Question 3A common-source amplifier using an E-MOSFET is shown in Figure 2.(a) Determine Vos, Io, Vos, ac output voltage and voltage gain. Assume that for this particular device,Incen) - 300 mA at Vos=6 V, Vosth- 3 V, and gm= 50 ms, Vin= 100 mV.(b) If load resistor R and bypass capacitor C; is removed, evaluate the effect of ac output voltage andvoltage gain in relative to their values in Question 3(a).VDD+15 VRp3.3 k2C24.7 MQ10 μΕ0.01 μFR2820 klRL33 klFigure 2

We need to find out dc voltage and current and Gain and output voltage for given input voltage .

Question 3 A common-source amplifier using an E-MOSFET is shown in Figure 2. (a) Determine Ves, Io. Vos, ac output voltage and voltage gain. Assume that for this particular device, Incen) - 300 mA at Vos=6 V, Vosiar- 3 V, and g= 50 mS, Va= 100 mV. (b) If load resistor R2 and bypass capacitor C; is removed, evaluate the effect of ac output voltage and voltage gain in relative to their values in Question 3(a). VDD +15 V Rp C2 3.3 kf2 Vout 4.7 MN 10 µF 0.01 µF R2 820 kf2 R 33 kn Figure 2

Question 3 A common-source amplifier using an E-MOSFET is shown in Figure 2. (a) Determine Ves, Io. Vos, ac output voltage and voltage gain. Assume that for this particular device, Incen) - 300 mA at Vos=6 V, Vosiar- 3 V, and g= 50 mS, Va= 100 mV. (b) If load resistor R2 and bypass capacitor C; is removed, evaluate the effect of ac output voltage and voltage gain in relative to their values in Question 3(a). VDD +15 V Rp C2 3.3 kf2 Vout 4.7 MN 10 µF 0.01 µF R2 820 kf2 R 33 kn Figure 2

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter25: Television, Telephone, And Low-voltage Signal Systems

Section25.1: Television Circuit

Problem 5R: From a cost standpoint, which system is more economical to install: a master amplifier distribution...

See similar textbooks

Similar questions

Draw the equivalent circuit for a common-emitter bipolar transistor amplifier andderive suitable formulae for the amplifier current gain, voltage gain and power gain.Neglect bias,decoupling and coupling components
For the BJT amplifier circuit of figure below with the following parameters:β = hfe ≈ 250, re= 20.3Ω, and ro = 1/hoe ≈ ∞ Ω, Zb= 50.26KΩ determine:(a) Draw the Ac equivalent circuit in re- model and hybrid model.(b) hie, , Zi , and Zo'(c) Av using h- model.(d) Avs and ac output voltage
a.) Consider a two-BJT configuration in Figure 1. You may assume that both transistors are the same with the same β, VBE,on = 0.7 V, and VCE,EOS = 0.3 V. Determine the minimum voltage VBE that will turn ON both Q1 and Q2. b.) Using the BJT small-signal model given in Figure 2, determine the AC current gain Ai = iout/iin for the circuit given in Figure 3. Assume ro >> rπ. You may assume that β is large.
Vs=100 mV peak-to-peak, 1 kHz sine signal, Kn=0.4mA/v^2 ,Vt=1V , λ=0.01V^-1 Make the DC analysis of the above given mosfet amplifier circuit. Simulation to tableWrite down the measured values and mathematical calculation results. (The valueswith the units.)DC Parameters ,Measured value ,Calculated ValueVGETCVGSVDVDSIDb. Draw the small signal model for the AC analysis of the circuit. Find the gm, ro, Av values.c. Show the Vs input signal and the Vo output signal of the circuit on the oscilloscope. Volt/div of channels andSpecify time/div values.
Draw the circuit diagram of a resistance–capacitance coupled common-source amplifier.
A base voltage of four volts is applied to an NPN bipolar junction transistor. A twenty kilo ohm resistor is linked to the base, while a hundred kilo ohm resistor is connected to the collector. The Collector is powered by a six volt supply voltage. Assume the transistor is in active mode, with a fifty common Emitter current gain(β).(i) Utilize the dc equivalent model of the transistor to draw the circuit design.(ii) Calculate the Collector current (IC) and the Base current (IB) .ii) Locate/determine the result (VCE).
The multistage amplifier circuit of Figure Q.2(b) have the following parameters:Q1 and Q2 : β = 200, VBE = 0.7 V, VT = 26 mV , VA = ∞Given that ICQ1 = 2 mA and VCEQ1 = 2 V. (i) Determine the value for RB4. List the assumption/approximation made in the analysis.(ii) Sketch and label the small-signal hybrid-π equivalent circuit at midbandfrequency range.(iii) Calculate the small signal hybrid-π model parameters: gm and rπ for Q1 and Q2. Then, determine Zi2 and Zo.
Fixed-bias configuration, Emitter-bias configuration, and Voltage-divider configuration- rank these three configurations based on their provided stability (i.e. ? independency)to the operating point. Use mathematical terms/equations to explain and justify your
In the circuit given in the figure, Vcc = 15V, R1 = R2 = 10k ohm, RE = 1k ohm, RL = 0.5k ohm and transistor parameters are given as VBE = 0.7V, beta (dc) = beta (0) = 100. According to this;a) Calculate the values of DC bias currents and voltages (I (BQ), I (CQ), V (CEQ)).b) Using the hybrid model of the transistor, draw the small signal equivalent circuit of the circuit.c) Derive the input impedance expression of the circuit and calculate its value.d) Derive the voltage gain expressions A (vi) and A (VG) and calculate its value.e) Derive the current gain expression A (i) = I (0) / I (i) and calculate its value. I sent you question's image. Thank you..
Instruction/s: Draw, Illustrate and label your schematic diagram before solving the problem.2.) Given a Collector -Feedback Biased transistor circuit with voltage at common collector is +10v ,base resistor is 100k ohms, Collector resistor is 10k ohms and Base current is 8.38 micro ampere, ,Voltage at Base-emitter junction is 0.7v. Determine Beta DC , Collector current and Voltage at collector-emitter junction. These might help as a guide to answer the problem...
In the common-emitter amplifier circuit shown in the figure, Vcc=9V, R1=27kΩ, R2=15kΩ, RE=1.2kΩ and RC=2.2kΩ. The transistor has β=100.a-) If Rsig=10kΩ and RL=2kΩ, calculate the IE value of the amplifier.b-) For small signal analysis of the transistor, find the value of Rin by deriving the π-modelc-) Calculate vo/vsig and io/ii.
A.What is the phase relationship between the AC input and output voltages in a common emitter amplifier ? What is the reason for the phase reversal ? B.What is the phase relationship between the ac input and output signal voltages in conmmon bas amplifier?what is the reason?