Quiz Determine the value of ix and V. 20/30° V 60Hz 10 £2 www ΤΗ -m 0.1 F 0.5 H V

Q: xplain the working of Doubly Fed Induction Generator and its characteristics?

A: The working of Doubly Fed Induction Generator and its characteristics

Q: A 1 MHz carrier of 10V amplitude, when frequecny modulated by a 400 Hz, 1V modulating signal, under…

A: Given, fc=1 MHzAc=10 Vfm1=400 HzAm1=1 V∆f=1 kHzfm2=1 kHzAm2=2 V

Q: What do you understand on extra-terrestial and terrestrial solar radiation

A: The sun is source of energy. It provides energy in the form of light and heat. The solar radiation…

Q: A two-stage power amplifier with a 50 dB gain and loss of -10 dB has an output power of 100 W. What…

A: We need to find out the input power for given output power and gain

Q: Discuss solar energy in future power system

A: In the given question we need to discuss solar energy in future power system.

Q: if the Laplace inverse transform of the following function is asin(3t). what is a ? ²+9 O a. 2/3 O…

A: The given function is,  4s2+9 Using the inverse Laplace transform,…

Q: :) Consider the JFET self-bias configuration circuit. Given that V₂= -8V and Ipss = 12mA. Assume VDD…

A: It is given that: VP=-8 VIDSS=12 mA=12×10-3 AVDD=20 VRD=3.3 KΩRG=1 MΩRS=1 KΩ

Q: 1- State if the following pulses are Nyquist pulse or not: (a) (b) -4 -2 4 P(t) 1 p(f) A 24 f T = 2…

A:

Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * R1 -12.7 V…

A:

Q: (a) Figure 1 shows a circuit that consists of two silicon diodes, D₁ and D₂. Using ideal model…

A:

Q: 2. The voltage and current in ac circuit are v = 100 sin (377t-30°) V and i = 6 sin (377t +30°) A.…

A: Given: v=100sin(377t-30°) Vi=6sin(377t+30°)A

Q: Design an astable 555 timer circuit to produce 1kHz square wave, where TH=0.35 ms and T₁ = 0.65 ms.…

A: Given: Output frequency f= 1kHz.           TH=TON=0.35 ms           TL=TOFF=0.65 ms…

Q: Determine the maximum bit rate for an FSK signal with a mark frequency of 48 kHz, 52 kHz space…

A:

Q: A 10 mH inductor, a 1 uF capacitor, and a variable resistor are connected in parallel in the circuit…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: f preceden

A: Given as,

Q: Problem No. 1. Using mesh analysis, solve for Vo. B=100 9 Volts Vb Rb 20 KOhms Rc 500 Ohms C V₁ =?…

A: In this question,  We need to determine the Voltage Vo as shown the circuit.  The current gain,…

Q: The result of u(t + 3) * u(t - 5) is: Select one: tu(t) (t-1)u(t-1) (t+3)u(t+3) (t-2)u(t - 2)

A: Given: Expression: ut+3*ut-5

Q: 11.a. In dwelling units, motels, hotels, and other occupancies such as dormitories, nursing homes,…

A: When feeder current exceeds 200 A then the demand factor of 70 % applied to excess current Suppose…

Q: The angle between EA and Vϕ is called the power angle Select one: True False

A:

Q: Q1. Find the values of resistance R and inductance L in the circuit of Fig. 1.

A: The required parameters can be calculated by computing the total impedance of the circuit and by…

Q: Convert 100 watts of power into dBW? Show all steps

A: Given data, Power is given P = 100 W

Q: Convert 100 watts of power into its equivalent power in dBm.

