The total impedance of the circuit can be obtained by reducing the parallel connected impedance and…

Q: Q3) For the circuit shown below, calculate: VPIS 1- Current I. 2- Resistance voltage VR. 3- VDI- 4-…

A: In the given figure, the diode D1 &amp; D2 are forward biased but diode D3 reverse biased. The…

Q: 3- (A)16 4- By Boolean Algebra YZ + (X + Z) + (XY+XZ) = Z + X. 5- OR gate produce 1 out puts when…

A: According to bartleby question answer rule I have to solve one question because all are different…

Q: A certain appliance draws 22 A across 25 V power source, how much will a spend if I use it for 8…

A:

Q: 20ΚΩ For the circuit below find V ref of . (741) comparator +16 V Vo 741 470 Ω A

A:

Q: The select lines in multiplexer determine which input is connected to the output, and also increase…

A: There are two types of memory, RAM and ROM. RAM - Random Access Memory ROM - Read Only Memory

Q: A copper wire has a resistance of 2.4 ohms at 20-deg. Find its resistance at 75-deg. Resistance…

A: In this question we need to find a resistance of wire at 75°C

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.