Single - shell , two - tube pass heat exchanger with surface area 0.4 m² and overall heat transfer coefficient of 1800 W / m²K; saturated steam at 110 ° C condenses on one side while water at a flow rate of 0.35 kg / s enters at 17 ° C . Calculate ( a ) Outlet temperature of the water (b) Rate of condensation of steam . cp ( water) = 4179 J / kg . K.

Single - shell , two - tube pass heat exchanger with surface area 0.4 m² and overall heat transfer coefficient of 1800 W / m²K; saturated steam at 110 ° C condenses on one side while water at a flow rate of 0.35 kg / s enters at 17 ° C . Calculate ( a ) Outlet temperature of the water (b) Rate of condensation of steam . cp ( water) = 4179 J / kg . K.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.14P

See similar textbooks

Similar questions

Water flowing in a long, aluminum lube is to be heated by air flowing perpendicular to the exterior of the tube. The ID of the tube is 1.85 cm, and its OD is 2.3 cm. The mass flow rate of the water through the tube is 0.65kg/s, and the temperature of the water in the lube averages 30C. The free-stream velocity and ambient temperature of the air are 10m/sand120C, respectively. Estimate the overall heat transfer coefficient for the heat exchanger using appropriate correlations from previous chapters. State all your assumptions.
10.1 In a heat exchanger, as shown in the accompanying figure, air flows over brass tubes of 1.8-cm 1D and 2.1-cm OD containing steam. The convection heat transfer coefficients on the air and steam sides of the tubes are , respectively. Calculate the overall heal transfer coefficient for the heal exchanger (a) based on the inner tube area and (b) based on the outer tube area.
What is the main difference between a copper and a cupronickel coaxial heat exchanger, and where is each used?
Mot water is used to heat air in a double-pipe heat exchanger as shown in the following sketch. If the heat transfer coefficients on the water side and on the air side are 550W/m2Kand55W/m2K respectively, calculate the overall heat transfer coefficient based on the outer diameter. The heat exchanger pipe is 5-cm, schedule 40 steel (k=54W/mK) with water inside.