Answered: Question 1: For the circuit given…

Question 1: For the circuit given below, find a)the currents I1, h, and Iz in the circuit. ) b) What is the total power delivered to the combination of resistors? R1=20 ɛi=10V I2 R2=6N R3=42 E2=14V

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter28: Direct-current Circuits

Section: Chapter Questions

Problem 28.21P: Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0...

See similar textbooks

Similar questions

(a) When the switch S in the circuit of Figure P28.14 is closed, will the equivalent resistance between points a and b increase or decrease? State your reasoning. (b) Assume the equivalent resistance drops by 50.0% when the switch is closed. Determine the value of R.
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
In the circuit shown below, Vs = 60 V, R1 = 7 Q, R2 =10 V, R3 = 6 Q and R4 = 6 Q. The Thevenin equivalent of this circuit consists of a voltage source Vth and series resistance RTh. FInd Vth and Rth and hence determine the current that will flow through a 50 Q resistor connected between points A and B. Give your answer in Amps to three decimal places. RTh I R3 R2 TA Vs VTh B Next > < Previous R4 R1 That -A B
The variable resistor Ro in the circuit is adjusted until the power dissipated in Ro is 40 W. Find the values of Ro that satisfy this condition. V,=60 V and R,=7,5 0, R2=30 0, R3=3 0, R4=6 0 and V=9iy. R, R3 R4 Vs R R. V. Lütfen birini seçin: O a. 1,50 and 3,90 O b. 0,55 and 4,50 Oc. 1,80 and 7,50 O d. 0,70 and 4,10 e. 0,31 and 2,40 * Of. 0,40 and 3,60 g. 1,80 and 7,20
Three resistors, R1=40, R2=30, R3=70 are connected to a battery as shown in the figure below. If the battery voltage is 44Volts, determine the power dissipated by R1. Express your answer in units of Watts, using zero decimal places. R2 R1 ww- R3 V