Which of the following is TRUE regarding instrumental methods of analysis? O A. these methods have higher precision compared to classical methods. O B. these methods can measure lower analyte concentration than classical methods O. these methods have lower accuracy compared to classical methods. O D. these methods have lower throughput compared to classical method.

Which of the following is TRUE regarding instrumental methods of analysis? O A. these methods have higher precision compared to classical methods. O B. these methods can measure lower analyte concentration than classical methods O. these methods have lower accuracy compared to classical methods. O D. these methods have lower throughput compared to classical method.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter8: Sampling, Standardization, And Calibration

Section: Chapter Questions

Problem 8.5QAP

See similar textbooks

Similar questions

Which of the following is TRUE regarding instrumental methods of analysis? A. these methods have lower throughput compared to classical method. B. these methods have lower accuracy compared to classical methods. C. these methods can measure lower analyte concentration than classical methods D. these methods have higher precision compared to classical methods.
Which of the following is/are true regarding instrumental methods of analysis? a. these methods have higher precision compared to chemical b. these methods have lower throughput compared to classical c. these methods can measure lower analyte concentration than classical d. all of the above
All of the following are classified as an instrumental method of analysis EXCEPT: A. chromatographic methods B. electroanalytical methods C. gravimetric methods D. spectroscopic methods
Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value (ET) for the quantity being sought by writing either <, >, or = on the space provided Determination of the true concentration (ppm Fe) in a water sample using the iron-phenanthroline method. Dilution factor was not taken into account. EX _____ 1ET
21. (What exactly is meant by potentiometric methods? What are they even?)
Which sentence is false about gravimetric analysis? a. It is used for inorganic b. It is used to assay barium c. It is used to assay of d. Relative precision 3% to 4%
A 0.0200 gram blood sample was decomposed by a microwave digestion technique followed by dilution to 100.0 mL in a volumetric flask. Aliquots of the sample solution were treated with a lead complexing reagent and water as follows: Solution 1: 10.0 ml blood sample + 20.0 mL complexing agent + 30.0 mL H20. Solution 2: 10.0 ml blood sample + 20.0 mL complexing agent + 26.0 mL H20 + 4.00 mL of 78 ppb Pb2+ standard. The resulting solutions were analyzed by UV/Vis at 375 nm. Absorbance for solution 1 = 0.155 and for solution 2 = 0.216. Calculate the concentration of lead (ppb) in the original sample.
5.00 mL of stock solution is diluted to 25.00 mL, producing solution ALPHA. 10.00 mL of solution ALPHA is diluted to 25.00 mL, resulting in solution BETA. 10.00 mL of solution BETA is then diluted to 25.00 mL, producing solution GAMMA. dilution factor for ALPHA from stock solution = 0.167 dilution factor for BETA from ALPHA solution = 0.0476 part c and d?
What is the experimental purpose of constructing a standard curve? a. To achieve an appropriate dilution factor for SDS-PAGE b. To verify the concentrations of the Bradford reagent within known parameters c. To produce a linear equation to estimate analyte concentration d. To verify that the serial dilution was properly conducted
What effect will the following have on plate height (H). Make sure to explain your full and complete reasoning. Reducing the rate of sample injection.
I have struggled to get the answer. A classmate said it was 159, though I would like to see the steps in demensional analysis, with correct sig figs. thank you! Provide only typed solution answer no handwritten solution needed
a. A 1.59 g sample containing KI was analyzed gravimetrically and 0.0538 g of Barium iodate was recovered. Express the results of this analysis as percent potassium iodide. b. What are the 4 most common reagents for open vessel decomposition of inorganic analytical samples?