ResourcesGive Up?25%Check AnswerO Assignment Score:( Question 13 of 20 >khe mnan and median yield stress. (Enter the mean to two decimal places and the median to one decimal placa )Note: If you are using CrunchIt, you may adjust the default precision under Preferences. Sce the instructionalit oDrltemptshow to adjust precision settings.M =Compare these two values. Referring to your plot, what general fact does your comparison illustrate?O The large outlier, as seen in the dotplot, is causing the mean to be less than the median.The large outlier, as seen in the dotplot, is causing the mean to be greater than the median.O The approximately symmetric distribution, as seen in the dotplot, is causing the mean to be about the same as themedian.he approximately symmetric distribution, as seen in the dotplot, is causing the mean to be greater than the medianQuestion Source. Baid e The Fractice Of Stacaties he Leercebp Spider silk is the strongest known material, natural or man-made, on a weight basis. A study examined the mechanicalO Assignment Score:25%O ResourcesGive Up?Check AnswerQuestion 13 of 20properties of spider silk using 21 female golden orb weavers, Nephila clavipes. The data on silk yield stress rnthe amount of force per unit area needed to reach permanent deformation of the silk strand. The data are exprecemegapascals (MPa).164.0478.7251.3351.7173.0448.9300.6362.0272.4740.2329.0327.2270.5332.1288.8176.1282.2236.1358.2270.5290.7(a) Use the software of your choice to make a dotplot of these data. Select the correct description of the shape, center,and spread of the distribution.O The distribution is unimodal and essentially symmetric except for a high outlier. The center is approximately 291MPa. The spread is from 164.0 to 478.7 MPa.0%O The distribution is unimodal and extremely left-skewed except for a high outlier. The center is approximately 240MPa. The spread is from 164.0 to 740.2 MPa.The distribution is unimodal and essentially symmetric except for a high outlier. The center is approximately 29MPa. The spread is from 164.0 to 740.2 MPa.S Tie distribution is unimodal and extremely lefi-skewed excent for a hish outlier. The center is approxinately 0MPa. The spread is from 164.0 to 478.7 MPa.Question Source Basa Theactice C/ Statstics ee cce

Name: ResourcesGive Up?25%Check AnswerO Assignment Score:( Question 13 of 2
Uploaded: 2024-03-20T07:06:16.000Z
Channel: Bartleby
Description: ResourcesGive Up?25%Check AnswerO Assignment Score:( Question 13 of 20 >khe mnan and median yield stress. (Enter the mean to two decimal places and the median to one decimal placa )Note: If you are using CrunchIt, you may adjust the default precisio

the distribution is unimodal and essentially symmetric except for a high outliers . the center is…

Math

Statistics

stion 13 (à Find the mean and median yield stress. (Enter the mean to two decimal places and the median to one decimel ale Note: If you are using CrunchIt, you may adjust the default precision under Preferences. See the instructional videa ae how to adjust precision settings.

stion 13 (à Find the mean and median yield stress. (Enter the mean to two decimal places and the median to one decimel ale Note: If you are using CrunchIt, you may adjust the default precision under Preferences. See the instructional videa ae how to adjust precision settings.

