Answered: Solve for the value of the capacitance…

Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc - 2316 ohms. Round your answer to 2 decimal places. Add your answer

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 4PP: Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the...

See similar textbooks

Related questions

Q: In the network shown in the figure, each of the resistance is equal to 20. The resistance between…

A: Solution !!

Q: Given the function displayed below, create a block diagram. a. F = A B + C b. F = X Y + X’ Y + Y’…

A: This is a basic problem of logic gate function. The solution is given in the next step.

Q: Apply DeMorgan's theorems to each expression:

A: It is given that: a. X=AB'C+D''b.Y=A+B'+C+D''+ABCD''

Q: 4.20 A 25-KVA, 2200/220-V, single-phase transformer has an equivalent series impedance of Zel = 3.5+…

Q: FOR THE CIRCUIT DETERMINE THE CURRENT LABELED L ву FIRST COMBINING THE FOUR SOURCES INTO A SINGLE…

Q: Two-three phase ac generators 1 and 2 are connected in parallel. The first generator has a per phase…

A: When two or more power generating or consuming unit connected in parallel then sum of active active…

Q: A 250V series motor draws a current of 40A. The armature resistance is 0.15 ohm and the field…

Q: 3. A bode plot of (1+jWT) has a) Slope of 20dB/decade and phase angle of tan¹ b) Slope of…

Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…

A: We need to find out the current through load for given circuit .

Q: B- Consider the differential amplifier in Fig. 1. Where, Ir=1mA, Rc-10 KM2, VBE = 0.7 V (1). For Var…

Q: A corridor is lighted by 4 lamps spaced 15 m apart and suspended at a height of 5 m above the centre…

Q: 6. A 8 bit ADC has generated a digital representation of 11001100 using the successive approximation…

A: Given : Input digital bit : 11001100 Vref=VFS=10Vn=8

Q: Point charges q1 and q2 are held in place at the (x,y) coordinates specified below. Point P is a…

Q: For the circuit shown in Figure 2.54, use nodal analy- sis to find the current delivered by the 24 V…

Q: For each of the values of no given below, sketch the signal g[n] defined as g[n] = x[no - n]h[n],…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: Total Power Pt = 2500 W Side band power PSB = 400 W We have to determine the modulation percentage μ…

Q: 5. Minimize the following Boolean functions into sum-of products and product-of-sums forms using a…

Q: A single-phase source delivers power to three loads that are connected in parallel: (i) a resistive…

Q: 2. Determine the current I in each of the circuits given in Figure B. 1.5 V 7A (a) 3 A (b) Figure B.…

A: We need to find out current for given circuit .

Q: What is the equivalent resistance between the points A and B of the network. 202 Aww 492 g 1002 www…

A: We simplify above circuit to calculate equivalent resistance, as one can see in digaram:

Q: 4. Find v₁ and v₂ in the circuit below. Show all your calculations. 355 8 V €2000 €3,000 100 +…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: Total power of an AM wave Pt = 2500 W Sideband power PSB = 400 W We have to find the modulation…

Q: 2. Find Ix.

A: Given- Source current= IS1 = 2A IS2 = 4A Voltage source- V1 = 4 V To find- Current Ix =?

Q: Draw a block diagram given the function shown below: F = A B + C F = X Y + X’ Y + Y’ Z ( A + B’)…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: We need to find out modulation index for given AM signal .

Q: Write a function using the block diagram shown below: X у x' N D f

Q: A 500 lossless line has load voltage V₁ = 10 e/25° V and load impedance 50 e/³0⁰ 9. Find the value…

Q: H (jw) = Y(jw) X (jw) = 105(10 + jw) (1000 + jw) (1 + jw)(100 + jw)(10000 + jw)

Q: Consider continuous standard telephone channel, with bandwidth 3100 Hz perturbed by bandlimited…

Q: If the power of an elementary electric dipole is 100 kW, what should be the numerical value of the…

A: Note: We have considered Half wave electric dipole antenna. According to the question, if power of…

Q: From the curcuit given below, determine the total amount of power in the series circuit. 50 V 5Ω 292…

Q: A unity feedback system, having an open loop gain G(s)H(s) = K(1-s) (1+s) becomes stable when A IKI…

A: Given- Unity feedback system , open loop gain, G(s)H(s)=K(1-s)1+s , To find- It is needed to find…

Q: Find the rank of the followng matrix For z1, find the rank of matrix A. A = 1 2 1 1 00 Find z such…

Q: consider two buses connected by an impedance of (0 + 5j) Q. The bus '1' voltage is 100 230° V, and…

A: Given- P=Line impedance angle, δ=30o,α=0o,A=D=1.0,β=5∠90o, To Find- The real and reactive power…

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: Introduction: A two-terminal passive electrical device used to limit or regulate the flow of current…

Q: A switch that can conduct positive on-state current, and can block positive or negative off-state…

Q: A gain of 11 is required from a noninverting constant- multiplier op-amp circuit. If the input…

A: Given Gain = 11 and R = 10k ohm Rf = ?

Q: Draw a block diagram of a detector for AM signal and show, using necessary processes and the…

A: The wave signal is shown in three separate sections, AM input wave, Rectified wave, and output wave.…

Q: If the current i flowing in the straight conducting wire as shown in the figure decreases, find out…

A: Solution !! Solution From right hand rule, the magnetic field by the straight wire is directed into…

Q: The frequency of the supply to the stator of an 8-pole induction motor is 50 Hz and the rotor…

Q: Use the Laplace transform to solve the initial value problem. Obtain Y (s) and y (t) 1.-y + 4y = e…

Q: A synchronous motor capable of operating with a leading power factor draws 15 kW from a distribution…

A: Synchronous motors revolve with a constant (synchronous) speed, as the name suggests. This type of…

Q: 4. Determine the power in the spectral components.

A: Given signal, VFM=100sin204.6π×106t+3sin30π×103t V

Q: Describe how the Medical Uses of Magnetic Fields.

A: Application of magnetic field in medical : There are various uses of magnet and magnetic field in…

Q: A self-inductance of 10 mH and its resistance 50 connect to AC source of voltage 200 V, and…

Q: The numbers are placed in the memory locations 2501 to 2504H. The sum is to be stored in the memory…

A: Solution !!

Q: use a P-N junction ideal diode to simulate a circuit measure and plot its I-V characteristics as…

A: According to the question, we need to show the theoretical calculation for the large signal piece…

Q: Use mesh analysis to obtain io in the circuit given below. Use Vv=80 V. www 2023 50 Vy 610 402 45 A…

A: We need to find out current for given circuit , we will find out it by using of mesh analysis

Q: For the circuit shown below. Find ib 9V 1 ΚΩ + www 3 ΚΩ ww • 2 ΚΩ + Ava

A: In this question, We need to determine the current ib as shown the circuit. We are solving this…

Q: A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF capacitor and 50…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

Solve for the value of the capacitance (in nF unit) if R2 = 1017 ohms and Xc-2316 ohms.
Round your answer to 2 decimal places.
Add your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor domain.
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841