STA BS (in cm) HI FS (in cm) ELEV (in m) BMa 135.5 10.401 TP1 126.5 188.6 TP2 159.6 150.0 ТРЗ 110.3 153.2 ТР4 102.5 145.2 BMb 109.8 122.2 ТР5 112.5 185.0 BMc 149.9 a) What is the difference in elevation between BMc and BMa? b) What is the difference in elevation between BMb and BMa?

Q: determine the following: a. Area b. First moment of the shaded area with 12 respect to x-axis c.…

A:

Q: The back staff reading on a B.M. of R.L. 500.000 m is 2.685 m. If foresight reading on a point is…

A:

Q: 3,6 m 2.7 m 2400 N B C D 2.7 m 1.5 m F E 4.8 m

A:

Q: SOVE FOR EQUILIBRIUM: Problem #3 lo00 300 # 3' 10' 4' Rz

A: This question is related to the Strength of Material or Mechanics. In this question we calculate…

Q: An ESP must treat 800,000 acfm with 99.1% efficiency. Assuming an effective drift velocity of 14…

A: Given: The discharge is 800,000 ft3/min. The efficiency is 99.1%. The effective drift velocity is 14…

Q: Question: Given The Following Differential Level Notes: STA BS HI FS ELEVATION BM-A 1.73 346.50 ...…

A: given - differential level notes. to find - point of highest elevation

Q: 120 kN F D 4.5m B 3.0m 1.5m G. 2 Om 2 Om 2.0m C 60 kN

A: consider ∑MF=0Va x 6-120 x 4=0Va=80KN find the inclination of the member BEθ=tan-1(1.52)=36.87°

Q: Calculate the polar radius of gyration of the shaded area about its centroid C. Assume t=115 mm, a…

A:

Q: Find the corrected level for point (A) if you know that the true level of (A) is 30 m e 131…

A:

Q: When QED = QDC = 6.50 mgd, determine the gage reading at Ein psi and the elevation of reservoir B in…

A: The question is based on the reservoir connected through a pipeline. The elevation of reservoirs and…

Q: Use K = 1.0 and E = 29,000 ksi, Fy = 50 ksi. No need to check the local stability of the column.…

A:

Q: D=300mm Head Loss =10m/km Q=? L/S

A:

Q: surfaces of CO 100 KN P F 30°. 30° 15 R

A:

Q: 3 kN C 5m 5 m B.

A:

Q: 12. CURVATURE AND REPRACTION. Two towers, A and B, are lo- cated on level ground and their bases…

A:

Q: 150 kN 96 kN/m A |C 5 m 8 m

A:

Q: h' ORIGIN R2 Hd L1 given Design head =4.2 Height of dam = 37,0 Calculate b and L1 O A. b= 0.73 , L1…

A: Given:- Design head h'=4.2 mHeight of dam Hd=37.0 m

Q: Q#12: The following staff readings were observed successively with a level. The instrument is moved…

A: Solution HI Method Station BS IS FS HI RL(M) Remarks A 3.228     735.611…

Q: Ra and Rb 10ok 200 kN 500KN.m 200 KN.M Ra Ro

A: as per our policy we should answer only one question at a time. so, i am answering only first…

Q: What is the difference in elevation between station 3+900 and 5+200? (Ans.) What is the difference…

A:

Q: 120 KN 90 KN 4.00 m 4.00 m 4.00 m B 60 KN 6.00 m

A:

Q: The isohyets for a 2-day storm on a basin of 1638.3 km² are sho the isohyets as plani-metered are…

A: In the above figure, the isohyets during a 2-day storm on a basin of 1038.3 km are displayed, and…

Q: Q.7 The number of optimum rain-gauges stations will be: Data given: Coefficient of variation (C) =…

A: given Coefficient of variation-Cv=36.5%Admissible % error E=9%

Q: 1.5m 3.0m 2.5m Problem 11A

A: given figure is  now calculate…

Q: For the given Differential Level notes below Station BS HI FS Elevation BM-125 2.38 897.39 ТР-1 3.11…

A:

Q: STA BM 1 2 TP 3 4 5 6 7 TP₂ 8 9 10 11 TP3 TP BS FS IFS 0.95 3 2.3 3.13 0.64 2.7 2.8 3.1 0.5 0.8 2.16…

A:

