E 1) ListenRC Circuit - DischargingYou have an RC Circuit - a Resistor and Capacitor (in series) hooked up to eachother. The capacitor is initially charged to a voltage of V. You allow the capacitor todischarge through the resistor, using up its energy.Voltage vs. Time Capacitor0.368 Vo1T2т374т57Time (s)C = 73.00 microFarads (UF)Initial Voltage = 9.50 VAt a time of 11.50 seconds after you start discharging the capacitor, the capacitorhas a voltage that is 77.0 % of the initial voltage across the capacitor. What is thevalue of the resistor? Put your answer in kilo Ohms (kS2).Your Answer:AnswerVoltage (V)

Answered: Image /qna-images/answer/482c6fd7-c424-45d5-aeb8-cbde852a7fa8.jpg

RC Circuit - Discharging You have an RC Circuit - a Resistor and Capacitor (in series) hooked up to each other. The capacitor is initially charged to a voltage of V. You allow the capacitor to discharge through the resistor, using up its energy. Voltage vs. Time Capacitor Vo 0.368 Vo 1T 27 37 4т 57 Time (s) C = 73.00 microFarads (UF) Initial Voltage = 9.50 V has a voltage that is 77.0 % of the initial voltage across the capacitor. What is the value of the resistor? Put your answer in kilo Ohms (kS2). At a time of 11.50 seconds after you start discharging the capacitor, the capacitor Your Answer: Answer Voltage (V)

RC Circuit - Discharging You have an RC Circuit - a Resistor and Capacitor (in series) hooked up to each other. The capacitor is initially charged to a voltage of V. You allow the capacitor to discharge through the resistor, using up its energy. Voltage vs. Time Capacitor Vo 0.368 Vo 1T 27 37 4т 57 Time (s) C = 73.00 microFarads (UF) Initial Voltage = 9.50 V has a voltage that is 77.0 % of the initial voltage across the capacitor. What is the value of the resistor? Put your answer in kilo Ohms (kS2). At a time of 11.50 seconds after you start discharging the capacitor, the capacitor Your Answer: Answer Voltage (V)

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 33CQ: Draw two graphs of charge versus time on a capacitor. Draw one for charging an initially uncharged...

See similar textbooks

Similar questions

Draw two graphs of charge versus time on a capacitor. Draw one for charging an initially uncharged capacitor in series with a resistor, as in the circuit in Figure 21.38, starting from t = 0. Draw the other for discharging a capacitor through a resistor, as in the circuit in Figure 21.39, starting at t = 0, with an initial charge Q0. Show at least two intervals of t.
A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?
A 500- resistor, an uncharged 1.50-F capacitor and a 6.16-V emf are connected in series, (a) What is the initial current? (b) What is the RC time constant? (c) What is the current after one time constant? (d) What is the voltage on the capacitor after one time constant?
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
The- pair of capacitors in Figure P28.63 are fully charged by a 12.0-V battery. The battery is disconnected, and the switch is then closed. Alter 1.00 ms has elapsed, (a) how much charge remains 011 the 3.00-F capacitor? (b) How much charge remains on the 2.00-F capacitor? (c) What is the current in the resistor at this time?
Figure P18.26 shows a voltage divider, a circuit used to obtain a desired voltage Vout from a source voltage . Determine the required value of R2 if = 5.00 V, Vout = 1.50 V and R1 = 1.00 103 (Hint: Use Kirchhoff's loop rule, substituting Vout = IR2, to find the current. Then solve Ohms law for R2. Figure P18.26
Figure P18.26 shows a voltage divider, a circuit used to obtain a desired voltage Vout from a source voltage . Determine the required value of R2 if = 5.00 V, Vout = 1.50 V and R1 = 1.00 103 (Hint: Use Kirchhoff's loop rule, substituting Vout = IR2, to find the current. Then solve Ohms law for R2. Figure P18.26
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
Lightbulb A is marked 25.0 W 120. V, and lightbulb B is marked 100. W 120. V. These labels mean that each lightbulb has its respective power delivered to it when it is connected to a constant 120.-V source. (a) Find the resistance of each lightbulb. (b) During what time interval does 1.00 C pass into lightbulb A? (c) Is this charge different upon its exit versus its entry into the lightbulb? Explain. (d) In what time interval does 1.00 J pass into lightbulb A? (e) By what mechanisms does this energy enter and exit the lightbulb? Explain. (f) Find the cost of running lightbulb A continuously for 30.0 days, assuming the electric company sells its product at 0.110 per kWh.
A student makes a homemade resistor from a graphite pencil 5.00 cm long, where the graphite is 0.05 mm indiameter. The resistivity of the graphite is =1.38102/m . The homemade resistor is place inseries with a switch, a 10.00-mF capacitor and a 0.50-V power source, (a) What is the BC time constant of the circuit? (b) What is the potential drop across the pencil 1.00 s after the switch is closed?
Construe! Your Own Problem Consider a rechargeable lithium cell that is to be used to power a camcorder. Construct a problem in which you calculate the internal resistance of the cell during normal operation. Also, calculate the minimum voltage output of a battery charger to be used to recharge your lithium cell. Among the things to be considered are the emf and useful terminal voltage of a lithium cell and the current it should be able to supply to a camcorder.
A 20.00-ohm; 5.00-watt resistor is placed in series with a power supply, (a) What is the maxim tun voltage that can be applied to the resistor without hanniug the resistor? (b) What would be the current through the resistor?