Quiz /A combination of a heat engine driving a heat pump, the heat energy supplied to the heat engine is 5040 J, and the temperature of the hot reservoir Tmin is 30 °C and the thermal efficiency of the heat engine is 41%. The work energy W12 of heat engine goes to the heat pump that the coefficient of performance COPHP 1.3. Find: а) The Tmax of the heat engine, b) The work done between two engines c) Qrej of the heat pump Tmax 150 °C Qadd = 5040 J Н.Е. W 12, Н.Р. Qrej 30 °C T min

Quiz /A combination of a heat engine driving a heat pump, the heat energy supplied to the heat engine is 5040 J, and the temperature of the hot reservoir Tmin is 30 °C and the thermal efficiency of the heat engine is 41%. The work energy W12 of heat engine goes to the heat pump that the coefficient of performance COPHP 1.3. Find: а) The Tmax of the heat engine, b) The work done between two engines c) Qrej of the heat pump Tmax 150 °C Qadd = 5040 J Н.Е. W 12, Н.Р. Qrej 30 °C T min

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A power station with an efficiency e generates W watts of electric power and dissipates D J of heat energy each second to the cooling water that flows through it. The cooling water increases its temperature by T degrees of Celsius. Find the mass of cooling water which flows through the plant each second. Specific heat capacity of water cw = 4,184 J/kgC e = 0.2W = 4.9 x 108 wattsD = 2.5 x 108 JT = 4 C Enter value in tons (1 ton = 1000 kg).Enter two digits after decimal point.
during the working stroke of an engine the heat transferred out of the system was 160kJ/kg of working substance. the internal energy also decreased by 405kJ/kg of working substance. Determine the work done
Energy balance results (in kW) obtained for the same medium speed single cylinder diesel engine are reported in the following table. For case 1, if the coolant temperature is 105 °C at the outlet of the engine and the volumetric flow rate is 0.22*10-3 m3/s, the temperature of the coolant at the inlet is (in °C): (The coolant is considered water with a density 999 kg/m3 and a specific heat 4.2 k/kg.K). Case N (rpm) bmep (bar) W. O ambient Q ahast shaft 2.2 4.2 19.1 60.3 9.90 3.52 1 500 7.1 24.5 23.8 500 6.1 3.6 5.2 400 3.50 4.9 4.1 1.4 Select one: O a. 142.1 O b. 112.7 O c. 97.31 O d. 87.2 O e. 370.31
Pls. Answer thank you! A cooling tower has an efficiency of 65%. Water enters the tower at 55°C. The wet bulb temperature of surrounding air is 27°C. What is the temperature of water leaving the tower?
The mechanical efficiency and static pressure of fan are 44.3% and 20 m of air respectively. What is the static efficiency if the total pressure created by fan is 25 m of air?
A-3.2. Suppose a large tank of water with a temperature of just over 0 Cwe put in a 100 g ice cube. When the ice melts, it absorbs 33 kJ of heat. What is theentropy change of a) (ice) system, b) environment (water tank)?
Suppose that in some location, thermal solar electricity can be produced at a cost of 4¢ per kilowatt hour (kWh), while electricity from coal costs 3.5¢ per kWh (note that thermal solar can be stored up and released overnight, so you can assume that there are no problems with intermittency). Suppose there is enough coal to last 100 more years at current use levels, and suppose for now that virtually all of the cost of making electricity from coal is the coal itself.7 If the real rate of interest is 2%, what do you expect to happen to the current price of coal?
Renewable Energy Systems (a) During the winter heating season of 180 days an office is heated continuously for 10 hours a dayby a 3kW electric heater. Assuming the heater is only used during the heating season determine howmany gigajoules and kilowatt hours are consumed by the heater annually. (b) Calculate the available power for two hydro schemes. One of the scheme has a flow rate of 3.4litres/second. And the other is a large river with a flow of 100 m3/ second. Both have an effective headwhich is 80% of the actual head. The actual head is 125m for each. And the plant efficiency is 83% foreach
Pls. answer thank you! A steam turbine of 6 MW capacity has a Willan's line equation of ms = 5.52 + 3.200 kg/hr. Determine the steam consumption at 63% load, kg/hr.
give a specific example of a process that has the energy changes and transfers described. (For example, if the question states “ΔEth > 0, W = 0,” you are to describe a process that has an increase in thermal energy and no transfer of energy by work. You could write “Heating a pan of water on the stove.”) ΔEth < 0, W ≠ 0, Q ≠ 0
A regional electric utility company has a power plant with 1000 MW of electricity. The overall thermal efficiency of the power plant is 25%. The fuel used in the plant is an oil with a heating value of 5.00 ´106 kJ/kg and costs PHP 3.75 per liter. The density of the oil is 0.90 kg/L. Determine: (a) the daily fuel requirement (kg) when the plant runs at maximum capacity.(b) the daily fuel cost (PHP) of running the plant at maximum capacity.There are two answers: one for (a), one for (b).
a) The velocity ratio (VR) b) The mechanical advantage c) The efficiency, Answer in % d) The ideal effort (P1). Answer in N