shower head in your apartment needs to have water come out with a speed of 9.6m/s. The shower head has 20 circular openings. Each opening has a radius of 1mm. The shower head is connected to a pipe with radius of 0.8cm. The bathroom pipe is 8m above the ground level. The pipe at the ground level has twice the radius of the pipe in the bathroom upstairs. a) What is the volume flow rate at the ground floor? b) What must be the gauge pressure between the ground floor and the bathroom pipe? c) What is the gauge pressure between the bathroom pipe and the shower head opening where the water exits the shower head?

Q: You wash your roof with a water hose at a height of 8.0 m above the ground. You connect two garden…

A: Given- P1 = Atmospheric pressure = 1.01 x 105 Pa v1 = 6 m/s height from datum 2 to 1 = (h) = 8 m By…

Q: A centrifugal pump delivers water against a net head of 14.5 m at a designed speed at 1000 rpm. The…

A: A centrifugal pump is a mechanical device that moves a fluid by transferring rotational energy from…

Q: At a hydraulic plant, the difference in elevation between the surface of the water at intake and at…

A:

Q: Pipe A, 30 cm in diameter, branches into two pipes B and C. Pipe B is 15 cm in diameter and pipe C…

A:

Q: A pump moves water horizontally at a rate of 0.05 m/s. Upstream of the pump where the pipe diameter…

A:

Q: A pump moves water horizontally at a rate of 0.05 m³/s. Upstream of the pump where the pipe diameter…

A:

Q: Water is pumped into a fire hose through a 6 cm diameter pipe with speed 1m/s. The water in the fire…

A:

Q: Give at least two reasons why turbines often have greater efficiencies than do pumps.

A: In turbines, the pressure gradient dp/dx is negative i.e., high pressure to low pressure whereas…

Q: Water enters a rigid, sealed, cylindrical tank through an inlet at the bottom of the tank at a…

A:

Q: Water is pumped into a fire hose through a 6 cm diameter pipe with speed 1m/s. The water in the fire…

A:

Q: Water flows in a new 10cm diameter cast iron pipe with f=0.027 at a velocity of 1m/s. For each pipe…

A:

Q: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a head of…

A:

Q: (B) A pelton wheel has a mean bucket speed of 12 m/s moves in the direction of jet water 10 cm in…

A: Given datau=12 msd=10 cmϕ=150u1=u2=12 msvelocity of jetv1=QA=0.18π4×0.12=22.93 ms

Q: Q5/ A centrifugal pump impeller runs at 1500 rpm & has internal & external diameters of 0.2 n & 0.4…

A: A centrifugal pump is a mechanical device that moves a fluid by transferring rotational energy from…

Q: A pump 260mm suction pipe and a 150mm discharge pipe is used to deliver 58L/s of water. The suction…

A:

Q: The net head delivered by a pump at a rotational speed of 1000 rpm is 10 m. If the rotational speed…

A: Given: The net head delivered by a pump is H1=10 m. The rotational speed of the pump is N1=1000 rpm.…

Q: For a certain stage of an axial flow turbine, the nozzle makes an angle of 28' with the wheel…

A: Given data as per question Axial velocity =500 ft/s Degree of reaction =50% blade velocity(u)=550…

Q: Water flows from a cylindrical pipe of diameter 6-cm into another cylindrical pipe of diameter 3-cm.…

A: Given: The diameter of first pipe is D=6 cm. The diameter of second pipe is d=3 cm. The velocity in…

Q: A pump receives 60 Liters per second of water with specific volume of 0.00112 m3/kg at a head of…

A:

Q: PROBLEM: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a…

A: given data;velocity coefficient (Cv)=0.98jet diameter(d)=15cmhead(H)=270mnozzle angle(α)=150wheel…

Q: Seven hundred gallons per minute of water are being discharged by a centrifugal pump 5 ft above the…

A:

Q: PROBLEM: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a…

A: As per rule solved first four parts only

Q: The velocity of water and pressure at the suction side of a pump is 4m/s and 90kPa respectively. If…

A:

Q: 1) Interpret solar power in the context of environmental impact. 2. What is the rigid dichotomy…

A: 1) Solar power is the renewable source of energy and it is used widely around the world for power…

Q: In an industrial cooling process, water is circulated through a system. If water is pump from the…

A:

Q: 2. A fan draws 1.42 m^3 per second of air at a static pressure of 2.54 cm of water through a duct…

A:

Q: 4. A pipe has an initial radius of 30cm, which then changes to a radius of 10cm. The velocity of the…

A: Please refer to the detailed solution given below, Answers - (a) Pressure difference P1 - P2 =…

Q: A city requires a flow of 25 million gallons per day for its water supply. If the required velocity…

A: Given data: Discharge required, Q=25 million Gallons/day=25×10624×60 Gallons/min…

Q: 1. A 2 cm diameter water jet having a velocity of 25 m/s and inclined from the horizontal at an…

A:

Q: Water flows through a 15m pipe with 1.3 cm diameter at 20 l/min. Determine the length of entrance…

A:

Q: PROBLEM: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a…

A: d=15 cm H= 270 mα1= 15°D=2.45 mβ2=20°ηmech=97%

Q: 8. For hydraulic pumps and motors, there are two types of losses, i.e._

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A fire starts in an apartment building in downtown Boston. When the firefighters arrive, they…

A: As per the question, the water is coming out of the hydrant at a certain velocity. When that is…

Q: Q6. A pump moves water horizontally at a rate of 0.02m /s. Upstream of the pump where the pipe…

A: Given Data: Flow rate, Q=0.02 m3/s

Q: A hotel builds a water fountain that is fed by a 16.0 cm diameter cylindrical pipe that carries…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: A two-lobe rotary positive-displacement pump moves 0.60 cm3 of motor oil in each lobe volume. For…

A: Given: The volume of each lobe is Vlobe=0.6 cm3. The number of lobe is N=2. The rate of rotation of…

Q: Water flows through a rubber hose 2 cm in diameter at a velocity of 4 m/s. (a) What must be the…

A:

Q: 9: Find the specific speed and power consumption for pump having the following properties: (Q=0.1…

A:

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.402 m. A hole of…

A:

Q: You only know one point on a pump curve, where a water pump produces 20 m of hydraulic head at flow…

A: A pump's performance curve shows how well it will operate in terms of flow and pressure head. For a…

Q: water enter an inward flow turbine at an angle of 22° to the tangent to the outer rim and leaves the…

A:

Q: three immiscible fluid are contained in a tank 1.0 m of water, 1.20 m of oil (s=0.80 and air under a…

A:

Q: (b) Figure Q5(b) shows the performance curves for a 31 cm diameter centrifugal pump used to pump…

A:

Q: 0, JA centrifugal pump used to take water from reservoir to another through 800 m ength and 0.15 m…

A: Given that, Length of the pipe, L=800 m,Diameter of the pipe, D=0.15 m,Difference in two tank, ∆z=8…

Q: A hydroelectric power plant takes in 30 m³/s of water through its turbine and discharges it to the…

A: In the given case let us neglect the viscous work and heat transfer and take section 1 into…

Q: A sump pump (used to drain water from the basement of houses built below the water table) is…

A: m• = 0.85 L/s = 0.85 × 10-3 m3/s  P = 3.05 × 105 Pa. a) di = 2.8 cm = 0.028 m  ∆h = 2.4 m = 2.4 m…

Q: The diameter of a pipe at the larger end is 0.6 cm and at the smaller side is 0.3 cm the larger and…

A: