Read the problems carefully and provide complete solutions with derivation of formulas (integrals and derivatives. Give complete and neat solution. Use two decimal places for final answers only. Final answers shown below are incomplete. A 900 kg car is sliding down a hill side after the handbrake is disengaged. The hill has a height of 20 m and a 200kg box is placed at the bottom. At what velocity will the car hit the box? What velocity will the box and car have if the collision is perfectly elastic? At what rate is the box moving away from the car, as observed by the driver? 19.81ms; 12.61ms; 32.42ms; 19.81ms

Read the problems carefully and provide complete solutions with derivation of formulas (integrals and derivatives. Give complete and neat solution. Use two decimal places for final answers only. Final answers shown below are incomplete. A 900 kg car is sliding down a hill side after the handbrake is disengaged. The hill has a height of 20 m and a 200kg box is placed at the bottom. At what velocity will the car hit the box? What velocity will the box and car have if the collision is perfectly elastic? At what rate is the box moving away from the car, as observed by the driver? 19.81ms; 12.61ms; 32.42ms; 19.81ms

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A uniform block measuring 40 cm x 20 cm wighs 1000 N. The width of the block is in contact with the surface of the plane with slop of x = 4 and y = 3. It is pulled up the incline by the force of 1500 N. The coefficient of friction is 0.20. Determine the following:1. the maximum height of the force from the incline so that the block does not tip over as it slides up the incline. Answer in 1 decimal place.2. the minimum height of the force from the incline so that the block does not tip over as it slides up the incline. Answer in 2 decimal places
A 100 lb block rests on a frictionless surface. Determine the acceleration of the block (which means magnitude and direction) if the angle α = 30° and Force A = 60 lb. Please include FBD. I think that is where problem is falling apart for me.
In a rope-climbing competition, all of the lifting is done by the arms; legs can only dangle. Imagine 220-lb Garvin Smith in training, hanging stationary from the rope, his legs off the floor. When prompted by his coach, he rapidly lifts his center of mass by 4 ft. in 0.65 s. Calculate Garvin Smith's acceleration. Round the final answer to one decimal place. Determine the net force (“force imbalance”) producing the acceleration. Round the final answer to one decimal place. Which forces are acting on Smith? (Note that his arms are part of himself, so they cannot exert a force on Smith.) With what magnitude force is Smith pulling down on the rope? Round the final answer to one decimal place. The force of 130.2 lb points _____.
A heavy industrial block slides from rest from point A down a plane inclined 30 degrees to the horizontal. After reaching the bottom of the plane, the block moves on the horizontal floor at a distance 2m before coming to rest. If the coefficient of friction between the block and plane and between block and floor is 0.40, what is the distance of point A from the intersection of the plane and the floor? Answer in meters and 2 decimal places
In an amusement park ride, riders stand against the vertical wall of a spinning cylinder. The floor falls away and the riders are held up by friction. If the radius of the cylinder is R, find the minimum number of revolutions per time necessary if the coefficient of friction between a rider and the wall is given.
Given the figure before, when the displacement of block D is 360 ft, then the displacement of block A is closest to:
To climb a 400 meter high mountain, you have two options, a straight line route with a 40 ° slope or a route composed of 5 equal sections (same length) each with a 20 ° slope. If traveling in a car with a mass of 1280 kg and a maximum power of 88 kW, Determine (assume the whole car as a particle): a) Is the friction enough to prevent the car from sliding? The coefficient of static friction of the tires with the ground is 0.95. b) What is the power required to climb the 40 ° slope at a constant speed of 40 km / h? Does the car have enough power to go up at that speed? c) What is the constant speed at which the 40 ° slope can be climbed with a 60 kW power? d) What is the power required to climb a 20 ° slope at 40 km/h? Does the car has enough power to go up at that speed? e) In which of the two trajectories does the car do more work? Ignore the resistance of the air and rolling resistance and radius of curves between sections of the compound route. Please add the free body diagram.
A sport car is traveling along a 12° banked road having a radius of curvature of 149 ft. The driver wants to increase his speed to 79 ft/s and wants to know which tires he must select. Determine (with 2 digits after the decimal point) the minimal required static friction between the tires and the road
30.A block is started from rest at the top of an inclined plane 6 meters long which makes45 degrees with the horizontal. The coefficient of friction between the block and theplane is 0.20. At the foot of the plane, the block continues to move along a horizontalsurface. If the coefficient of friction between the block and the horizontal surface is0.15, how far does the block go along the horizontal surface?
A 5kg block is pushed up along the slope as shown. The coefficient of kinetic friction is uk =0.2. Determine the speed of the block when it moves 2 m up the slope using Newton's Second Law. (Don't use the required method for this question)
a capsule attached to a line is being rotated in a vertical loop of radius of 15 meters determine: the required speed at the top of the loop for the capsule to fell three times its weight the required speed at the bottom of the loop for the capsule to feel three times its weight the required speed at the top of the loop for the capsule to feel weightless
pls send me answer of this question all the parts pls and i will rate you sure, pls solve a,b,c and d and also a and b A 200-kg dragster (racing car) exerts a constant force of 4000 N during a race. The coefficient of kinetic friction between the tires and the pavement is .15. If the drag strip is 1000 m long, determine:a. The net force on the dragster. b. The acceleration of the dragster. c. The time it takes for the dragster to finish the race.d. The dragster's velocity at the end of the race.The dragster now needs to slow down, so it opens a parachute. The force of air drag is 3500 N. The driver also locks the brakes of the dragster, and the coefficient of kinetic friction becomes .75. Determine:a. How long it will take to stop the dragster.b. The distance the dragster travels while stopping.