A: Given, Power (P) = 100 watts

Q: Find the output voltage for the following circuit. ( TOMA 15ks M 5 ksv 30k 25kr ww ww loke till…

A:

Q: site, a Static Cone Penetratio carried out. The measured p esistance q was 1000 kPa in depth. The…

A: Given: Friction ratio-1% Measured point resistance- 1000 kPa

Q: D6.27 The circuit of Fig. 6.27(a) is to be fabricated using a transistor type whose ß is specified…

A: The given circuit can be analyzed by using the DC analysis of the circuit. If the voltage at…

Q: minals (see fig 3) ? alent circuit for the network in fig 4. through terminals A B and C in fig 5. -…

A:

Q: find 1₁, 12, and i3 in the circuit displayed 60 cos (127t-10°) V iz 100 92 70 92 W 3 H m 1.5 H 1 H…

A:

Q: Quiz Determine the value of ix and V. 20/30° V 60Hz 10 92 www 1H m 0.1 F ele 0.5 H V

A: Current remains the same in the series-connected circuit but they differ in parallel circuit Voltage…

Q: blackboard.ncat.edu Remaining Time: 1 hour, 17 minutes, 25 seconds. A Moving to the next question *…

A: The given circuit diagram is shown below:

Q: Determine the Fourier series representation for the signal x (t) shown in Fig. P. 4.2.9.

A:

Q: A zener diode has a power rating of 4W and zener voltage of 20V. The maximum current it can safely…

A: We need to find out the current for zener diode .

Q: 3.15P) The excess electron concentration and Electic field is plotted in a bar of an n-type…

A: Semiconductor: Any member of a family of crystalline solids known as a semiconductor falls into the…

Q: in the circuit shown, what current flows through the 18 Q resistor?

A:

Q: What is the magnitude of the force required to stretch a 10 cm-long spring, with spring of 100 N/m,…

A: here we have to find the force required to stretch the 10 cm long spring , with spring constant of…

Q: Find the solution to linear constant coefficient difference equation y(n)= (1/2) y(n-1) + x(n) with…

A:

Q: Calculate the maximum bit rate for an FSK signal with a mark frequency of 102 kHz, 104 kHz space…

A:

Q: The maximum load current that can be drawn is 30 V O2.3 mA O 2.5 mA O 1.4 mA O 1.8 mA 15 kQ ww V₂=9V…

A: We need to find out maximum current through load .

Q: equal to: 05 on The function F(s) = 58² +1 8(8²+5) has a final value

A: Given data, Function is given, Fs=5s2+1ss2+5

Q: 5. 85.5J of energy are converted into heat in nine seconds. What power is dissipated? [9.5 W]

A: Given, Energy, E = 85.5 J Time, t = 9 seconds

Q: Describe power system interconnection ecperience in the world

A: The network of the power system is connected to other networks. It denotes that every generator is…

Q: What is wrong with this dioce? XMM1 Short Not enough data O Nothing O Open 12 IDEAL DIODE…

A: For the given circuit diagram we need to find its correctness.

Q: A substation has two feeders, Sub Feeder-A have demand at a time is 35 KW and Sub Feeder-B have…

A: Given: Sub Feeder 1 demand at a time is 35 kW Sub Feeder 2 demand at a time is 42 kW Max demand of…

Q: The color code of a resistance is given below. The values of resistance and tolerance, respectively,…

A: Given data, Color band is given as,

Q: In GSM, a "TDMA frame" is composed of eight distinct time slots. Each GSM time slot is 577 s…

A: It is given that: A TDMA frame is composed of eight distinct time slots. GSM time slot is 577 μs.…

Q: converter topologies in pv system

A: It is asked to discuss about the converter topologies in PV system.

Q: For op-amp circuit shown in fig. 10.80, Determine the bandwidth with feedback when the gain…

A: For the circuit shown in the figure, Gain * BW = 2.6 x 108 Hz   with feedback So if we are able to…

Q: Define maximum power point tracker . Write its various strategies used for operation of mppt

A: MPPT is classified below.

Q: +Q0 I R S1 (close at t=0)

A:

Q: Which of the following is a causal and stable system: Select one: O y(t) = tx(t) + 3 O y(t) =…

A: Given data, In option (i) function is given as txt+3 here xt is multiplied with t so it will be a…

Q: Find Vx, Vy, Vz. Vx = nodal voltage at the node where R1, R2, and R3 meet Vy = nodal voltage at…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.