solve with steps please example/2.12 Use of Equivalents in Determining the Accuracy of a Water AnalysisProf. Mihelcic was in the city of Dunedin in New Zealand to view yellow-eyed penguins and alba-trosses. The label on a bottle of New Zealand mineral water he purchased there states that a chemicalanalysis of the mineral water resulted in the following cations and anions being identified with corre-sponding concentrations (in mg/L):[Ca?+] = 2.9 [Mg²+] = 2.0 [Na*] = 11.5 [K*] = 3.3(SO?] = 4.7 [FI¯] = 0.09(CI] = 7.7Is the analysis correct?

The concentrations of different ions in a bottle of mineral water chosen for analysis is provided.

Answered: solve with steps please

Science

Chemistry

solve with steps please

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 80AP

See similar textbooks

Similar questions

A 25mL volumetric pipet is used to deliver a sample of the stock solution marked “0.6000M X2SO4” into a 100mL volumetric flask. Distilled water is added to the flask until it is about 3/4thfull, the solution is mixed well, then more water is added to fill it up to the calibration mark, then it is mixed again. Calculate the concentration of X+ion in the dilute solution made above.
Although other solvents are available, dichloromethane(CH₂Cl₂) is still often used to “decaffeinate” drinks because thesolubility of caffeine in CH₂Cl₂ is 8.35 times that in water.(a) A 100.0-mL sample of cola containing 10.0 mg of caffeine is extracted with 60.0 mL of CH₂Cl₂. What mass of caffeine re-mains in the aqueous phase? (b) A second identical cola sampleis extracted with two successive 30.0-mL portions of CH₂Cl₂.What mass of caffeine remains in the aqueous phase after each extraction? (c) Which approach extracts more caffeine?
1. A 0.57 gram sample aspirin (MM=180 g/mol) is crushed and dissolved in water. The sample is titrated with 0.20 M sodium hydroxide. The titration required an average volume of 8.50 ml of sodium hydroxide to reach the endpoint. What is the purity of the sample? 2. Nitrosyl chloride, NOCl, dissociates on heating as shown below. When a 1.50 gram sample of pure NOCl is heated at 350 oC in a volume of 1.00 liter, the percent dissociation is found to be 57.2%. What is the quilibbrium constant? NOCl <-> NO + 1/2 CL2
Solution of Pb(NO3)2 and NaCl are combined, resulting in concentrations of 0.0050 M Pb(NO3)2 and 0.00250 M NaCl immediately upon mixing. select the correct description of the final solution, given that the Ksp of PbCl2 is 1.7x10^-5. A) NaNO3 Precipitates B) All solutes reamin soluable C) Pb(NO3)2 precipitates D) PbCl2 precipiates E) All Solutes precipitate.
In one trial determination of the concentration of NaOCl in the diluted bleach sample, 10.00 mL of the diluted bleach solution required 29.82 mL of 0.0195 M Na2S2O3 titrant to reach the endpoint. What is the molar concentration of NaOCl in the diluted bleach solution?
What is the primary standards and its amounts, and indicators used for the Volumetric Solution (VS): 1N Sulfuric acid? And why?
-3: A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v ethanol. (Density of ethanol = 0.789 g/mL; MW of ethanol = 46 g/mol) Determine the initial volume of 70% v/v ethanol used in the preparation. How much water was added to the stock solution to make 1L of the final concentration? The molarity of 5.0 mL of 70% v/v ethanol was found to be __________. Question 1-3: A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v ethanol. (Density of ethanol = 0.789 g/mL; MW of ethanol = 46 g/mol) Determine the initial volume of 70% v/v ethanol used in the preparation. How much water was added to the stock solution to make 1L of the final concentration? The molarity of 5.0 mL of 70% v/v ethanol was found to be __________.
A series of iron standard solutions need to be made from a 40 ppm iron stock solution provided. For the first dilution, pipet 5.00 mL of the 40 ppm stock solution into a 100.00 mL volumetric flask and dilute to mark. What is the new concentration of the diluted solution?
Calculate the volume in milliliters of 0.362 M KOH necessary to titrate 28.38 mL of 0.279 M diprotic sulfuric acid, H2SO4, to a phenolphthalein end-point. Report the answer to a precision of 2 decimal places.
A 10 ml of concentrated acetic acid was added in a sufficient quantity of water to make 350 ml of the acid solution. SG acetic acid= 1.05 kb acetate = 5.556x10^-10 What is the weight of acetic acid in grams? What is the molarity (mole/Liter) of acetic acid solution? What is the ka of acetic acid? What is the Hydronium ion concentration? What is the pH of the solution?
As a food chemist for a major potato chip company, you are responsible for determining the salt content of new potato chip products for the packaging label. The potato chips are seasoned with table salt, NaCl. You weigh out a handful of the chips (78.5 g), boil them in water to extract the salt, and then filter the boiled chips to remove the soggy chip pieces. You then analyze 100.0 mL of the chip filtrate for Cl- concentration using the Mohr method. First, you prepare a solution of AgNO3, and standardize it using 0.500 g KCl as the primary standard. Calculate for the concentration (in M) of the standard AgNO3 solution if it takes 64.5 mL of the AgNO3 titrant to reach the equivalence point of the reaction. Write the balance chemical reaction between the standard and the titrant. You then use the standardized AgNO3 solution to analyze the chip filtrate in a Mohr reaction, finding that the solution yields a rusty brown precipitate when 48.8 mL of titrant is added. Calculate for the…
A commercial vinegar was analyzed by titration to determine the percent acetic acid. Briefly, 10.00 mL of vinegar sample was diluted to 100. mL solution in volumetric flask. A 25.00 mL aliquot from the diluted vinegar required 25.55 mL of 0.1005 M NaOH to reach the phenolphthalein endpoint. Which is the correct equation between the analyte and titrant reaction? CH3COOH + NaOH → NaCH3COO + H2O 2CH3COOH + NaOH → NaCH3COO + H2O C20H14O4 + NaOH → NaC20H14O4 + H2O CH3COOH + 2NaOH → NaCH3COO + H2O