e-ServicesAcademic DepartmentsETC CIMSResistivity of silver is less than that of tungsten. If a tungsten wireand a silver wire are having the same length and area of crosssection, which of the following statements is true?Resistance of the tungsten wire is more than that of theO a.silver wireResistance of the tungsten wire is less than that of thesilver wireb.O c.Both wires are having the same resistanceO d. From the given information, a conclusion cannot be made

We need to tell which wire will have more resistance.

Resistivity of silver is less than that of tungsten. If a tungsten wire and a silver wire are having the same length and area of cross section, which of the following statements is true? O a. Resistance of the tungsten wire is more than that of the silver wire O b. Resistance of the tungsten wire is less than that of the silver wire Both wires are having the same resistance d. From the given information, a conclusion cannot be made

Resistivity of silver is less than that of tungsten. If a tungsten wire and a silver wire are having the same length and area of cross section, which of the following statements is true? O a. Resistance of the tungsten wire is more than that of the silver wire O b. Resistance of the tungsten wire is less than that of the silver wire Both wires are having the same resistance d. From the given information, a conclusion cannot be made

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Similar questions

A 12-guage gold wire has a length of 1 meter. (a) What would be the length of a silver 12-gauge wire with the same resistance? (b) What are their respective resistances at the temperature of boiling water?
Check Your Understanding A strain gauge is an electrical device to measure strain, as shown below. It consists of a flexible, insulating backing that supports a conduction foil pattern. The resistance of the foil changes as the backing is stretched. How does the strain gauge resistance change? Is the strain gauge affected by temperature changes?
What is the current in the element of an electric clothes dryer with a resistance of 7.4 Ω when it is connected to 240 V? Express your answer to two significant figures and include the appropriate units. I= How much charge passes through the element in 50 min? (Assume direct current.) Express your answer to two significant figures and include the appropriate units. Q=
What is the resistance of a 2.54-cm-diameter rod of pure silicon that is 20.0 cm long. What current flows through the rod when 1.00 × 103V is applied to it?
The resistivity of silver ρ = 1.61 x 10-8 Ω.m. If you have a length of silver wire that is 3.15 m in length, and that has a cross-sectional diameter of 482 μm, what is the resistance of that wire (in Ω, or Ohms)?
A wire 2.3m long has a diameter of 0.38mm. When connected to a 1.5V battery, there is a current of 0.60A through the wire. What is the resistivity of the wire? (include units) tip: p=RA/L
If the resistance of a copper wire at freezing OoC is 30Ω. What is the resistance at -40o C? The heating unit for an electronic iron has a resistance of 12Ω. If the cross-section of the material is rectangular (0.0045 x 0.125) in and its total length is 13ft. Determine the resistivity of the material used.
how do you find the cross-sectional of the wire and resistivity of a wire is given by R=ρlA given: diameter .40mm length 40m copper: 1.72x10^-8
The resistivity of copper is 1.72E-8 Ω×m. What is the resistance of a copper wire that is 27.5 m long and has a diameter of 7.99E-3 m (in Ω)?
What should be the internal resistance in a battery to provide the maximum power transfer to the load (Figure 1)?
As the potential across the resistor increased, the current through the resistor increased. If thechange in current is proportional to the potential difference, the data should be in a straight lineand the y-intercept should be zero. In the two resistor examples how close is the y-intercept tozero? Is there a proportional relationship between potential difference and current? If so, writethe equation for each resistor data set in the form V = mI. Use a numerical value for theproportionality constant, m. Compare the constant in each of the above equations to the resistance of each resistor.
When a potential difference of 12 V is applied to a wire 6.9 mlong and 0.33 mm in diameter, the result is an electric current of2.1 A. What is the resistivity of the wire?