Question 2: Evaluate the Discrete Time Fourier series representation for the following signal бл x[n] = cos -n+- 17 3 +7)

Q: What type of FET that the two channels are enhanced after applying proper voltage at the gate

A: Given Data:As per Question Explain type of FET that the two channels are enhanced after applying…

Q: For the FET amplifier shown: given FET parameters gm-0.2s, ra=10kQ, R, 1k2, and Rg-500kQ, (i)…

A: For the given feedback amplifier, the type of feedback topology needs to be identified and the…

Q: Measure: VRI V1 30V VR2 4 R1 m 5000 R4 ww 1000 VR3 Loop 1 Loop 2 R5 ww 4000 VR4 Verify KVL around…

A: Given Circuit:To determine:Voltage across each resistor:

Q: Sv A Find Vr + U X- m + sr and ir ил +m- aug YV

A: Circuit diagram is given as,

Q: (a) Find the currents i, and is in the circuit shown below. (b) Find the current through the 62…

A:

Q: a) g(t)*z(t) Du b) y(t)*z(t) c) g(t)*y(t)

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Q: x(t) = 10 cos(2n 200 t) sin(2π 1000 t)

A: Given Data:A continuous-time signal of,To Find:The double-side Amplitude and phase Spectra

Q: (b) What are the conditions of diodes in the Fig 2.11 given below (whether it is forward or reverse…

A: Need to analyze the given circuit and need to find the state of the diode. The conduction of the…

Q: a) An amplitude modulator is shown in fig. 4. VDC ii) 1) m(t) 1992 VOUT (t) cos(4×10³ лt) Figure 4…

A:

Q: Q1/ A conventional amplitude modulator (AM), where m(t) is the analogue message, Vpc is an offset…

A: Step-1->Ans(1)->

Q: Α) 2: Tel Rab 8 Ω Ο 18 Ω ²³-are 2012 www www 9Ω. ΣΩ www 20 Ω HE 20TH CLICHT 22 ΑΛΜ wwwww 12 AST

A: We need to find out equivalent resistance between a and b for given circuit.

Q: A 3200/240-V, 60-Hz, 1-phase transformer is built on a core having an effective cross-sectional area…

A: For single phase transformer,

Q: For the lossless TL shown in below with length 1, let Zg - 620, ZR = (open circuit load) and the…

A: We have given the parameters (open circuit load)Hence Now Reflection coefficient at receiving end…

Q: Q3) A 1600-kVA, 13500 V, 50-Hz, Y-connected synchronous generator has Ra=1.5 Ohm, Xs = 30 Ohm.…

A:

Q: A rectangular waveguide with a=3 cm and b=5 cm as shown in the figure is filled with polyethylene…

A:

Q: 2. A transmission line is to be terminated with a resistance of 125 [2] to minimize standing waves.…

A: Step-1->

Q: Q1/ Choose the correct answers and fill the blanks for the following questions: 1. Matching of a…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: A single-phase to single-phase cycloconverter is supplying and inductive load comprising of a…

A: “Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: The suggested overload factor, K0, for a perfectly smooth electric motor driving a perfectly smooth…

A: A  perfectly smooth electric motor driving a perfectly smooth generator through a gear type speed…

Q: A 100 W, 250 V lamp is connected in series with a 100 W, 200 V lamp across 250 V supply mains.…

A:

Q: Please can you tell me which items is the correct one from below 1. E-MOSFET 2. CMOS 3. VMOSFET…

A: Metal Oxide Semiconductor Field Effect Transistor (MOSFET) is a three-terminal Device the names of…

Q: The drift current in transistor is influenced by O Breakdown voltage limit of VCC O Forward biasing…

A: In the active mode of operation: The electrons gets drifted from emitter to base because of the…

Q: a) It is desired to draw maximum power by connecting a resistor between a an b. What should be the…

A: In this questionWe need to determine the resistance across the a and b to maximum power delivered to…

Q: Q4) Which one could be a valid and acceptable root-locus? (b) (c) (d)

A:

Q: A 110-V, 60-Hz, 2-pole, universal motor operates at a speed of 12500 rpm on full load and draws a…

A: For a universal motor,

Q: RB 12 V VB 2 mA RC + VCE 7.6 V ß = 80

A:

Q: Draw a Nyquist plot for the unity-feedback control system with the open-loop transfer function 1…

A: Given dataTo find outNyquist plot.Stability using Nyquist stability criterion.

