Refer to the soil profile shown in figure below CALCULATE TOTAL STRESS (ot) AT POINT B A G.W.T Sand 5m Ysat = 20. 9 B. Clay Ysat = 17. 8 4m Let the point A at depth "0", point B at depth "Sm". and point C at depth 9m Select one: Select one: O a. 102.3 KN/M2 Ob. 107 KN/M2 Oc. 109 KN/M2 O d. 104.5 KN/M2

Refer to the soil profile shown in figure below CALCULATE TOTAL STRESS (ot) AT POINT B A G.W.T Sand 5m Ysat = 20. 9 B. Clay Ysat = 17. 8 4m Let the point A at depth "0", point B at depth "Sm". and point C at depth 9m Select one: Select one: O a. 102.3 KN/M2 Ob. 107 KN/M2 Oc. 109 KN/M2 O d. 104.5 KN/M2

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter18: Sheet-pile Walls

Section: Chapter Questions

Problem 18.13P

See similar textbooks

Similar questions

An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 9from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the stress in kPa at depth of 20 m. Show free body diagram a.21.6 b.372.8 c.192.8 d.62.5
Refer to Figure 10.47. A exible rectangular area is subjected to a uniformly distributed load of q 5 330 kN/m2. Determine the increase in vertical stress, Dz, at a depth of z 5 6 m under points A, B, and C .details about me sending through pictures
An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 (from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the effective stress in kPa at a depth of 20 m. If the pore pressure at this point is shown by a piezometer to be 180 kPa. a. 62.5 b. 372.8 c. 192.8 d. 21.6
Consider the soil profile shown inFigure 1.4: How high should thegroundwater table rise/drop so thatthe effective stress at C is 130 kN/m2?
Given that: • stress contributed by q1 = 0.73 KN/m² • total increase in vertical stress = 46.36 KN/m² • if the magnitude of the two loads is combined as one, the horizontal distance = 1.80m Answer the ff: a) The stress contributed by q2 is b) What is the equivalent horizontal load if it is located 3 meters away from point A given that the said point experiences the same vertical stress increase given by the set-up? Note: Point A is at the same depth
The plan of a flexible circular loaded area is resisting the uniformly distributed load(q), 835 kN/m2 with the radius of 5.7 m. Illustrate and calculate the increase in thevertical stress (Δσ) at a depth of z = 7.2 m below point A which is immediately belowthe center.
The sand layer shown is 2.5m thick. Beneath the sand layer is a 1.8m thick clay layer, underneath the clay layer is a solid rock. Water table is at depth of 0.9 m below the ground surface. SAND: Ymoist= 23KN/m3 ; Ysat= 21KN/m3 CLAY: Ysat= 23 KN/m3 ; LL= 42% e=0.7 A.) Compute the overburden pressure at mid-clay layer. B.) Find the maximum surface pressure without exceeding a 139.5mm settlement in clay layer if it is assumed to be normally consolidated. C.) If surface pressure is 70kpa and pre-consolidation pressure is 80kpa, find the settlement in clay layer.
An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 9from consolidated undrained test with pore pressure measurement) The weight of fill per unit volume is 18.64 kN/m3. Compute the stress in kPa at depth of 20 m. a. 192.8 b. 62.5 c. 21.6 d. 372.8
The soil in a deposit underlying an area where a level ground surface exists has a unit weight of 22 kN/m3. Determine the principal stresses o1 and oz at a depth of 5 m below the soil surface if the lateral pressure is 0.50 of the vertical pressure. Adjust your answer to ZERO decimal places. 01 = kN/m2, 03 = kN/m2
Plz give the correct answer. Compute the intensities of active and passive earth pressure at depth of 8 m in dry cohesionless sand with an angle of internal friction of 30 degrees , and unit weight of 18kN / (m ^ 3) What will be the intensities of active and passive pressure if the water level rises to the level? Take the saturated unit weight of sand as 22kN / (m ^ 3) .
In a pressuremeter test in a soft saturated clay, the measuringcell volume Vo = 535 cm3, po =42.4 kN/m2,pf =326.5 kN/m2, vo =46 cm3, and vf = 180 cm3.Assuming Poisson’s ratio smsd to be 0.5 and using Figure3.31(attached), calculate the pressuremeter modulus (Ep).
Subject : Geotechnical Engineering If you don't know the solution please leave it. The plan of a flexible rectangular loaded area is shown. The uniformly distributed load on the flexible area (q) is 400 kN/m^2. Determine the increase in the vertical stress at a depth of z = 1m, 2m, and 3m below.