time intérval, and zero potential difference is measured across the capacitor. After the switch is dpened, the potential difference reaches a maximum value of 150 V. What is the value of the inductance? R L. S

time intérval, and zero potential difference is measured across the capacitor. After the switch is dpened, the potential difference reaches a maximum value of 150 V. What is the value of the inductance? R L. S

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 25PQ: A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH...

See similar textbooks

Related questions

Q: Find an expression for the induced emf as a function of time, where time t is in s. Express your…

Q: An LC circuit includes a 0.025 mF capacitor and a 340 mH inductor. (a) If the peak capacitor voltage…

A: An LC circuit includes a 0.025 mF capacitor and a 340 mH inductor. (a) If the peak capacitor voltage…

Q: onside snown below) consisting Voltage source: V(t)=Vosin(wt) connected in series to a capacitor C…

Q: apacitance C and an inductance L are operated at the same angular uency. At what angular frequency…

A: Given Inductance L =5.2 mH = 5.2 × 10-3 H Capacitance C = 3.9 μF = 3.9 × 10-6 F

Q: capacitor is initially charged when switch 1 is open and switch 2 is closed. Switch 2 is then…

A: Given:- The capacitor is initially charged when switch 1 is open and switch 2 is closed. Switch 2 is…

Q: QI/An RLC circuit consists of a (150 resistor), a (21.0 F capacitor), and a (460-mH inductor),…

Q: An inductor is hooked up to an AC voltage source. The voltage source has EMF Vo and frequency f. The…

A: n inductor is hooked up to an AC voltage source. The voltage source has EMF Vo and frequency of. The…

Q: An RLC series circuit has a 200 Ω resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is…

A: Resistance, R = 200 Ω Inductance, L = 25 mH frequency, f = 8000 Hz phase angle, A = 45º

Q: i resistor R, inductor L, and capacitor C are all connected in parallel to an AC source of EFM. What…

A: Given data: The RLC circuit is arranged in parallel manner. To calculate : maximum current To draw:…

Q: A 10-mH inductor and a 25uF capacitor are connected in parallel. The combination is in series with a…

A: a. Here the capacitor and inductor are connected in parallel, so the effective impedance is

Q: Tia needs to produce a solenoid that has an inductance of 3.33 ?H She constructs the solenoid by…

Q: 2. In the circuit below the switch has been closed for a long time. R, R2 If at t = 0 the switch is…

A: When switched is closed for a long time then current will not flow through the capacitor. Because…

Q: For the circuit shown—consisting of a 5.1 ohm resistor, 180 × 10-6 H inductor, 85 × 10-6 F…

Q: An RLC series circuit has a 230 Ω resistor and a 28.0 mH inductor. At 9100 Hz, the phase angle is…

Q: When a nonideal 1.3-H inductor is short-circuited, its magnetic energy drops to one-fourth of its…

Q: The LC circuit of a radar transmitter oscillates at 17.5 GHz. (a) What inductance is required for…

A: Given data: The frequency of oscillation is f=17.5 GHz. The capacitance is C=1.10 pF.

Q: 3. In the circuit below the capacitor initially has a charge Qo. If the switch is closed at t = 0,…

Q: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF . During the current…

A: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF . During the current…

Q: An inductor with inductance L and a charged capacitor with capacitance C are put in a single loop.…

A: Given data: The LC series circuit With inductance = L And a charged capacitor = C Required: The…

Q: 5. Consider the circuit below, where the capacitor carries an initial charge Qo. R

Q: Part (e) Express the time to, when the current reaches one half of its maximum value, in terms of L…

A: e) I(t)=VR×1-e-RtLImax=VR I(t)=Imax2 when e-RtL=0.5∴-RtLlog(e)=-log(2)≡t=L×log2)R×log(e)Hence time…

Q: A capacitor C=25μF is charged by a 40 volt battery. When the capacitor is fully charged, it is…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: n inductor has a peak current of 330 A when the peak potential is 2.2V at 45 MHz. What is the…

Q: 1. In the circuit below, suppose the switch has been in position A for a very long time. If it is…

A: For a L-R circuit, From boundary condition,

Q: A 10.00 μF capacitor C is initially charged to a voltage V of 10.00 (V). It is then connected in…

Q: A 2.0 mF capacitor has 1.0 kΩ reactance. (a) What’s the frequency of the applied voltage? (b) What…

Q: A 9.0-V battery is connected in series with a 31-mH inductor, a180@Ω resistor, and an open switch.…

Q: It has been proposed to use large inductors as energy storage devices. (a) How much electrical…

Q: (a) A condenser of capacity 10 µF, an inductance of 0.2 mH and a resistance of 600 Q are joined in…

A: As two independent questions are asked, according to policies, first 3 sub questions of first main…

Q: A 510-turn solenoid has a radius of 8.00 mm and an overall length of 14.0 cm. (a) What is its…

Q: A 2.0 micronFarad capacitor has a reactance of 1.0 kohms. a) What is the frequency of the applied…

Q: A long fund rival solenoid with 100 turns per cm has a radius of 1.6 cm. Assume the magnetic field…

Q: A 100-mH inductor is connected across the emf of the preceding problem. (a) What is the reactance of…

A: (a) Given, Inductance, L=100 mH=100×10-3 H The inductive reactance, XL=ωL....Eq(1) ω=2×π×60=120π Hz…

Q: (a) What is the impedance? (b) What is the maximum current? A (c) What is the phase constant o of…

Q: For a certain RLC Circuit the maximum generator emf is 125V and the maximum current is 3.20A.…

A: Given: The maximum voltage of the source is 125 V. The maximum current in the circuit is 3.2 A. The…

Q: Tarik winds a small paper tube uniformly with 173 turns of thin wire to form a solenoid. The tube's…

A: Given data : Number of turns, N = 173 Diameter of the tube, D = 7.95 mm =…

Q: lelll R L2 2. In this figure, assume arbitrary numbers for R1, R2, L1, and L2 including some number…

Q: A neon sign transformer has a 450 W AC output with an rms voltage of 15 kV when connected to a…

A: Given: The output voltage is V2=15 kV. The power is P=450 W. The number of turns in primary coil is…

Q: What is the unit of the physical quantity "Inductance"? A) weber B) farad C) henry D) tesla

A: The inductance is the property of a coil which is used to store the electrical energy in form of…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

In the circuit of the figure below, the battery emf & is 55 V, the resistance R is 210 0, and the capacitance C is 0.500 µF. The switch S is closed for a long
time interval, and zero potential difference is measured across the capacitor. After the switch is dpened, the potential difference across the capacitor
reaches a maximum value of 150 V. What is the value of the inductance?
R
3.
S
ll

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
For the cucu3t shown below, what are (a) the total impedance and (b) the phase angle between the current and the emf? (C) Write, an expression for i(t).
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
In an oscillating RLC circuit, R=5.0 ,. L=5.0mH , and C = 500 F . What is the angular frequency of the oscillations?
What is the resistance R in the circuit shown below if the amplitude of the ac through the inductor is 4.24 A?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.