Q: Question 3. Parameters for a 400 V three-phase synchronous generator with 5 kVA power are given as X…

A: The given information about a three-phase star connected synchronous generator is written…

Q: A magnetic circuit has a length 19 cm, cross section area A=20 cm² and relativity permeability 2673.…

A: it is asked to find the current flowing in coil

Q: Q3. Determine the z-parameters of two-port circuit shown below.

A: The Z parameters for the given network needs to be calculated. The Z parameters can be obtained by…

Q: A universal motor has a total resistance of 30 and a total inductance of 0.5 H. When connected to a…

A:

Q: -Find the transfer function for the signal flow graph (SFG) in figure below- M

A: For the given signal flow graph the transfer function needs to be obtained and the same can be…

Q: A rectangular waveguide with a=3 cm and b=5 cm as shown in the figure is filled with polyethylene…

A:

Q: Can you please point out which is the correct answer from below. 1. substrate 2. drain 3. source…

A: Answer for the complete statement"The___________ is the electron deficiency (or holes) at the…

Q: Describe the main features of the different types of technology that can be used for playing back…

A: Analogue recording:- Analogue implies to a continually shifting illustration of a continuously…

Q: Question 1. Given the following feedback system, a. Find the forward transfer function b. What…

A:

Q: R1

A: A JFET voltage-divider bias circuit is given with RD=1 k Ω, RS= 800 Ω, VP=-4 V, R1=390 k Ω, R2=100k…

Q: For the circuit below, what are the output voltage and Amp-Hour measurements at the + and terminals?…

A:

Q: Question 7: Find the value of Rs for Bridge Circuit is balanced or zero current (14 = 0) in R4: 10 V…

A: Voltage source, Value of resistance,

Q: Fig.1 2-The circuit shown in Fig.2, with R=1/3 2, L=1/4 H, C-3F. has input voltage v(t)=sin2t. The…

A:

Q: Q3. A 3-phase 20km line delivers a load of 10MW at 11KV having a lagging power factor of 0.707 at…

A: l= 20 KmP= 10 MWVR=11 KVcos= 0.707 (lag)R = 0.2 ohm/km/phaseX= 0.07 ohm/km/phaseregulation =?…

Q: "What is output Q during pulse b? (high, low) (answer in small letters)" 0 0 புபுபுபு 1 PR D FF PCLK…

A: it is asked to find the output during pulse b

Q: y voltage for the circuit in Figure 3.1 is given by: V(t)=10sin (27×637×10³t) V V(t) R R=6 kQ, L=4…

A:

Q: till I 352 W X si D.AV $be 0.3v Iv 33-22 lov à M A T 10.07 Ion 322 Sewwoor

A: We need to find out the current for given circuit.

Q: 24V 3 Ω www 1=0)) 4Ω 4Η mo 8 Ω

A: Given circuit diagram is,

Q: 3. a) Consider a single tone message signal m(t) = Am cos(2nfmt) where fm = 30 Hz is the message…

A:

Q: A three-phase Y-connected synchronous generator is rated 100 MVA, 12.5 kV, 0.85 PF leading and 50…

A: Given dataFrequency,

Q: Question 4: Determine the Currents 11 and 12 for the Network in Fig 4-4 Constructed of Standard…

A:

Q: please show diagram

A: VCE = 8.55 V IC = 2.15 AFrom the previous answer coordinates that we have 8.55, 2.15 .We have ,When…

Q: 8- Find the sequence for the following z-transform z² + 2z X(z)= (z-1)(z + 3) If the ROC is: i) |z|3

A: Given:To find:The sequence x[n] corresponding the given X(z), if ROCs are as:

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.