QUESTION 16 The minimum number of cycles to failure versus stress (S-N curve) of an outer guide vane (OGV) is given by log10(N) = - In {(oxouts -1 - 0.35)/0.65}, where Nf is the number of cycles to failure at stress level o (MPa) and outs = 419 MPa. The component has logged 1000 cycles at 156 MPa and 10,000 cycles at 147 MPa. Determine the percentage of the component life that has been used.

QUESTION 16 The minimum number of cycles to failure versus stress (S-N curve) of an outer guide vane (OGV) is given by log10(N) = - In {(oxouts -1 - 0.35)/0.65}, where Nf is the number of cycles to failure at stress level o (MPa) and outs = 419 MPa. The component has logged 1000 cycles at 156 MPa and 10,000 cycles at 147 MPa. Determine the percentage of the component life that has been used.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The width of an apron conveyor with a capacity of 75 tons/hr & speed of 50 ft/min. a. 220 mm b. 370 mm c. 070 mm d. 460 mm
Answer the following: c.) What is the friction factor d.) What is the total coefficient of loss or K. Note that some of the K are provided.
Correction Ey=500 × 10^-6
Correction Ey = 500 × 10^-6
Urgent plz
25,15mm and 14mm/s are the data's. Urgent solution required.
Pls veryyy urgentt
Selct the correct answer This element indicates how much Q a hydraulic valve can drive without exceeding a preset pressure drop. a) Flow capacity coefficientb) flow factorc) Internal volume capacity coefficientd) Compression ratio of a fluid
Compute efficiency and Balance Delay
Problem 8.37 from Ferdinand Beer
HYDRAULICSPLEASE PROVIDE COMPLETE SOLUTIONNEED ASAP THANKS
Friction Factor