Regarding the recovery techniques used to control air pollution, what is stated in: a) They are used in intermediate air quality standards and the cyclone is an example of equipment used. b) They are used in atmospheric emissions and the incinerator is an example of equipment used. c) They are used in atmospheric emissions and the electrostatic precipitator is an example of equipment. d) They are used in final air quality standards and the bag filter is an example of equipment

Regarding the recovery techniques used to control air pollution, what is stated in: a) They are used in intermediate air quality standards and the cyclone is an example of equipment used. b) They are used in atmospheric emissions and the incinerator is an example of equipment used. c) They are used in atmospheric emissions and the electrostatic precipitator is an example of equipment. d) They are used in final air quality standards and the bag filter is an example of equipment

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter5: Separation Processes

Section: Chapter Questions

Problem 5.22P

See similar textbooks

Similar questions

Question - There is a small spill of a toxic material on a paved surface of a chemical plant. This spill has width 0.8 ft and a length of 2.5 ft. The wind is a 10 miles per hour in the direction parallel to the length of the spill. Estimate the rate of evaporation in grams per hour. There is no toxin in the air at time 0 and at infinite distance from the spill. Assume air to behave as an ideal gas. Assume the toxic material can be considered an ideal solution with psat = 22 mmHg. MWtoxin = 164.4 g/mol, Ptoxin =1.69 g/cm³, Pair = .001225 g/cm³, Hair= 0.0187 CP, MWair = 28.9 g/mol, Dtoxin,air = 0.0888 cm²/s.
QUESTION 2 Supposing you were part of the students who visited Barekease water treatment plant for a practical session during the semester in Kumasi. During the session, you had face to face interaction with the Water Engineer in charge of the chemical treatment unit a.) Discuss four (4) key factors that affect the selection of a disinfectant ) Examine five factors that influence disinfection efficacy and microbial inactivation ) A dual media filter is composed of 0.30 m anthracite (mean particle size 0.20 mm) that is placed over a 0.60 m layer of sand (mean particle size 0.70 mm) with a filtration rate of 9.78 m/h. Assume the grains sphericity ф= 0.75and porosity (ε)=0.40. Determine the head loss in the clean filter?
Describe briefly the nature and operation of dissolved air flotation used in drinking water treatment. Use sketches where appropriate.
In a wastewater treatment plant, the supply of oxygen supply is 073 kgO2/h is necessary underoperating conditions, using a mechanical aeration system. Calculate theStandard Oxygen Transfer Rate. Using relevant data: Liquid temperature: T = 23 ◦C, Altitude = 1000 m, DO concentration to be maintained in the liquid CL = 1.5 mg/L, α = 0.90, β = 0.95, θ = 1.024 (Note: calculate the required value if it is missing)
The air pollution control equipment on a municipal waste incinerator includes a fabric filter particle collector (known as a baghouse). The baghouse contains 424 cloth bags arranged in parallel, that is 1/424 of the flow goes through each bag. The gas flow rate into and out of the baghouse is 47 m3/s, and the concentration of particles entering the baghouse is 15 g/m3. In normal operation, the baghouse particulate discharge meets the regulatory limit of 24 mg/m3. when all 424 bags are in place and the emissions comply with the regulatory requirements: a) Calculate the fraction of particulate matter removed. b) Calculate the efficiency of particulate removal.
A water treatment plant with an average flow of Q = 0.044 m3/s treats its water with alum (Al2(SO4)3 ⦁14H2O) at a dose of 25 mg/L. Alum coagulation is used to remove particulate matter, reduce the concentration of organic matter, and reduce the alkalinity of the water. If the organic matter concentration is reduced from 8 mg/L to 3 mg/L, determine the total mass of alkalinity consumed and the total mass of dry solids removed per day.
Discuss the provision of the Solid Waste Disposal in Buildings. Discuss the Fire Requirements in Buildings.
Flue gas conditioning is extremely important for ESPa in some industries. Why?
5 apparatus or devices used for Flash, Fire, and Pour Points of lubricants and fuels
Propane is flowing in a 4-inch schedule 40 steel pipe at the minimum rate for which the flow is turbulent. Calculate the energy loss per 50 feet of pipe. Use Moody's diagram.
Propose an air pollution control device for an automobile factory that emits nitrogen oxides, carbon dioxides and hydrocarbons. Describe the respective concept of the control measure.
Different pollutants are generated in labs, offices, wards, and other parts of the hospital.