QUESTION 4 A settling analysis is run on a Type 1 suspension in a laboratory column with a port of 1.9m below the suspension surface. The data obtained are shown below. Time (min) TSS (conc,mg/L) 0 220 3 116 5 98 10 75 20 35 40 10 60 2 What is the theoretical removal efficiency in a settling basin for an overflow of 440 m2/m.day?

QUESTION 4 A settling analysis is run on a Type 1 suspension in a laboratory column with a port of 1.9m below the suspension surface. The data obtained are shown below. Time (min) TSS (conc,mg/L) 0 220 3 116 5 98 10 75 20 35 40 10 60 2 What is the theoretical removal efficiency in a settling basin for an overflow of 440 m2/m.day?

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter16: Soil Improvement And Ground Modification

Section: Chapter Questions

Problem 16.10P

See similar textbooks

Similar questions

A column analysis of a flocculating suspension is run in the apparatus shown below. Theinitial solids concentration is 320 mg/L. The resulting matrix is shown below. What willbe the overall removal efficiency of a settling basin which is 2.5 m deep with a detentiontime of 2 hr?
In a constant head permeameter test, the length of the specimen is 200 mm and the cross-sectionalarea is 78.5 cm2. If k = 2.1 x 10-2cm/sec, and a rate of flow of 130 cm3/min must be maintainedduring the test, what should be the head difference across the specimen?
For a homogeneous earth dam 32 m high and 2 m free board, a flow net was constructed with four flow channels. The number of potential drops was 20. The dam has a horizontal filter at the base near the toe. The coefficient of permeability of the soil was 9 × 10^–2 mm/s. Determine the anticipated seepage in m^3/s, if the length of the dam is 100 metres. a.0.98 b.0.120 c.0.054 d.0.045
) A pumping test carried out in a 50 m thick confined aquifer resulted in a flow rate of 600l/min. The thickness of the impermeable layer above the aquifer is 20 m and the originalwater level in the well was 2 mm below the ground surface (which is also the top of theimpermeable layer). Drawdowns in two observation wells located 50 m and 100 m fromthe well are 3 and 1 m respectively. Calculate:i) The coefficient of permeability of the aquifer, ii) The drawdown in the well, iii) The radius of influence. The diameter of the well is 0.6 m.
In order to compute the seepage loss through the foundation of a cofferdam, flownets were constructed. The result of the flownet study gave Nf = 6, Nd = 16. The head lost during seepage was 19.68 ft. If the hydraulic conductivity of the soil is k = 13.12 x 10-5 ft/min, compute the seepage loss per foot length of the dam per day. a.1.9 ft3/day/foot length of the dam b.1.95 ft3/day/foot length of the dam c.1.39 ft3/day/foot length of the dam d.2.9 ft3/day/foot length of the dam e.2.25 ft3/day/foot length of the dam
A rectangular sedimentation tank has dimensional proportions of 10:1:3 (L:W:H). If sedimentation is done in batch, the tank can cater 1080 m^3 in one hour, while the detention time for a continuous settling is 15 minutes on the same tank. a) During batch sedimentation, how many batches is done in an hour? b) Solve the dimensions of the tank. c) If the critical settling velocity is 0.003m/s, how many percent of the solids will be settled down? d) If the influent has a solids concentration of 230 mg/L and the effluent is 90% of the influent, compute the solids concentrations both at the underflow and the overflow. e) Determine the filter area if the filter loading rate is 2.3 gal/d.ft. ANSWER D AND E I PROVIDED SOME INFORMATION THANK YOU!
A rectangular sedimentation tank has dimensional proportions of 10:1:3 (L:W:H). If sedimentation is done in batch, the tank can cater 1080 m^3 in one hour, while the detention time for a continuous settling is 15 minutes on the same tank. a) During batch sedimentation, how many batches is done in an hour? b) Solve the dimensions of the tank. c) If the critical settling velocity is 0.003m/s, how many percent of the solids will be settled down? d) If the influent has a solids concentration of 230 mg/L and the effluent is 90% of the influent, compute the solids concentrations both at the underflow and the overflow. e) Determine the filter area if the filter loading rate is 2.3 gal/d.ft.
A constant-head permeability test is performed where the hydraulic gradient is 0.75. The crosssectional area of the sample is 0.25 ft2. The quantity of water flowing through the sample is measured to be 0.004 ft3/minute. (a) What is the coefficient of permeability in feet per minute? (b) What is the coefficient of permeability in millimeters per second?
5. The coefficient of permeability of a sand at a void ratio of 0.62 is 0.03 cm/sec. Estimate the coefficient of permeability at a void ratio of 0.48. Using Casagandre equation Using Kozeny-Carman equation Find the difference in the rate of flow using the results of “a” and “b” if i = 0.70 and A = 0.6 m2.
Pumping test was carried out in a layer of soil extending to a depth of 28 m. The initial position of water table is located 4 m below the ground. Observation wells were sighted 33.5 m & 97.5 m from the pumping well. Water is pump at 248.4 m3/hr and when steady level was attained, the drawdowns at the observation wells were observed to be 1.1 m and 0.54 m, respectively. Compute the coefficient of permeability in m/day. CHOICES A. 64.82 m/day B. 71.49 m/day C. 71.49 m/day D. 78.09 m/day
For a falling-head permeability test, the following values are given: Length of specimen = 200 mm Area of soil specimen = 1000 mm^2 Area of standpipe = 40 mm^2 Head difference at time t = 0 = 500 mm Head difference at timt t = 3 minutes = 300 mm Determine the hydraulic conductivity of the soil in ×10−4cmsec Please answer this asap. For upvote. Thank you very much
The following data relate to a pump-out test: Diameter of well = 24 cm; Thickness of confined aquifer = 27 m; Radius of circle of influence = 333 m; Draw down during the test = 4.5 m; Discharge = 0.9 m^3/s.What is the permeability of the aquifer in mm/s? Choices: a. 2.15 x 10^-2 b. 4.5 x 10^-1 c. 93 X 10^-1 d. 1.6 X 10^-1