Simple saturated vapour compression refrigeration system using NH3 has a capacity of 25 TR. Evaporator and condenser temperature are -5℃ and 40 ℃ respectively. Calculate: (a) Mass flow rate of refrigerant (b) COP Take cpv = 2.1897 kJ/kgK. Properties are given below

Q: A plant located at an altitude of 925 m has an open feedwater heater located  2.76 m above the pump…

A: The pressure head at any point in the fluid system can be calculated using the formula given below…

Q: A Freon 12 vapour compression system operating at a condenser temperature of 40°C and an evaporator…

A: Given dataTe=0°CTc=40°CRC=15 tonsTo find 1. m°2. discharge temp Tb

Q: Water vapor with a flow rate of 20000 kg / h enters the condenser of a power plant at a pressure of…

A:

Q: In NH3-water absorption system the heat is supplied to generator by condensing stream at 0.2 MPa.…

A: Ammonia - water absorption refrigeration cycle Heat input by steam at 0.2 MPa and dryness fraction…

Q: The maximum flow rate of standard shower heads is about 3.5 gpm (13.3 L/min) and can be reduced to…

A:

Q: Calculate the power req'd. by 2 compressor in an NH3 system that serves a 30 tons evaporator @…

A:

Q: An ammonia compressor operates at an evaporator pressure of 316 kPa and a condenser pressure of…

A: Evaporator pressure=316kPaCondenser pressure=1514.2kPASubcooled at 5°Superheated at 8°'Stroke…

Q: 0.2 A condenser condenses 2700kg steam per hour while air leaks into It at 2.2kg/hr. The condensate…

A: Given: The steam condenses per hour, mw = 2700 kg/hour The air leakage into the condenser, ma = 2.2…

Q: A vapor-compression refrigeration system, using ammonia (R-717) as the refrigerant, is operating…

A:

Q: Derive the equations as given below as applied to COOLER - DEHUMIDIFIER apparatus using the basic…

A: According to the law of conservation of mass   The mass entering the system = The mass leaving the…

Q: Refrigerant R-134a to the compressor of a refrigeration machine It enters at 140 kPa pressure and…

A:

Q: Q.1. A refrigeration process with interstage cooling uses refrigerant HFC-134a, and the outlet of…

A:

Q: Schematic diagram of a Simple Vapor Compression System is shown that uses refrigerant R-134a for…

A:

Q: A two-stage refrigeration system operates with ammonia refrigerant flowing at the rate of 15 kg/min…

A: (a) Drawing the schematic and ph diagram of the two-stage refrigeration system as shown below –…

Q: Refrigerant R-134a enters to the compressor of a refrigeration machine at a pressure of 140 kPa and…

A: In this refrigeration cycle, there are four processes Process 1-2 Isentropic compression Process 2-4…

Q: The mass flow rate of the refrigerant in a Single Stage Vapor Compression (SSVC) refrigeration…

A: given; mass flow of refrigerant(m)=0.015kg/sevaporating(T1)=-200c                       =273-20…

Q: A vapor-compression refrigeration system using ammonia as refrigerant is to be used to cool 45,000kg…

A:

Q: standard vapor compression system produces 20 tons of refrigeration using r-12 while operating…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: An air refrigeration system having pressure ratio of 5 takes air at 0°C and 1 atm. It is compressed…

A: Let p1 =pressure before compression= 1bar T1=Temperature after compression =273K T3=Temperature…

Q: For R-410A refrigerant, which operates at a flow rate of 0.102 kg/s. It is known that saturated…

A:

Q: Q2: A simple R134a vapor compression system operates between 40°C condensing temperature and-10°C…

A:

Q: refrigeration in kW. The specif

A:

Q: A Freon 12 vapour compression system operating at a condenser temperature of 45oC and an evaporator…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: developing 60kw of refrigeration using refrigerant R134a with condensing temperature 400C and…

A:

Q: The mass flow rate of the refrigerant in a Single Stage Vapor Compression (SSVC) refrigeration…

A:

Q: our compression refrigerator operates between the pressure limits of 462.4 kN/m² and 1785.9 kN/m².…

A:

Q: A mechanical refrigeration system shown below with R-1234yf is operating under such conditions that…

A: Note: As per policy we can solve the first three subparts. Please resubmit the remaining parts.

Q: Refrigerant R-134a to the compressor of a refrigeration machine It enters at 140 kPa pressure and…

A:

Q: Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam…

A:

Q: A standard vapor-compression refrigeration system produces 20 tons of refrigeration using R 12 as a…

A: Given data:- Evaporator temperature = -25°C Condenser temperature = 40°C Refrigeration = 20 tone

Q: 00 x 200 mm ammonia compressor with a compression efficiency of 82% operates with a suction pressure…

A: As per the guidelines, I can solve only first three subparts. For rest parts, repost in a separate…

Q: A six-cylinder, 6.70 x 5.70 cm, refrigerant 22 compressor operating at 1800 rpm indicates a…

A:

Q: A vapour compression plant uses R-12 and is to develop 5 tonnes of refrigeration. The condenser and…

A: Refrigeration = 5 tonnes Temperature range = -10oC and 40oC

Q: A cooling system with a capacity of 10 tons of refrigeration operates at 210 KPA in the evaporator…

A:

Q: A refrigeration system using R-12 is to have a refrigerating capacity of 60 kW. The evaporating…

A: Given data as per question Refrigeration capacity =60 KW Evaporator temperature  =-100 c Condensor…

Q: If an evaporator outlet temperature on an R-410A system is 50f and the evaporator superheat is 10f,…

A: Hence, at 40 ºF the evaporating pressure can be obtained from the property table of R-410A is –

Q: THERMODYNAMICS A condenser (cooler) takes 0.05 kg/s of R-134a at 200 kPa and 80 degrees Celsius and…

A: Answer: The cooling capacity needed for the condenser is 12.9495 kW.

Q: Q4. Fluid enters a condenser at the rate of 40 kg/min with a specific enthalpy of 2000 kJ/kg, leaves…

A: Heat lost by fluid,∆QL=m˙2000-200∆QL=40×2000-200∆QL=72000 kJ/min

Q: a cooling system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the evaporator,…

A: Consider the T-s diagram shown below for the given cycle.

Q: Mass flow rate of R134a. Mass flow rate of chilled supply water and Volumetric flow rate entering…

A:

Q: nters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate…

A:

Q: A 3 cylinder 100 x 200 mm ammonia compressor with a compression efficiency of 86% operates with a…

A: Solution:

Q: g at 5 °C suction temperature and a 40°C condensing temperature has an evaporator load 17.6 KW. If…

A:

Q: Q3. Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.20 MPa and -5…

A: Draw the T-s diagram for the system as follows:

Q: A two-cylinder R-134a compressor operating at 1500 rpm. The evaporator temperature is (-6°C) and the…

A:

Q: single effect evaporator was used to concentrate 10000 kg / hr of tomato juice from 5% total solids…

A:

Q: Air V = 600 m'/min | P 100 kPa T=27 C R-134a P = I MPa T1=90 C P= 95 kPa T= 60 C P, 1 MPa T = 30°C…

A: Assumptions  Steady state-flow process since there is no property change with time. K.E and P.E.…

Q: A vapor-compression system produces 20 tons of refrigeration using R12 as a refrigerant while…

A: Delta_P = 10[kPa]Delta_T = 10[C]T_cond = 41.6[C]T_evap= -25[C]Q_in = 70[kW] =  20 Ton*3.5  (1 ton =…