Q: 880KN 200 KN/m 300 KN /m A B 3 m 1 m 1 m 1m C 1m

A: shear force is the net vertical reaction at any section is resultant of the inter transverse force.…

Q: Given the following differential level notes: STA BS HI FS ELEV BM-1 1.73 346.50 TP-1 2.50 185 TP-2…

A: Given data in question  Back sight Fore sight Elevation of BM1 To find out  Elevations of all points…

Q: 9.2 Redo Problem 9.1 with the following: L, = 3 m, L, = 6 m, y = 17.3 kN/m?, Yal = 19.4 kN/m³ , and…

A: Hello dear student, i hope my answer is helpful for you and As per bartrlby guidelines the first…

Q: L Problem 2 10 kN/m a. Location of Amax b. Amax 10 m

A: Problem 2 Fixed beam uvl load w = 10 kn/m L = 10 m Double integration method location of maximum…

Q: Length of economic haul = 450 m Stationing of limits of economic haul = 2+498.03 Stationing of…

A:

Q: While leveling between two points Pand Qon opposite banks of a river, the level was first set up…

A:

Q: lowing at a rate of 4.5m3 lopes are 1 vertical to 2 h 01

A:

Q: q=66 kN/m El= 9000 kN.m2 L=4 m A EI

A: Given data: q=66 kN/mEI=9000 kN.m2L=4 m

Q: 100 kN 100 kN (4000 mm?) 75 kN - (5000 mm) 3 m (5000 mm?) A B (4000 mm) 4 m E = 200 GPa (4000 mm)…

A:

Q: A 1.75 m Area = 800 mm² B 1.25 m C Area = 500 mm² 75 kN 1.5 m D 50 kN P.

A: Determine the deformation of point b in mm

Q: 12 kN/m d= 86 mm %D A B, 3 m 1.5 m –

A:

Q: A 10 m 10 kN/m B Problem 2 a. Location of Amax from A b. Dmax

A: Given A fixed beam Required  Location of maximum deflection and maximum deflection value

Q: 2. Given the following differential level notes HI Elevation 100m Station BS FS BM-A 1.73 ТР-1 ТР-2…

A: Given:- Station BS HI FS Elevation BM-A 1.73     100 m TP-1 2.50   1.85   TP-2 2.76   1.05…

Q: Find the cam diameter and actual volume displaced? Volumetric efficiency 1420 rpm, e = 14.67 mm, L =…

A: Volumetric efficiency, ηv=91.87%=0.9187 Vane pump speed, N=1420 rpm Eccentricity, e=14.67 mm=0.01467…

Q: 25 kN 20 kN 30 kN B D А +1.5 m→- 3 m -3 m

A: Given:- A=600mm2 To find:- Maximum normal stress in bar

Q: (Ans. VA = 68.96 k 1, VB = 157.79 k 1)

A: Two internal hinges are present in the beam which can be used in equilibrium equations. There are…

Q: Use the following figure, to calculate the curv elevation of full and main stations by using Analyti…

A:

Q: An engineer's level with a stadia constant of 0.30 m was set up on the line between two points, A…

A:

Q: Given the ff: w=67% Gs=2.67 Gwet=19.89kN/m3. What is the degree of saturation

A:

Q: A closed surface consists of a hemispherical surface of 1m radius and the lateral surface of a right…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 45D |1m im H F E 7.5 kN V 5 kN 0.5 m 1m 1m 1m

A:

Q: The back staff reading on a B.M. of R.L. 1000.000 m is 1.663 m. If foresight reading on a point is…

A:

Q: C.L Elev.=??m 17 m 5 m 3 m 7 m Elev.=15m 4 ?? m Elev.=13m Elev.F12m 3.

A: Given Data- To Find- It is needed to find out the area of the given figure.

Q: A closed surface consists of a hemispherical surface of 1m radius and the lateral surface of a right…

A: The area enclosed by the given closed surface is 11.44m2. The correct answer from the given options…

Mapping

Mapping is the process of representing the surface of the earth, objects on it, and the relative positions of the objects, to a suitable scale. In mapping, a large area of land is measured, surveyed, and plotted. The details of the objects present in the nearby surrounding area are located using conventional signs. All these processes are carried out on a flat paper known as a map.