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In the 2015 AFC Championship game, there was a charge that the New England Patriots underinflated their footballs for an advantage. The Patriots' opponents during the championship game were the Indianapolis Colts. Measurements of the Colts' footballs were taken. The balls should be inflated to between 12.5 and 13.5 pounds per square inch (psi). The accompanying data consists of six of the eight measurements on the Colts' footballs. Complete parts (a) and (b) below. 12.75, 12.50, 12.15, 12.35, 12.55, 12.30 The test statistic is = (Round to two decimal places as needed.) The p-value is = (Round to three decimal places as needed.) b. Use the data to construct a 95% confidence interval for the mean psi for the Colts' footballs. How does this confidence interval support your conclusion in part (a)? The 95% confidence interval is ___ psi to ___ psi. (Round to two decimal places as needed. Use ascending order.)
Two quality control technicians measured the surface finish of a metal part, obtaining the data in the table below. Assume that the measurements are normally distributed.
The spike stature of the plants grown from the seeds of the porcine separates (Dactylis glomerata L) collected from the University campus and İbradı Eynif pasture are given below. In this plant, compare whether there is a difference between regions in terms of spike height. Virgo Height (cm) Data obtained from plants collected from university campus 5 6 8 7 8 6 5 5 4 6 6 Data obtained from plants collected from Eynif pasture 12 9 11 9 9 11 9 10 11 10 Note: Your results interpretation according to two different possibilities (Do it separately, assuming that it is 0.07 and 0.04).
The average weight of a Coastal male Grizzly Bear is approximately normal with E(x); =795 pounds and SD * (x) = 80 pounds. 8. How likely is it to randomly select 64 Coastal male Grizzly Bears with a sample average weight of 810 pounds or more? Which density curve is the best model for this problem?
The article “Effect of Internal Gas Pressure on the Com- pression Strength of Beverage Cans and Plastic Bottles” (J. of Testing and Evaluation, 1993: 129–131) includes the accompanying data on compression strength (lb) for a sample of 12-oz aluminum cans filled with strawberry drink and another sample filled with cola. Does the data suggest that the extra carbonation of cola results in a higher average compression strength? Base your answer on a P-value. What assumptions are necessary for your analysis? ( use ? = 0.01 )
The department of zoology at the Virginia Polytechnic Institute and State University carried out a study to determine if there is a significant difference in the density of organisms in two different stations located in Cedar Run, a secondary river that is located in the river basin. Roanoke. Drainage from a sewage treatment plant and overflow from the Federal Mogul Corporation sedimentation pond enter the flow near the source of the river. The following data give the density measurements, in numbers of organisms per square meter, at the two different collecting stations. Number of organisms per square meter Station 1 Station 2 5030 2800 13700 4670 10730 6890 11400 7720 860 7030 2200 7330 4250 2810 15040 1330 4980 3320 11910 1230 8130 2130 26850 2190 17660 22800 1130 1690 With a significance level of 0.05, can we conclude that the densities are the same in the two…
An experiment to determine the effect of four different types of engine oil (A, B, C, and D) on the rolling friction coefficient of a car speed has been conducted. Three brands of car (Honda, Toyota, and Mazda) were chosen, and each engine oil was tested twice on each car, producing the following ANOVA output in Figure 2. i) How many treatments involved? Write down all the treatments ii) Identify the number of replication for each treatment. iii) Based on the ANOVA table above, find the values of W, X, Y and Z. iv) Test the interaction effect on rolling friction coefficient of car speed between the four different types of engine oil and the three different brands of car. v) Do we need to test for marginal effect? Give a reason.
In experiments to determine the effectiveness of drugs such as anti-fungal ointments that are applied to the skin, the concentration of the drug in a patient’s skin must be measured. The article “Determining Bioequivalence of Topical Dermatological Drug Products by Tape- Stripping” (W. Navidi, A. Hutchinson, et al., Journal of Pharmacokinetics and Pharmacodynamics, 2008:213–220) describes an improved method of measuring that is designed to ensure that all the drug in the skin is recovered. Assume that in an experiment using the old method, the mean amount of drug recovered from a sample of 49 patients was 105 ng with a standard deviation of 20 ng, and that in an experiment using the new method the mean amount of drug recovered in a sample of 35 patients was 117 ng with a standard deviation of 15 ng. Find a 98% confidence interval for the difference in the mean amounts recovered between the two methods.
A manufacturer of paper used for making grocery bags is interested in improving the tensile strength of the product. Product engineering thinks that tensile strength is a function of the hard-wood concentration in the pulp and that the range of hardwood concentrations of practical interest is between 5 and 20%. A team of engineers responsible for the study decides to investigate four levels of hardwood concentration: 5%, 10%, 15%, and 20%. They decide to make up six test specimens at each concentration level, using a pilot plant. Using the data given below: a. Complete the ANOVA table. b. At 0.05 significance level, test whether there is a difference in mean tensile strength based on Hardwood Concentration.
Refer to the data display from a sample of airport data speeds in Mbps. What is the number of degrees of freedom that should be used for finding the critical value ta/2 ?
Calculate the average values of the Cp and Cpk capabil-ity indices for the BOD data , assuming that LSL=5 mg/L and USL=35 mg/L. Do these val-ues of the indices indicate that the process performance is satisfactory?
The performance of two analysts in determining total mercury (mg / kg) in fish was evaluated using the absorption spectrometry method. The results on the concentrations of mercury found in fish, for each analyst, are presented in the table below: Analyst 1 Analyst 2 7 12 9 8 6 9 11 13 13 14 8 9 7 8 13 10 12 7 9 15 (a)Is the performance in determining total mercury for Analyst 1 more accurate than Analyst 2? Compare the accuracy in the results of the two analysts at a 95% confidence level. Explain. (b)Are the results obtained by the two analysts, in the concentrations of mercury found in the fish, statistically equivalent, with 95% confidence? Explain