-Series RLC ciranitAmplitnde of heVoltage Source is 120V- lesistor has a valve of 802a value of 8os2Reactance of ne capacitor is 480eThe vellage amplitadeacras thecapucitar is 360V(a) What is he amplitudeamplinadeof The curent within the cirenit?(b) What is he impedance of he circuit?(c) What are hwo possible readance valves fur he induchr and whoh orehas asmaller anqular freg vency Than resonancefrequency.

Given: Vs=120 VR =80ΩXc= 480 ΩVc=360 V

-Senies RLC circnit Ampli hade of he voltage Sourze is 120V - lesistur has a valve of 80s2 - Reactance of ne capacitor is 480e - The volge amplitade T acrass the capacito is 360V (a) What is the amplihde of ne curent within the citeuit? (b) What is Phe impedance of the cireuit? (c) What are huo possible reacance valves fur the and whoh. has a smaller anqular Geanency Than resong inductor,

-Senies RLC circnit Ampli hade of he voltage Sourze is 120V - lesistur has a valve of 80s2 - Reactance of ne capacitor is 480e - The volge amplitade T acrass the capacito is 360V (a) What is the amplihde of ne curent within the citeuit? (b) What is Phe impedance of the cireuit? (c) What are huo possible reacance valves fur the and whoh. has a smaller anqular Geanency Than resong inductor,

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 72CP: The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is...

See similar textbooks

Similar questions

Discuss possible practical applications of RL circuits.
What is meant by rectifier? Explain the half wave rectification and also calculate its rms value of current and voltage?
Discuss the working of LC electronic oscillator by explaning circuit.
what is the maximum frequency, if the circuit minimum frequency is 7000 Hz and the banwidth is 21 kHz?
A 60microfarad capacitor is connected to a 110V 59Hz signal. What is its impedance in Ohms?
Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The transmissionlines are made of aluminum cables with a 7 cm2crosssectional area. Find the loss of power in the transmissionlines if it is transmitted at (a) 200 kV (rms) and (b) 120 V(rms).
An LRC circuit is set up with an inductance of 1>5 henry, a resistanceof 1 ohm, and a capacitance of 5>6 farad. Assuming theinitial charge is 2 coulombs and the initial current is 4 amperes,find the solution function describing the charge on the capacitor atany time. What is the charge on the capacitor after a long periodof time?
Check Your Understanding If a European ac voltage source is considered, what is the time difference between the zero crossings on an ac voltage-versus-time graph?
For what value of the phase angle between the voltage output of an ac source and the current is the average power output of the source a maximum?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If AC in a circuit can be thought of as a wave, which kind is it, longitudinal or transverse?
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is vin, and the output voltage is vout. (a) Show that for the capacitor circuit, voutvin=11+2R2C2 and for the inductor circuit, voutvin=RR2+2L2 (b) Slow that for low frequencies, voutvin , but for high frequencies, vout0 .